Sirus SM5A User manual

Manual
Speaker SM5A

2 / 8
Table of contents
1. Safety instructions............................................................................................................................ 3
1.1. Instructions for a safe and efficient operation.......................................................................... 3
1.2. Further safety instructions ....................................................................................................... 4
1.3. Designated use........................................................................................................................ 4
2. Introduction....................................................................................................................................... 6
3. Connections ..................................................................................................................................... 6
3.1. Electrical connections.............................................................................................................. 6
4. Control.............................................................................................................................................. 7
5. Technical data.................................................................................................................................. 7

1. Safety instructions
•
This Device is suitable for indoor use only.
•
All modifications will void the warranty
•Repairs
have to
•
Only use fuses of the same type and original parts as spare parts.
•
Protect the Un
•
Make sure to unplug the power supply before opening the housing.
1.1.
Instructions for a safe and efficient
Please read careful through this manual before the first start
All persons which are entrusted with installation, start
device have to:
•
Show a corresponding competence.
•
Follow the lines of this ma
•
Face this manual as part of the product.
•
Keep this manual over the lifetime of the product.
•
Pass this manual to new owners of the device.
Be careful with heat and extreme temperature
Only
use the device in a place where no extreme temperatures will occur.
Do not keep it in a temperature bellow 32°F (0°C
Avoid exposing it to direct rays of the sun or near a heating appliance.
You have to attend that with an ambi
humidity exceeds 50%.
Keep away from humidity, water and dust
Do not place it in a location with
high humidity or lots of dust.
Containers with liquid
should not be placed on
Avoid placing it on un-
stable location
Select a level and stable location to avoid vibration.
Do not use chemicals or volatile liquids for cleaning
Use a clean dry cloth to wipe off the dust
stubborn dirt.
Before cleaning the device make sure you disconnect the powerplug.
If out of work, contact sales agency
If any troubles occurs
, remove the power plug
do not open the cabinet by yourself, i
Take care with the power cable
Never pull the power cable to remove the plug from the receptacle, be sure to hold the plug
Make sure that it isn’t possible to squeeze or damage the power cable with shar
yourself with regular checks that there are no damages to the power cable or
When not using the device for an extended period of time, be sure to disconnect the plug from the
receptacle.
3 / 8
This Device is suitable for indoor use only.
All modifications will void the warranty
.
have to
be carried out by skilled personnel only.
Only use fuses of the same type and original parts as spare parts.
Protect the Un
i
t from rain and humidity to avoid fire and electric shocks.
Make sure to unplug the power supply before opening the housing.
Instructions for a safe and efficient
operation
Please read careful through this manual before the first start
-up.
All persons which are entrusted with installation, start
-
up, operation, maintenance and repair of this
Show a corresponding competence.
Follow the lines of this ma
nual.
Face this manual as part of the product.
Keep this manual over the lifetime of the product.
Pass this manual to new owners of the device.
Be careful with heat and extreme temperature
use the device in a place where no extreme temperatures will occur.
Do not keep it in a temperature bellow 32°F (0°C
), or exceeding 104°F (40°C).
Avoid exposing it to direct rays of the sun or near a heating appliance.
You have to attend that with an ambi
ent temperature von 40°C it is not allowed that the
Keep away from humidity, water and dust
high humidity or lots of dust.
should not be placed on
or near the device.
stable location
Select a level and stable location to avoid vibration.
Do not use chemicals or volatile liquids for cleaning
Use a clean dry cloth to wipe off the dust
. Metall Parts can be cleaned with
a wet soft cloth for
Before cleaning the device make sure you disconnect the powerplug.
If out of work, contact sales agency
soon
, remove the power plug
immediately
, and contact with an engineer for repairing,
do not open the cabinet by yourself, i
t might result in a danger of electric shock.
Take care with the power cable
Never pull the power cable to remove the plug from the receptacle, be sure to hold the plug
Make sure that it isn’t possible to squeeze or damage the power cable with shar
p edges. Assure
yourself with regular checks that there are no damages to the power cable or
the device itself.
When not using the device for an extended period of time, be sure to disconnect the plug from the
Only use fuses of the same type and original parts as spare parts.
t from rain and humidity to avoid fire and electric shocks.
Make sure to unplug the power supply before opening the housing.
up, operation, maintenance and repair of this
ent temperature von 40°C it is not allowed that the
relative
a wet soft cloth for
Before cleaning the device make sure you disconnect the powerplug.
, and contact with an engineer for repairing,
Never pull the power cable to remove the plug from the receptacle, be sure to hold the plug
itself.
p edges. Assure
the device itself.
When not using the device for an extended period of time, be sure to disconnect the plug from the

