SKIP HOP jumpscape User manual

User Manual of Product 1:
Skip Hop Fold-Away Baby Jumper, Explore & More Jumpscape

AGES
4m+
304350.01
At Skip Hop, we take great pride in the quality of the craftsmanship of each and every item we produce. We are
committed to providing our customers best-in-class, high quality, genuine Skip Hop products through authorized Skip
Hop retailers. We stand behind that by the following warranties against defects in materials and workmanship.
This product is covered by a 2-year Warranty. Warranty is non-transferrable and only applies to the original purchaser. All
refunds and exchanges are issued at the discretion of Skip Hop. Warranty does not cover:
• Damages caused by normal wear and tear (i.e., hook-and-loop wear, etc.)
• Defects resulting from repair or alteration of the product (except by Skip Hop)
• Defects resulting from improper use, including any use or care not in accordance with the product instructions
• Damages resulting from airlines or airport staff
• Defects resulting from improper storage, such as outdoors or in damp environments
• Products that are re-sold, given away, or in any other case where you are not the first and original owner
• Products without receipt or proof of purchase
• Products purchased outside of North America
• Products that are not purchased through an authorized Skip Hop retailer (online or in-store)
Remedies under this warranty are limited to repair or replacement of the product or components of the product. In no
event will Skip Hop or any of its retailers, dealers, distributors or resellers be liable for incidental, indirect or consequen-
tial damages relating to the product (including any repaired or replacement product or component) or its use. Some
jurisdictions do not allow the exclusion or limitation of incidental or consequential damages, so the above limitation
and exclusion may not apply to you.
To get service under this limited warranty: please visit www.skiphop.com, or call 877-4-SKIPHOP (in the US).
LIMITED WARRANTY:
BATTERY INFORMATION:
• At the end of product life, remove batteries from product by following the above battery replacement instructions. Always dispose of used batteries properly.
See section on safety and disposal information. • Batteries are to be inserted with the correct polarity. • Do not burn batteries. • Non-rechargeable batteries are
not to be recharged. • Rechargeable batteries are only to be charged under adult supervision. • Rechargeable batteries are to be removed from the toy before
being charged. • Exhausted batteries are to be removed from the toy. • The supply terminals are not to be short-circuited. • Different types of batteries or new
and used batteries are not to be mixed. • Do not mix alkaline, standard (carbon-zinc), or rechargeable batteries.
CONSUMER INFORMATION: SAFETY AND DISPOSAL
At end of product life remove batteries from product by following the battery replacement instructions. Substances used in batteries pose
potential environmental and health effects. Do not mix waste batteries with other waste. Keep waste batteries separate. Do not dispose of by
landfill or by incineration. Return waste batteries to your point of purchase or recycle center. Recycle all waste batteries per local regulation.
Do not dispose of Waste Electrical Electronic Equipment (WEEE), including batteries, in unsorted municipal waste; collect separately. Dispose
of at WEEE collection sites per local regulation. WEEE contains chemicals that are hazardous to the environment and human health. The
end-user’s participation is critical to the success of WEEE collection.
CAN ICES-3 (B)/NMB-3(B)
© 2017 Skip Hop
50 W 23 ST, NY, NY 10010
In the US: 877.4.SKIPHOP
[email protected]
www.skiphop.com
EU Rep:
Fox Williams
10 Finsbury Square
London EC2A 1AF, UK
IWARNING
• KEEP INSTRUCTIONS FOR FUTURE USE.
• NEVER LEAVE CHILD UNATTENDED! Always keep child in view while in product.
• DO NOT USE THE BABY BOUNCER AS A SWING!
• FALL HAZARD! Stop using this product when child:
- can stand flat-footed in the product at the highest adjustment level
- can lift themselves out of seat or starts to climb out.
- begins to walk unassisted.
• Ages: 4m+. Do not use with children over 26.5 lbs (12 kg) or over 30 inches (76 cm). For use only with
infant who can hold up their head unaided and can sit up unassisted.
• Never use near stairs, stoves or ovens, fireplaces, heaters, swimming pools, or other dangerous areas.
• To avoid tip over, place product on a flat, level surface.
• DO NOT adjust height while child is sitting in the product.
• Make sure Support Strap Rings are securely fastened before putting child in the seat. Check to ensure they
are secure before each use.
• Make sure Jumper legs are securely locked in position on a flat surface before putting your child in the seat.
Ensure that the child is correctly and safely positioned in the seat of the baby bouncer.
• Strings can cause strangulation! DO NOT place items with a string around child’s neck, such as hood
strings or pacifier cords. DO NOT suspend strings over product or attach strings to toys.
• Be aware of the danger of allowing other children to play near the product.
• Do not let other children swing or climb the fold-away jumper.
• Recommended time limit per use session is 20 minutes.
• Do not use this product if it is damaged or broken. Throw away at first sign of damage or weakness.
• Only replacement parts supplied by the manufacturer should be used on the product.
• Remove and discard all packaging materials properly before use.
CAUTION: Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause
harmful interference, and (2) this device must accept any interference recieved, including interference that may cause undesired
operation. Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to
operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a residential installation. This may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the equipment off and on,the user is encouraged to try and correct the interference by one or
more of the following measures:
— Reorient or relocate the receiving antenna.
— Increase the separation between the equipment and the receiver.
— Connect the equipment to an outlet on a circuit different from that
to which the receiver is connected.
— Consult the dealer or an experienced radio/TC technician for help.
OWNER’S MANUAL
Meets or exceeds ASTM F963, EN71 and applicable safety standards.
