SimplyTrack BTT100 User manual
Smart GNSS/GSM Terminal
with internal antennas
BTT100
Overview
Product Name
Dimensions
Weight
Positioning Methods
79(L)*32.6(W)*11. (T)mm
33g
GPS/BDS/GLONASS, QZSS, LBS
BTT100
CE, FCC
Product Certication
Specication
External Power Supply
Built-in Backup Battery
9-90 VDC 55mAh Li-ion Battery
2
3
1
Technology
Ready to start
Power supply
Technology GSM
Quad Band 850MHz/900MHz/1800MHz/1900MHz
GSM Antenna Built-in GSM Antenna
GPRS Specication Class12
Data Path SMS, Platforms
Pin Details
Wiring Scheme
Quick Commands
Function SMS Command
Backend server parame er se ings
Se ing he APN
Cen re number se ing
SERVER,1,Domain,por ,0#
SERVER,0,IP,por ,0#
APN,<In erne Name>#
APN,<In erne Name>[,Username]
[,User Password]#
Use cus om APN parame ers o urn
off APN adap ion.
APN#
Query he APN parame ers curren ly
in use.
CENTER, A, CENTRE NUMBER#
Enquiry S a us
Query parame er se ings
GPS da a iming in erval
STATUS#
PARAM#
TIMER,T1,T2#
T1=5～60 s；ACC ON S a us Upload
In erval
T2=5～60 s；ACC OFF S a us Upload
In erval
Fast Flashing: GSM is initializing
Slow Flashing: GSM signal is normal
Always on: GPRS working
No Flashing: No GSM Signal/SIM Card
Orange GSM）
Blue GPS）
Fast Flashing: Searching for GPS signal
Always on: Position captured
No Flashing: GPS sleep
/ GPS not working
LED indicator Introduction
Safety Information
This message contains information on how to operate BTT100 safely. By
following these requirements and recommendations, you will avoid dangerous
situations. You mustread these instructions carefully and follow them strictly
before operating the device!
• The device uses SELV limited power source. The nominal voltage is +12 V DC.
Theallowed voltage range is +9 ... +90 V DC.
• To avoid mechanical damage, it is advised to transport the device in an impact-
proof package. Before usage, the device should be placed so that its LED
indicators are visible. They show the status of device operation
• When connecting the 4 connector wires to the vehicle, the appropriate jumpers
of the vehicle power supply should be disconnected
• Before unmounting the device from the vehicle, the 4 connector must be
disconnected. The device is designed to be mounted in a zone of limited access,
which is inaccessible to the operator. All related devices must meet the
requirements of EN 60950-1 standard. The device BTT100 is not designed as a
navigational device for boats.
Do not disassemble the device.If the device is
demaged, the power supply cables are not isolated or
the isolation is damaged, DO NOT touch the device
before unplugging the power supply
