Sirius XM RAdio Outdoor Home Antenna Kit User manual

Outdoor Home Antenna Kit
for Satellite Radio
Installation Guide

If you experience problems with the operation
or performance of your SiriusXM product,
DO NOT RETURN THIS PRODUCT TO YOUR RETAILER.
Call SiriusXM Listener Care at 1-866-746-7961
and speak to one of our service representatives.

3
Table of Contents
Introduction ....................................................5
Safety and Care Information .................................................. 7
What’s in the Box? ........................................................... 8
Installation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9
Aiming At Different Sirius Satellites . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 27
Troubleshooting ................................................ 31
Product Specifications ..........................................33
Patent Information..........................................................35
Environmental Information...................................................35

4

5
Introduction

6
Introduction
Thank you for purchasing the Outdoor Home Antenna Kit for Satellite
Radio
The Outdoor Home Antenna Kit for Satellite Radio will allow you to connect a
Sirius or XM Radio to the Outdoor Home Antenna, using standard RG-6 antenna
cable wire, the same cable used in cable TV installations. This allows you great
flexibility as to where you locate the Outdoor Home Antenna and where you
locate your Radio. RG-6 cables can be purchased at your local hardware store,
home center, or electronics retailer. A short adapter cable is included for
adapting the RG-6 cable to your Radio.
The Outdoor Home Antenna is a high-performance antenna, specifically
designed to receive signals from the SiriusXM satellites and terrestrial (ground)
transmitters when mounted outdoors on a home or other building. The antenna
has been approved by Sirius XM Radio Inc. to receive the SiriusXM signal under a
variety of conditions within the North American coverage area.
The antenna should be mounted according to the instructions in this manual to
ensure the best quality reception of the SiriusXM signal. All necessary mounting
hardware for a variety of mounting options is included with the kit.
And for the latest information about this and other SiriusXM products and
accessories, visit siriusxm.com or your favorite retailer.
Please read the entire Installation Guide before installing your Outdoor Home
Antenna Kit for Satellite Radio.

7
Safety and Care Information
IMPORTANT! Always read and understand all the instructions to avoid injury to
yourself and/or damage to your device. Sirius XM Radio Inc. disclaims all
responsibility for damage from data loss due to breakdown, repair, or other
causes.
• Review this installation manual before beginning the installation process.
Installation of the antenna and splitter requires experience in mechanical
and electrical procedures, and may involve using a ladder to reach the
soffit or roof of the home or building. A phillips-type screwdriver and a
3/8 in. wrench is needed for installation, and, depending upon the type of
installation, a power drill with a 3/32 in. drill bit may also be required. If
you are not comfortable or experienced with the installation procedures,
SiriusXM recommends that you have a professional install the kit and
wiring for you.
• Be sure not to cut, damage, or puncture the external jacket of the antenna
cables during the installation procedure. Damage to the antenna cable
can cause the SiriusXM signal to be degraded or unavailable, and can also
cause water to intrude into the antenna cable causing the cable to fail.
• Do not expose to chemicals such as benzene and thinners. Do not use
liquid or aerosol cleaners. Clean with a soft damp cloth only.
• Do not expose to fire, flame, or other heat sources.
• Do not try to disassemble and/or repair device yourself.
• Do not drop your device or subject it to severe impact.
• Do not place heavy objects on device.
• Do not subject device to excessive pressure.

8
Introduction
What’s in the Box?
A
B
D
E
F
G
H
I
C
A. Outdoor Home Antenna
B. Antenna Base
C. Rubber Cable Boot
D. RG-174 Adapter Cable
E. U-Bolts (2)
F. Mounting Brackets (2)
G. Hex Lock Nuts (4)
H. #10 Screws (4)
I. Cable Tie

9
Installation

10
Installation
Materials Required and Installation Considerations
In order to install the Outdoor Home Antenna you will need to purchase a length
of RG-6 antenna cable to complete your installation. The following illustration
shows a typical home installation.
OUTDOOR HOME ANTENNA SATELLITE RADIO
Adapter
Cable
234567890
direct
jump
FM
menu
1
234567890
direct
jump
FM
menu
1

11
A cable will be needed for the following:
• A length of RG-6 cable to go from the Outdoor Home Antenna to the
location of the Satellite Radio. (150 ft. maximum length.)
RG-6 cable is typically sold in lengths of 25, 50, or 100 ft., all with “F” type
connectors on each end. These cables may be purchased at your local hardware
store, home center, or electronics retailer.
The length of the RG-6 cable from the Outdoor Home Antenna to the Satellite
Radio should not exceed 150 ft., as shown in the preceding illustration. The
overall length for your particular installation may be less than 150 ft.
Determine the overall length of the RG-6 cable run by measuring the distance
from the Outdoor Home Antenna mounting location to where the Satellite Radio
will be located.
RG-6 Cable
Outdoor Home
Antenna
Radio
RG-174
Adapter Cable
150’ MAX.
1
234567890
direct
jump
FM
menu
1

12
Antenna Installation
A successful antenna installation consists of four steps: First, assembling the
antenna; Second, determining a location for the antenna; Third, choosing a
mounting option; and Fourth, adjusting and aiming the antenna. Please read the
following four sections before beginning the antenna installation so that you
understand the entire installation process.
First: Assembling the Antenna
The antenna arm should be temporarily adjusted to be at a 45 degree angle
relative to the antenna pod. To adjust the position of the arm, refer to the
following figure and loosen screw Auntil the arm can be moved. Adjust the arm
so that it’s at a 45 degree angle and then tighten screw A.
Installation
1. Loosen Screw
2. Move arm to 45 degrees
3. Tighten Screw
A
ARM
POD

13
Next, the antenna arm with the pod needs to be attached to the antenna base.
Refer to the illustration on page 14 and attach the antenna arm to the antenna
base:
1 Use a phillips screwdriver to remove the screw Bfrom the antenna arm.
2 The mounting bracket Con the antenna base has two sides. Before you
slide the antenna arm over the mounting bracket C, be sure the antenna
arm and antenna base are in the correct orientation as shown.
3 When correctly oriented, slide the antenna arm over the mounting bracket
Con the antenna base and align the screw holes in the mounting bracket
with the screw hole in the antenna arm.
4 When the screw hole is aligned, re-insert screw Band snug it until it is
tight.