Cumple o supera los estándares ASTM F963, EN71 y las normas de seguridad aplicables.
Répond ou dépasse la norme ASTM F963, EN71 et les normes de sécurité applicables.
Erfüllt oder übererfüllt alle nötigen Sicherheitsstandards wie ASTM F963 und EN71.
Beantwoord aan of overschrijdt ASTM F963, EN71 en toepasselijke veiligheidsnormen.
Satisfaz ou excede ASTM F963, EN71 e padrões de segurança aplicáveis.
符合或者超出 ASTM F963、EN71，以及适用安全标准。
Product and colors may vary slightly.
El producto y los colores pueden variar ligeramente.
Le produit et les couleurs peuvent varier légèrement.
Am Produkt und bei den Farben sind kleinere Abweichungen möglich.
Product en kleuren kunnen licht verschillen.
O produto e suas cores podem variar levemente.
产品和颜色可能会略有不同。
Made in China. Hecho en China. Fabriqué en Chine.
Hergestellt in China. Vervaardigd in China.
Fabricado na China. 中国制造。
jumpscape
TM
fold-away jumper
EXPLORE & MORE
saltarín plegables
pull repliable
EN
CONTENTS:
BASE TUBE/SUPPORT ARM ASSEMBLY:
CLEANING AND CARE:
TABLETOP ASSEMBLY AND HEIGHT ADJUSTMENT:
SEAT INSTALLATION:
Plastic Parts: Wipe surfaces with mild soap and water. Air dry.
Seat Cover: Machine wash cold, gentle cycle. No bleach. Air dry. Do not iron.
Use only screws and metal bars provided and assemble using a Phillips head screw driver. DO NOT USE POWER TOOLS!
Read all instructions and warnings before assembly and use of the stationary JumpscapeTM Fold-Away Jumper.
IMPORTANT! KEEP FOR FUTURE REFERENCE.
Height is adjusted by attaching Strap Support Rings
to one of the 5 hook locations under the Tabletop.
(1 for tallest child / 5 for smallest child.)
Baby’s feet should be
positioned as shown:
Feed straps through the
guide channels to secure.
DISASSEMBLE FOR STORAGE:
INSTALLING LIGHT-UP BOUNCE COUNTER ON TOP SURFACE:
1.
Remove all toys
2.
Disconnect all straps from Tabletop
5.
Wrap hook-n-loop strap
on bottom of Seat around
legs to secure.
3.
Turn Tabletop upside down between base tubes.
4.
To fold the legs: while pressing down on
the foot pedal, pull up on the Support Arm and fold
toward center. Repeat on other side.
1.
Place toy on edge of Tabletop
(Clip will be pushed out)
2.
Push Clip under Tabletop
3.
Press down on suction cup
2.
Push down
1.
Insert back of Bounce
Counter into slot
Install/replace batteries (by adult only):
• Open battery cover with screwdriver
• Insert or replace with 3 AAA 1.5V batteries.
Be sure to insert with the correct polarity.
• Replace cover and secure screws with screwdriver
Features:
• Every 100 bounces will be rewarded with sound and light effects.
• When powered off (or timed out) the Bounce Counter will save sound and light settings for the next session.
It will also save the count from the last session and the high count.
• Usage reminders will signal after 10 and 20 minutes (recommended use per session is 20 minutes).
• After 30 seconds of inactivity, light and sounds will play to entice baby to move. If no movement after 1 minute,
the same sequence will play and the display will go to sleep. Any movement during this time will wake up the unit
and the Bounce Counter will keep counting.
• After 30 minutes of inactivity, the unit will auto off. Current bounce count will be saved to history as well as the
highest count to date. Press power button to restart.
• Count will max out at 9999. Push on / off to reset to zero.
At the end of the product life, remove batteries from product
by following the battery replacement instructions. Always
dispose of used batteries properly. See section on safety and
disposal information. To prolong the life of this product
remove batteries when toy is in storage.
• Power: On and off
• Sound: Toggle sounds on or off
• Light: Toggle child-facing lights on or off
• History: Press once to view last bounce
count, press again within 5 seconds to view
high count. Count will remain on screen for
5 seconds. Hold down button for 5 seconds
to reset the high score back to zero. Scores
will reset when batteries are changed.
• Sun button:
Plays 4 different sounds and light
effects when baby presses it.
2.
Screw Metal Bars into
Base Tubes (2) with Phillips head
screw driver (not included).
3.
Flip base right side up.
Pull up on Support Arms
and click down into base.
1.
Assemble base upside down.
Place Base Tubes (2)
onto Support Arms.
Seat
Support Arm
Assemblies (2)
Base Tubes (2)
Phillips head screwdriver required for assembly.
Tabletop
Seat Cover Light-Up Bounce Counter
Swaying Trees
Spinning Bee
Hedgehog Mirror
and Tambourine
Jumping Jack Fox
Leaf Teethers
Screws (4)
Metal Bars (2)
Pull on suction cup tab
1. 2.
Pull Clip from under Tabletop
3.
Remove from Tabletop
IMPORTANT: Care should be taken in unpacking and assembly. Examine product
frequently for damaged, missing, or loose parts.
IMPORTANT! Make sure to attach to the same number on all rings so they are the same height.
ALWAYS remove baby from Jumper before adjusting height. Make sure Support Strap Rings are
securely fastened before putting child in the seat. Check to ensure they are secure before each use.
INSTALLING TOYS:
MOVING AND REMOVING TOYS:
LIGHT-UP BOUNCE COUNTER OPERATION (requires 3 AAA batteries):
EN
ADULT ASSEMBLY REQUIRED.