MICODUS MV55G User manual

MV55G User Manual V1.0
Learn how to set up your new MiCODUS Tracker
Copyright ©2022 MiCODUS | All Rights Reserved
R

2.Specifications
Model
Weight
Dimensions
Battery Working Time
MV55G
80g
59mm(L) * 45mm(W) * 22mm(H)
Tracking Mode：1-2 hours
Device Information
Working Voltage
Battery Capacity
Working Temperature
Working Humidity
Working Frequency
SIM Card
Cellular Antenna
MV55G(EU):
4G LTE-FDD: B1/B3/B7/B8/B20/B28;
4G LTE-TDD: B38/B40/B41;
3G WCDMA: B1/B8;
2G GSM/EDGE: B3/B8;
MV55G(AU):
4G LTE-FDD: B1/B2/B3/B4/B5/B7/B8
/B28/B66;
4G LTE-TDD: B40;
3G WCDMA: B1/B2/B4/B5/B8;
2G GSM/EDGE: B2/B3/B5/B8;
Micro SIM Card
Built-in
DC 9V - 50V
3.7V 140mAh Lion Polymer battery
-20℃- 75℃
10%-85%RH non-condensing
Working Parameters
Device Information
Cellular Specifications
1. Main Features
4G+3G
+2G
Historical Route
Playback
Real-time
Tracking 140mAh 4G WiFi Hotspot (Optional)
Overspeed
Alarm
Vibration
Alarm
Movement
Alarm
Plug Out
Alarm Geo-fence Engine Start/
Flameout Alarm
ON / OFF

3. Activate Device
LED Event State
Charging
Charger inserted and battery has been fully charged
Charger has not been inserted
Searching for network
POWER LED (RED)
CELL LED
(YELLOW) Network has been registered
Solid
Dark
Dark
Flash every 1 second
Solid
GPS has fixed
GPS is in fixing Flash every 1 second
Device is working but stopped more than 5min
Device has not been turn on
Device ran out of battery
GPS LED (BLUE)
ALL LED
Solid
ALL LED TURN OFF
Install the SIM card via the correct direction as below:
APN,ApnName,User,
Password# SET APN OK APN,orange, orange,orange#
APN,internet#SET APN OKAPN,ApnName#
SMS Command
Format Reply Example Note
If the SIM card has APN user and APN
password, then use this command.
If the SIM card operator doesn't have APN
user and APN password, then please use this
command.
Tracking sensitivity
GPS Channels
-162 dBm
64
Position Accuracy 5-10m
GNSS Specifications
Positioning Type
GPS Antenna
Cold Start
Hot Start
GPS+BEIDOU+LBS
Built-in
6HFRQGV
6HFRQG
Normal SIM
Please get the exact correct APN name from local SIM card provider.Take the tracker
to a good signal place for operation and configure the APN for it as below:

4. Package Content
GPS Main Unit
User Manual
Quick User Guide
Genuine Packing Box (Optional)
OBD Extension Cable (Optional)
x 1
x 1
x 1
x 1
x 1
5. Functions Explanation
a. Vibration Alert：
This vibration alert function just work under
stationary status.How to use this function:
* First Step:
Configure SOS numbers for
the tracker by this sms command：
SOS,A,1st number,2ndnumber,3rd number#
3 SOS numbers supports at the most.
*Second Step:
Enable the device to enter into arm
mode by this sms command: ARM#
*Third Step:
Conifgure the alarm ways by this sms command：SENALM,[A][,M]#
*Fourth Step:
Keep the device under stationary status more than 5min to let it enter into sleep arm
mode;
*Five Step:
Vibrate the device then the tracker will send the vibration alarm messages.
A=ON/OFF, default: OFF;
M=0/1/2, way of alarming,( 0 :Platform only, 1: SMS+Platform,
2: Platform+SMS+phonecall, Default:1)
Please follow with the quick user guide carefully!
For example:
SOS,A,12345678910#
ARM#
SET SOS NUMBER OK
SENALM,ON,1#
SET VIBRATE ALARM OK
SET ARM MODE OK
MV55G
Note: The APN information is very important, it must 100% correct to match with the sim
FDUGRIWKHWUDFNHULI\RXFRQ¿JXUHGZURQJ$31WKHWUDFNHUDOVRZLOOUHSO\6(7$31RN
but it will can't get online!