14
Installation
Re-insert screw
and tighten
Slide the antenna
arm over the
antenna base
mounting bracket
Align the
screw hole
Correct
Correct
Verify the correct orientation
of the antenna arm and
antenna base
ARM
BASE
C
IncorrectIncorrect
Remove Screw
B
B
1.
3.
2.
4.

15
Second: Determining a Location for the Antenna
For correct operation and best reception of the SiriusXM signal, it is important
that the Outdoor Home Antenna is located in a place where it will have a clear
view of the satellite in the sky. Obstructions such as bushes, trees, other homes
or buildings, overhangs, soffits, chimneys, gables, dormers, etc., will impair or
prevent the antenna from receiving a signal.
The best reception is obtained if the pod portion of the antenna (where the logo
is printed) has a clear 360 degree view of the sky within the cone-shaped area
shown in the following illustration.
If you cannot obtain a clear 360 degree view of the sky in your location, then
you’ll need at least a clear view of the south sky. If you look closely at the next
illustration, you can see that the antenna does not have a clear view of the sky in
all directions due to trees. However, it does have a clear view of the sky toward
the south, in the direction of the satellite. Your antenna will also need to have a
clear view sky of the in the south direction. Not sure which way is south? Think
about where the sun rises (in the east) and sets (in the west). Then stand so that
east is to your left and you’ll be facing south.
No obstructions to the
sky within this area

16
Once you have determined a possible mounting location for your area, it is
recommended that you put the antenna in place temporarily and connect the
antenna to your Radio as shown in the following illustration. Using the Antenna
Aiming or Signal Indicator feature of your Radio, verify that your antenna
is receiving a good signal. (Consult the User Guide of the Radio for specific
instructions on how to access the feature.)
If it is not possible to obtain a view of the south sky, and you are using the
Installation
No obstructions to
the south sky
SOUTH

17
Outdoor Home Antenna to connect to a Sirius Radio, refer to the section “Aiming
At Different Sirius Satellites” on page 28.
Third: Antenna Mounting Options
There are three possible mounting options for the Outdoor Home Antenna, and
the antenna mounting location you have chosen may determine which mounting
methods you can use:
• Wall Mount: Mounting the antenna directly on the side of a home or
building.
• Roof Mount: Mounting the antenna on the soffit of a home or building.
• Mast Mount: Mounting the antenna on a mast or pole, such as an existing
satellite TV dish mast, an existing TV antenna mast, or other mast or pole,
not exceeding 2 inches in diameter.
Wall Mount
The antenna mounting bracket should be oriented in a vertical position (as
shown) and mounted directly to the wall of the building or home using the
provided #10 screws.
Remember to avoid blocking the antenna’s view of the sky as described in the
RG-174
RG-6 Adapter Cable
Signal Indicator
S
ATELLIT
E
TERRESTRIA
L
234567890
direct
jump
FM
menu
1

18
Installation
previous section by locating the antenna too high under the eaves or soffit of the
home or building.
Once you have determined a suitable mounting location, use the mounting
bracket as a template and mark the wall with the location of the four screw holes
in the bracket. Then, using a 3/32 in. drill bit, drill pilot holes in the wall for the
screws and then screw the bracket to the wall.
MOUNTING
HOLES
INCORRECT
VIEW OF THE SKY
IS OBSTRUCTED
BY THE SOFFIT
AND GUTTER
CORRECT
UNOBSTRUCTED
VIEW OF THE SKY
CORRECT
UNOBSTRUCTED
VIEW OF THE SKY

19
Roof Mount
When mounting the antenna on the soffit of a home or building, mount the
antenna as close as possible to the peak of the roof. It can be mounted on the
chimney or on the soffit of the home or building. Do not mount it directly on the
roof surface to avoid leaks. Remember to avoid blocking the antenna’s view of
the sky by locating it where a chimney, dormer, gable, etc., may obstruct the view
of the sky.
The antenna mounting bracket should be oriented in a vertical position as shown,
and mounted directly to the building or home using the provided #10 screws.
Once you have determined a suitable mounting
location, use the mounting bracket as a template
and mark the mounting surface with the location of
the four screw holes in the mounting bracket. Then,
using a 3/32 in. drill bit, drill pilot holes for the
screws. It may be necessary to fill the holes with
a small amount of roof cement or caulk to insure
MOUNTING
HOLES

20
Installation
a watertight installation. Screw the bracket to the mounting surface using the
provided #10 screws.
Mast Mount
The Outdoor Home Antenna can be mounted on most any mast or pole which
does not exceed 2 inches in diameter using the provided U-bolts and mounting
brackets. If you have a satellite TV dish, the Outdoor Home Antenna may be
mounted on the same mast as the satellite dish, but remember that the dish
cannot obstruct the antenna’s view of the south sky.
To mount the antenna to the mast, you will need to use the two provided U-bolts,
the two mounting brackets, and the four hex nuts. Keep in mind that the antenna
cable is routed under the lower U-bolt, in the slot provided in the antenna base as
shown.