SKIP HOP 303326.02 User manual
EN
CONTENTS:
INSTRUCTIONS FOR USE:
Adult assembly required.
CLEANING AND CARE:
Wipe clean with a slightly damp cloth. Remove batteries when unit is not in use for an extended period of time.
Do not drop on hard surfaces or expose it to moisture.
Batteries are included.
Product is shipped in Demo mode. Switch out of Demo mode for normal play.
1. Loosen the battery door screw
using a Philips head screwdriver.
2. Open battery door compartment
and insert three new AA (1.5V)
Alkaline batteries. Be sure to insert
with correct polarity.
3. Position the battery door securely
back into place and tighten with
a screwdriver.
*Batteries should be replaced by an adult.
Read all instructions before assembly and use.
IMPORTANT! Keep instructions for future use.
Bee Rattle TO ACTIVATE BASE
• Easy-to-hold wings are
easy to grab.
• Movable beads and
rubberized details for teething.
•Bee wobbles but won’t fall over.
The motorized base is “Bee Activated”. Slide switch
to desired crawl mode. Put the Bee inside to make it go.
If the Bee is removed, the Cloud Base will spin around
and play music until it is replaced.
CIRCLE MODE: For beginner crawlers
With the Bee in place, Cloud Base
will move in a circular path.
• IMPORTANT:REMOVE sensor-blocking sticker BEFORE giving Follow Bee Crawl Toy to baby.
• Please remove all plastic and/or wire packaging fasteners before giving to a child.
• Sensor is light-sensitive and works best indoors. Not recommended for use in direct sunlight.
•Product works best on a smooth, hard floor or foam mat (may be slower on low-pile carpet). Not recommended for use
on high pile carpet or shag rugs.
• To preserve battery life, Crawl Toy will auto-off after 5 minutes when toy is not in use.
•Always turn the cloud base off when not in use to conserve battery power.
RANDOM MODE: For advanced crawlers
With Bee in place, Cloud Base will
move around in a random path.
When Follow-Bee Crawl Toy senses a wall or
other solid object, it will make a sound and
pivot in a new direction to avoid it.
CLOUD BASE SENSOR
Sensor
•Obstacle sensor
Motorized Cloud Base
•Colorful lights & music
Tactile Ribbons
INSERTING THE BATTERIES:
NOTES:
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device
may not cause harmful interference, and (2) this device must accept any interference recieved, including interference
that may cause undesired operation. Changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This may cause harmful interference to radio communications. However, there is no guarantee
that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on,the user is encouraged to try and
correct the interference by one or more of the following measures:
— Reorient or relocate the receiving antenna.
— Increase the separation between the equipment and the receiver.
— Connect the equipment to an outlet on a circuit different from that
to which the receiver is connected.
— Consult the dealer or an experienced radio/TC technician for help.
CAN ICES-3(B)/NMB-3(B)
Do not dispose of
WEEE in trash.
CONSUMER INFORMATION: SAFETY AND DISPOSAL
Do not dispose of Waste Electrical Electronic Equipment (WEEE), including batteries, in unsorted municipal waste; collect
separately. Dispose of at WEEE collection sites per local regulation. WEEE contains chemicals that are hazardous to the
environment and human health. The end-user’s participation is critical to the success of WEEE collection.
• Do not burn batteries. Dispose of batteries in a safe and appropriate manner.
• Non-rechargeable batteries are not to be recharged.
• Rechargeable batteries are only to be charged under adult supervision.
• Exhausted batteries are to be removed from the toy.
• The supply terminals are not to be short circuited.
• Different types of batteries or new and used/old batteries are not to be mixed.
• Rechargeable batteries are to be removed from the toy before being changed.
• Do not mix alkaline, standard (carbon-zinc), or rechargeable batteries.
• Batteries are to be inserted with the correct polarity.
•Remove batteries before putting toy into storage for a prolonged period of time.
Off Circle Mode Random Mode Demo Mode
IMPORTANT:
REMOVE sensor-blocking
sticker BEFORE giving
Follow Bee Crawl Toy
to baby.
EXPLORE & MORE
follow-bee crawl toy
Other SKIP HOP Baby & Toddler Furniture manuals