b. Engine Status Change Detection：
Once the OBD tracker detected engine start or flamout it will send alarm message out, and
the alarm ways is configurable by SMS, call and tracking platform.
c. Plug out alarm：
If someone plug out the device it will send alarm message out, and the alarm ways is config-
urable by SMS, call and tracking platform.
*First Step:
Configure SOS numbers for t
he tracker by this sms command：
SOS,A,1st number,2nd number,3rd number#
3 SOS numbers supports at the most.
*Second Step:
enable this function by this command：PWRALM,A,B#
* First Step:
Configure SOS numbers for
the tracker by this sms command：
SOS,A,1st number, 2nd number,3rd number#
3 SOS numbers supports at the most.
A =ON/OFF, Default:ON;
B=0/1/2 (0: Platform only, 1: SMS+Platform,
2 :Platform+SMS+Call, Default:2)
*Second Step:
Configure the alarm ways via
this SMS command：ACCALM,ON,A,M,N#
Alarm ways: A=ON/OFF, Default: ON;
M=0/1/2 (way of alarm)( 0 : GPRS only, 1: SMS+GPRS,
2: GPRS+SMS+CALL, Default:1);
N=0/1/2; (0: ACC ON&OFF Alarm; 1: ACC ON Alarm; 2: ACC OFF Alarm; Default:0 )
Ways of alarming:
For example:
SOS,A,12345678910#
SET SOS NUMBER OK
ACCALM,ON,1#
SET ACC ALARM OK
MV55G
For example:
SOS,A,12345678910#
SET SOS NUMBER OK
PWRALM,ON,1#
SET POWER ALARM OK
MV55G

6. Installation Recomendation
Where is the OBD interface?
Most of the car's OBD interface is located in A and B,
A small part of the car will be in C,D and E.
Where is the OBD interface?
Most of the car‘s OBD interface is located in A and B,
A small part of the car will be in C,D and E.
Explanation
Area A VW、Ford、Toyota 、Hyundai 、Citroen、BMW、
etc./Most cars.
Explanation
Area B Honda,Lexus,etc.
Explanation
Area C Dongfeng Citronen,etc.
Explanation
Area D/E A few cars...

Unable to connect to
tracking platform
Check the APN and settings.
Check whrther the data service of SIM card is enabled.
Check the balance of SIM card.
Tracker shows offline
Check whether external power is still connected.
Check if the vehicle entered netword blind area.
Check the balance of SIM card.
7. Troubleshooting
Type Use
8. Full SMS Commands List
Location drift
In area with poor GNSS signal (tall building around or
basement), drifting may happen.
Check whether vibration happens around to trigger the
accelerator.
Unable to locate
Make sure the top side facing upward without metallic things
shielded.
Make sure it’s not in area with no satellite coverage.
No command reply
Make sure command format is correct.
Vehicle may be in network blind area.
Make sure SIM card is well inserted and has SMS servi.
APN Setting
Server Setting
If set with IP: SERVER,0,IP,Port#
APN,Network name[,name,password]#
If set with Domain Name: SERVER,1,
Domain,Port# SERVER,1,d.micodus.net,7700#
SERVER,0,47.254.77.28,7700#
APN,CMNET# (if no name & Password)
APN,internet,internet,internet# (if with name
& Password)
Check IMEI IMEI#
Restore factory settings
Restart device
Internet Traffic Switch
FACTORY#
RESET#
INTERNET,ON#
INTERNET,OFF#
Functions Explanation Command Format

Functions Command Format Explanation
Version Inquiry
Parameter Inquiry
VERSION#
PARAM#
Status Inquiry STATUS#
BATTERY: XX% (Built-in Battery Power Percent)
INTERNET: CLOSED (No Network) FAILED (Conn-
ecting Network or Failure) SUCCESS (Connected
to Network）
NET: NONE (No GSM Signal),HIGH / MED /
LOW (Signal Strength)
GPS: CLOSED (GPS Module Closed) , FIXED,
N (Positioned and satellite number), UNFIX,
0 (Not Positioned yet)
SPEED:30KM/H
ACC: ON / OFF (ACC on or off)
POWER: CONNECTED / DISCONNECTED (Power
Connected or Disconnected), 12.5V (Vehicle
battery voltage)
SENSOR: ON/OFF (Sensor on or off), LEVEL:
3 (Sensitivity level 1-9)
FORTIFIED STATE: ARM (Arm or Disarm)
Latitude&Longitude
Inquiry
Map URL Inquiry URL#
WHERE#
Time Zone Setting
Set the angle upload
GMT,Time zone orientation,
Whole Time Zone[,Half Time Zone]#
ANGLEREP,[X][,A][,B]#
ANGLEREP,OFF#
GMT,E,8# (if no half time zone)
GMT,W,9,30# (if has half time zone)
NOTE: Parameter : E / W；0 ~ 12; 0/15/30/45
Query current mileage
CENTER,A,13800138000#
NOTE: Center number is only used for cutting off
power & oil, it can only be set by SOS Administrator
when using this command by SMS.
X=ON/OFF, default：ON; A=5～180 degrees,
diversion angle degree, default：30 degrees；
B=2～5 seconds, detecting time, default：3 seconds,
NOTE: Reply message’s language is determined by
device’s language setting, if get position content
failed, device will reply Google Map location link.
Address Inquiry POSITION#
Mileage Statistics
Add Center Number
MILEAGE,[A],[B]#
MIELEAGE#
CENTER,A,center number#
A=ON/OFF, On/Off mileage calculation, default: Off
B=0～999999，Mileage initial value , unit：km ;
default: 0, mileage return to zero

