Sirus Akku 15 User manual

Manual
Compact System
Akku 15

2 / 8
Table of contents
1. Safety instructions............................................................................................................................ 3
1.1. FOR SAFE AND EFFICIENT OPERATION............................................................................ 3
2. Introduction....................................................................................................................................... 4
2.1.1. Set ................................................................................................................................... 4
2.1.2. Technical Data................................................................................................................. 4
3. Setup und Wiring.............................................................................................................................. 5
3.1. Before using............................................................................................................................. 5
3.2. Control..................................................................................................................................... 5
3.3. Tips.......................................................................................................................................... 6
1. Connections ..................................................................................................................................... 7
1.1. The balanced signal ................................................................................................................ 7
1.2. The unbalanced signal ............................................................................................................ 7

3 / 8
1. Safety instructions
•Read the safety instructions and also this manual carefully.
•Keep the manual.
•Observe all red flags.
•Observe the manual.
•To prevent fire or electric shocks, protect the device against rain and
humidity
•Pull the plug before opening the housing.
•To prevent an electric shock you should not remove the cover.
•Do not operate the device in the near of water.
•Use only a dry cloth for cleaning.
1.1.FOR SAFE AND EFFICIENT OPERATION
Be careful with heat and extreme temperature
Avoid exposing it to direct rays of the sun or near a heating appliance.
Not put it in a temperature bellow 32°F /0°C, or exceeding 104°F /35°C.
To avoid placing on un-stable location
Select a level and stable location to avoid vibration.
Do not use chemicals or volatile liquids for cleaning
Use a clean dry cloth to wipe off the dust, or a wet soft cloth for stubborn dirt. Pull the plug before
cleaning.
If out of work, contact sales agency immediately
Any troubles arose, remove the power plug soon, and contact with an engineer for repairing, do not
open the cabinet by yourself, it might result a danger of electric shock.
Take care with the power cable
Never pull the power cable to remove the plug from the receptacle, be sure to hold the plug. When not
using the device for an extended period of time, be sure to disconnect the plug from the receptacle.
Ventilation
It is not allowed cover fans and air in and outlets.

4 / 8
Safety
Do not remove the grounding. It is for your safety. If you remove the grounding it can cause electric
shocks.
Hearing
To avoid hearing damages, you should not operate a sound system with high levels. This applies to
monitor systems, which are in the near of the ear, headphones or IEMs also.
Accessory
Please use only the accessory which is set by the manufacturer.
Important
Damages caused by the disregard of this user manual are not subject to warranty. The dealer will not
accept liability for any resulting defects or problems. Make sure the electrical connection is carried out
by qualified personnel. All electrical and mechanical connections have to be carried out according to
the European safety standards.
2.Introduction
Thank you very much for buying the Compact System Akku 15. Please read and keep this manual
carefully. Please load the battery of the device once a month completely to get the battery life.
2.1.1. Set
The set of the compact system is made up as follows:
- 1x Speaker
- 1x Remote
- 2x Wireless microphone
2.1.2. Technical Data
Frequency response 45Hz – 20kHz
RMS Power 180W
MAX Power 360W
Voltage 115-230V/AC

5 / 8
3.Setup und Wiring
3.1.Before using
1. When first powering-up the product, keep the controls all the way off, in order to prevent from
being potentially damaged and from producing annoyed sounds caused by defective cables or
hookup. When turning up controls, do it gradually, until normal operation is verified. These
precautions are necessary for all speaker system with high power amplifiers, since they have
enough power to blow most speakers in abnormal situations.
2. Check the AC Voltage before connecting the Ac plug.
3.2.Control
1. USB Port
2. SD MMC Port
3. LCD Display
4. Control of the MP3-Player
5. MIC 1 IN
Use a XLR balanced or unbalanced XLR
connector.
6. Gain control MIC 1
This control adjusts the volume of MIC 1.
7. Effect control MIC 1
This control adjusts the amount of the signal that
is sent to the effects processor.
8. MIC 2/Guitar IN
Use a balanced or unbalanced 1/4“jack
connector.
9. Gain control MIC 2/Guitar
This control adjusts the volume of MIC2.
10. Talk over
If you press this button while using a microphone,
it will lower the sound of playing music. So your
voice from microphone is come more clearly.
11. Equalizer
The controls adjust overall tone of the mixer. Each slide control adjusts the amount of specific
frequencies + or – 12dB
12.Line out
Here you can link additional speakers. The additional speakers must be self amplified.

6 / 8
13. AUX in
Use a RCA or 3.5mm balanced or unbalanced jack connector to connect a CD-Player, turntable or
mixer.
14. AUX Level
This controls the signal for AUX when using AUX.
15. PEAK
The LED lights up when using the signal distortion occurs and in compression condition. Reduce the
volume with LEVEL control until the PEAK LED does not light up anymore, or occasionally lights up at
signal peaks.
16. Master
This controls the output signal.
17. RF A LED
The LED lights up when using wireless microphone A.
18. Volume control for wireless microphone A
This control adjusts the volume of wireless microphone A.
19. VHF Power
The LED lights up when using the wireless microphone.
20. Volume control for wireless microphone B
This control adjusts the volume of wireless microphone B.
21. RF B LED
The LED lights up when using wireless microphone A.
22. Power On/Off
23. Voltage Selector
Here you can change the AC power between 115V and 230V. If you power supply system has a
voltage of 230V the voltage selector has to be set on 230V. If you power supply system has a voltage
of 115V the voltage selector has to be set on 115V.
24. Power supply input connector
25. Charge LED
The LED lights up when charging.
26. Power LED
27. Remote control
28. Mode
With this button you can choose between USB/SD.
3.3.Tips
Do not expose electronic circuitry to moisture! When you set the system up outdoors, be sure to
protect it against rain. Keep soft drinks, beer and all other liquids well away from the cabinets to
protect their electronic components from short circuits.

7 / 8
1.Connections
1.1.The balanced signal
The system has a female XLR input that accepts a balanced line-level signal. When connecting a
balanced signal, be sure it´s wired as follows:
1.2.The unbalanced signal

8 / 8
Importer:
B & K Braun GmbH
Industriestraße 2
D-76307 Karlsbad
[e-mail]