IMPORTANT:
Damages caused by the
disregard of this user manual are not subject to warranty. The dealer will not
accept liability for any resulting defects or problems.
by qualified personnel
. All electrical and mechanical connections have
the European safety standards.
1.2.
Further safety instructions
IMPORTANT!
Handle with the dangerous electric voltages carefully.
With this voltage there is the danger to get a life
After taken the device from a cold room to a warm room, it is not allowed to activate the device. It is
possible that thereby emerged condensed water damages the device.
it reached ambient temperature.
Make sure that the vo
ltage which i
Don’t switch the device in short time intervals (e.g. in second cycle) on or off.
Keep away children and laymen off the device.
Health risk!
Don’t look directly into the light source.
possible that some people get epileptic seizures. This is especially true for
individuals whose epilepsy was determined by a doctor.
1.3.Designated use
This device was developed for professional use on stages, in discos, theat
approved for a connection up to 230V 50/60 Hz AC voltage
Regular breaks during operation increase the lifetime of your device.
Avoid vibrations
or any form of forceful im
device.
Make sure that the device is not exposed excessive heat, humidity or dust at the place of installat
Take care that no cables are lying around. You would endanger your own safety and also the safety of
a third party.
It is not allowed t
o operate or store the device in an environment in which spray water, rain, humidity
or fog is expected. Humidity or very high atmospheric humidity could reduce the isolation of the device
and could cause deathly electric shocks. If you use fog devices the
direct smoke jet. There has to be a safety distance of at least 0.5m between this device and the fog
machine. Make sure that the saturation of the fog has to enable a visibility of at least 10m.
Do not operate the device dur
ing thunderstorms. Surge volt
device from the
power supply during thunderstorms.
Surrounding objects or surfaces should not be in contact with the device.
The device has to
be protected by a suitable safety
4 / 8
disregard of this user manual are not subject to warranty. The dealer will not
accept liability for any resulting defects or problems.
Make sure the
electrical connection is carried out
. All electrical and mechanical connections have
to be carried out according to
Further safety instructions
IMPORTANT!
Handle with the dangerous electric voltages carefully.
With this voltage there is the danger to get a life
-
threatening electric shock.
After taken the device from a cold room to a warm room, it is not allowed to activate the device. It is
possible that thereby emerged condensed water damages the device.
Do not a
ctivate the device until
ltage which i
t is connected to does
not exceed the specified values.
Don’t switch the device in short time intervals (e.g. in second cycle) on or off.
Keep away children and laymen off the device.
Don’t look directly into the light source.
At certain circumstances it is
possible that some people get epileptic seizures. This is especially true for
individuals whose epilepsy was determined by a doctor.
This device was developed for professional use on stages, in discos, theat
res etc. The device is only
approved for a connection up to 230V 50/60 Hz AC voltage
.
Regular breaks during operation increase the lifetime of your device.
or any form of forceful im
pact during the installation, the start-up
or Operation
Make sure that the device is not exposed excessive heat, humidity or dust at the place of installat
Take care that no cables are lying around. You would endanger your own safety and also the safety of
o operate or store the device in an environment in which spray water, rain, humidity
or fog is expected. Humidity or very high atmospheric humidity could reduce the isolation of the device
and could cause deathly electric shocks. If you use fog devices the
device may not be exposed to a
direct smoke jet. There has to be a safety distance of at least 0.5m between this device and the fog
machine. Make sure that the saturation of the fog has to enable a visibility of at least 10m.
ing thunderstorms. Surge volt
ages could destroy the device.
power supply during thunderstorms.
Surrounding objects or surfaces should not be in contact with the device.
be protected by a suitable safety
cord.
disregard of this user manual are not subject to warranty. The dealer will not
electrical connection is carried out
to be carried out according to
threatening electric shock.
After taken the device from a cold room to a warm room, it is not allowed to activate the device. It is
ctivate the device until
not exceed the specified values.
At certain circumstances it is
possible that some people get epileptic seizures. This is especially true for
res etc. The device is only
or Operation
of the
Make sure that the device is not exposed excessive heat, humidity or dust at the place of installat
ion.
Take care that no cables are lying around. You would endanger your own safety and also the safety of
o operate or store the device in an environment in which spray water, rain, humidity
or fog is expected. Humidity or very high atmospheric humidity could reduce the isolation of the device
device may not be exposed to a
direct smoke jet. There has to be a safety distance of at least 0.5m between this device and the fog
machine. Make sure that the saturation of the fog has to enable a visibility of at least 10m.
ages could destroy the device.
Unplug the

5 / 8
Make yourself familiar with the functions of the device before start-up. People without the experience
should not handle the device. The most cause of functional disorder is inappropriate handling.
Use the original packing or designated accessory for transport to avoid damages.
For reasons of safety unauthorized changes are forbidden.
A usage of the device which differs from usages which are described in this manual can cause
damages of the device. In that case the warranty expires. Additional you should notice that every
differed usage is related with dangers and can cause e.g. an electrical short, fire, electric shock or
crash.

6 / 8
2. Introduction
Thank you for buying the SM5A. It is a powerful device.
For a successful installation and operation, please read this manual carefully.
3. Connections
3.1.Electrical connections
If you wish to change the power supply settings, see the chapter Appendix. Connect the fixture to the
mains with the enclosed power cable and plug. The earth has to be connected.
Cable (EU)
Cable
(US)
Pin
International
Brown Black Live L
Light blue White Neutral N
Yellow/Green Green Earth
1 You are able to connect the Top via
RCA (unbalanced), Jack or XLR
(balanced) to the signal
6 Connect the IEC Plug for the Power
supply here

7 / 8
4. Control
2 Control the Level of the High Frequencies
3 Control the Volume of the Speaker
4 Power on the Speaker
5 Change the Voltage
5. Technical data
Tweeter 1” Neodym Soft Dome
Woofer 5” Composite
Frequency Response 53 Hz – 20 kHz (+- 2 dB)
Power Tweeter: 15 W
Woofer: 30 W
Input balanced: XLR / 6,3mm Klinke; 20 kOhm
unbalanced: RCA; 10 kOhm
HF Level -2dB / -1dB / 0dB / +1dB
Dimensions 230 x 190 x 295 mm
Weight 6 kg

8 / 8
Importeur:
B & K Braun GmbH
Industriestraße 2
D-76307 Karlsbad
www.bkbraun.com
[e-mail]