Add SOS Administ-
rator Number
SOS,A,1st number,
2nd number,3rd number#
Functions Command Format Explanation
Delete SOS Admin-
istrator Number
Set 3 numbers at a time:
SOS,A,13800138000,1380013800 1,13800138002#
Set the first numberseparately:
SOS,A,13800138000#
Set the second number separately:
SOS,A,,13800138001#
Means to set 3rd number separately:
SOS,A,,,13800138002#
Directly delete the number:
SOS,D,13800138000#
Delete 1st number:
SOS,D,1#
Delete 2nd number:
SOS,D,2#
Delete the 2nd and 3rd number:
SOS,D,2,3#
SOS,D,1st number,
2nd number,3rd number#
or SOS,D,1,2,3#
Delete Center Number
Data Upload Time
Interval
Heartbeat Packet Upload
Sensor Sensitivity
Arm manually
Disarm manually
HBT,time#
LEVEL,A#
ARM#
DISARM#
CENTER,D#
TIMER,T1,T2#
T1(upload interval when acc on):0 or 5-18000(seconds),
0 means no upload, default is 10;
T2(upload interval when acc off):0 or 5-18000(seconds),
0 means no upload, default is 180;
HBT,3#
NOTE: Range :1-60min, default 3min.
LEVEL,2#
NOTE: A：Sensitivity Level 1-9 (1-9 is from week to
strong vibration)
Set the device into arm mode
Set the device out of arm mode
Vibration Alarm Setting
Shift Alarm Setting
SENALM,[A][,M]#
SENALM,OFF#
SHIFT,[A][,B][,M]#
SHIFT,OFF#
A=ON/OFF, default: OFF;
M=0/1/2, way of alarming, 0 :GPRS only, 1: SMS+GPRS,
2 : GPRS+SMS+phone call, default:2
Example: SHIFT,ON,100,1# ( Means Setting 100 meters
shift alarm range, when the ignition turned off, vehicle’s 100
meters’ shift will trigger the alarm. )
A=ON/OFF; default:ON
B=Shift Distance (Range: 100-9999m)
M=0/1/2; way of alarm, 0 : GPRS only, 1: SMS+GPRS,
2: GPRS+SMS+CALL, default:1

E-mail: [email protected]
Skype: MiCODUS
9. Any Questions?
Download on the
APP Store
Download for
Android
Search "MiCODUS" in iOS APP store or Google Play
Store, or just scan the QR code as below to download
MiCODUS APP:
10. Download the APP
Auto Arm By ACC
ACC Status Change
Alarm
Power Disconnect
Alarm
ACCARM,ON,M#
ACCARM,OFF#
ACCALM,ON,A,M,N#
A=ON/OFF, Default: ON;
M=0/1/2 (way of alarm); 0 : GPRS only, 1: SMS+GPRS,
2: GPRS+SMS+CALL, Default:1;
N=0/1/2; 0: ACC ON&OFF Alarm; 1: ACC ON Alarm;
2: ACC OFF Alarm; Default:0
A=ON/OFF, defaultON;
B=0/1/2, ways of alarming, 0: GPRS only, 1: SMS+GPRS,
2 : GPRS+SMS+phone call, default：2；
ACCALM,OFF#
PWRALM,A,B#
PWRALM,OFF#
M=5-1800s, default: 60s
Close auto arm by acc function
Close engine start/flameout alarm
Close power disconnect alarm
Functions Command Format Explanation