Sineoji PL200EP User manual

1
Quick Installation Guide
200Mbps Mini Homeplug AV
PL200EP
Packaging Contents
1. PL200EP
2. Ethernet cable
3. User manual
Note:
Homeplugs are pre-configured from the factory so that they are paired automatically. You can connect
to a maximum of 8 homeplugs within the home network. Have the homeplugs plug directly to the
power outlets for best results. Sineoji Homeplugs are compatible with all AV models.
Installing a NEW HomeplugAV Network
1. Plug in your Homeplug to the power socket and connect the LAN cable provided to the
ethernet port of the homeplug and the other end to the ethernet port of your ADSL
Modem/Router.

2
2. Plug the other homeplug to the power socket of your desired location, for instance, BEDROOM
A. Connect the LAN cable to the ethernet port of the homeplug and the other end to your
Desktop PC/Notebook/Media Player/Game Console.
3. Turn on the power socket where the two homeplugs are residing. You have successfully setup
your homeplug network.
Adding a 3rd Homeplug (Bridge C) to existing Network
1. Press and hold the security button on Homeplug A for 1 to 3 seconds. The Power LED light on
Homeplug A begins to flash.
2. Within 2 minutes, press and hold the security button on Homeplug C for 1 to 3 seconds and
then release.
3. Homeplug A, B and C are now paired and connected.
LED Status
POWER
ON : The Homeplug is receiving electrical power
OFF : Power is off
FLASHING : Device going on standby mode
DATA
RED : Weak signal and slower network speed
ORANGE : Normal signal with standard network speed
GREEN : Excellent signal with optimal network speed
OFF : Homeplug is not connected within the network

3
ETHERNET
SOLID GREEN : Ethernet port is connected
BLINKING : Data is transmitting and receiving
OFF : No device is connected to the ethernet Port
RESET BUTTON
Pressing the reset button will erase all data and restore ALL SETTINGS to the factory default
values.