
2
Skatey.nl BV - De Nedervonder 21 - 5061 JP Oisterwijk – The Netherlands - tel. 0031 13 5220608 - info@skatey.nl – www.skatey.nl
Rabobank 10.18.67.018 – VAT-no. NL850381903B01 - BIC/SWIFT: RABONL2U - IBAN: NL33RABO0101867018
Chamber of Commerce 52295680
1 = Power switch. Press to switch on the remote. Switch off by pressing 2-3 seconds. The remote shall
switch off when not being used for approx. 5 minutes
2 = Speed gear: Sparkling in low frequency for low speed gear; in high frequency for high speed
3 = Code button: In code disconnected mode, the light is off, or sparkling; In code connected mode, the light
keep being on, but the power switch light is off, then, it works with the skate. Switch on the power switch on
the control box under the board, then switch on the remote, then press the code button in front of the skate,
OK now
4 = Battery Indicator 1: The light set indicates the power capacity of the skate battery. If the lights-on point is
on red light, then the skate battery needs to be charged. If the whole lights set keep sparkling while the
remote is on, or while skating, it means the remote is out of power soon, the remote will power off itself soon,
and the skater needs to change 2 new 1.5V#7 small batteries
5 = Speed Indicator: The light set indicates the skating speed of the skateboard. This is only for general
speed indicating, not exact speed indicating. As speeding up by the remote trigger, the indicating lights will
be on gradually from left to right
6 = Battery Indicator 2: This light indicates the capacity of the remote battery
7 = Combination switch for the skateboard: If press these two buttons together, it may switch off the
skateboard directly. Or like the remote, if people forget switching off the skateboard, it could also switch off
itself in about 5 minutes
8
8 = Remote Trigger: Pulling the trigger slowly and gradually, makes the skateboard go forward slowly, and
speed up gradually; Push the trigger slowly and gradually, make the skateboard brake slowly till stop
gradually