SKLZ HIT-A-WAY Parts list manual

SET-UP & USAGE GUIDE
HIT-A-WAY®
LIMITED
WARRANTY
REGISTER YOUR PRODUCT AT SKLZ.COM TO ENSURE
WARRANTY COVERAGE, GET NEW PRODUCT
INFORMATION AND SPECIAL DEALS FROM SKLZ
IDEA SUBMISSION
If you have an idea for a new and innovative sports training
product, visit SKLZ.com to submit your concept. Some restrictions may apply.
Pro Performance Sports (PPS) / SKLZ warrants to the original consumer purchaser of any PPS/SKLZ product it manufactures
that the product will be free of defects in materials or workmanship for 90 days (unless specified in alternate warranties) from
the date of purchase. If defective and purchased from a retail store, return the product along with receipt to the retail store
where the product was purchased. If the item was purchased from PPS/SKLZ, return the product along with the packing slip
(proof of purchase) postage prepaid to the address below for replacement consideration. Label: Attn: Returns
This warranty does not cover damages resulting from accident, misuse, abuse or lost merchandise. Only valid in the USA. All
returns sent to PPS/SKLZ require a Return Merchandise Authorization number (RMA). For returns to PPS/SKLZ and for all
other Customer Service inquiries, please call toll free, 1-877-225-7275 for a return authorization number for any exchange.
Made in China. ©2012 Pro Performance Sports, LLC. All rights reserved. Manufactured and distributed by
SKLZ/Pro Performance Sports: 2081 Faraday Avenue, Carlsbad, CA 92008 U.S.A. SKLZ, SKLZ Chrome and
Sport-Brella are registered trademarks of Pro Performance Sports, LLC., its subsidiaries and affiliates. Product
features, appearance, and specifications may be subject to change without notice. Unauthorized duplication is
a violation of applicable local and international laws.
HIT-A-WAY®SAFETY INFORMATION:
» Improper use of the Hit-A-Way can result in serious injury.
» Read all set-up and usage instructions carefully. Set-up and proper positioning are
critical for the safe use of your Hit-A-Way.
» Always inspect the Hit-A-Way before using. Do not use your Hit-A-Way if it
appears to be damaged.
» Using a practice bat is recommended. Repetitive use of the Hit-A-Way may cause
damage to wood or high-end lightweight bats.
» Children under the age of 16 should always have an adult present when using the Hit-A-Way.
» If you swing beyond the ball and into the cord, it is possible to lose control
of the bat. While this event is unlikely, it may result in you striking yourself with the bat.
(See page 2 for proper positioning)
» Placing a home plate as a point of reference will help reduce the likelihood that you will
step forward and swing into the cord.
» An uppercut swing increases risk of the bat tangling in the cord.
» This is a tool to develop form and mechanics. DO NOT swing aggressively!
» Only an adult should set up the Hit-A-Way.
Children under the age of 16 should always have an adult present.
AlwAyS wEAr A hElmET:
fAcE GUArD rEcommEnDED

INCORRECT CORRECT
USING YOUR HIT-A-WAY®:
1. Wind ball once around pole (clockwise for right
handers) and pull ball and cord toward you.
Fully extend cord and set home plate down
(not included) so that the ball is over the center
of the plate. Stand 2 feet back from home plate
to hit the ball near the thick end of the bat. If the
bat can reach the adjustment sleeve or beyond,
you’re too close - move back.
2. With the ball centered over home plate, throw
ball forward towards imaginary pitcher until the
cord winds up. The ball will wind around the pole
4 to 5 times.
3. Wait for the ball to unwind 3 to 4 times and hit the
ball. If cords unwind completely, do not hit
the ball; catch it and start over. This is critical,
since swinging into the cord can cause you to
lose control of the bat. Keep hitting as ball returns.
(Do not step toward pole after hitting.)
NOTE: Never stand closer than 2 feet from plate
to avoid bat tangling with cord.
4. Repeat and build a rhythm. You should strive for
repeated, solid contact. Hit continually for a minute
and build up the length of your hitting intervals as
you improve.
“PITCH” HEIGHT ADjUSTMENT INSTRUCTIONS:
Step #1: To lower the ball to your
desired hitting height, pull the
sleeve back, away from the ball
and push the lower cord out of
ball while firmly holding the ball.
Step #2: Pull the excess cord back
through the ball using the upper
cord. (Repeat as desired). Once
the adjustment is made, push the
sleeve back so it butts up against
the ball.
Step #1: Pull the sleeve back,
away from the ball and push upper
cord out of ball.
Step #2: Pull excess cord back
through ball using the lower cord.
Once the adjustment is made,
push the sleeve back so it butts
up against the ball.
Lowering the Height Raising the Height
3
1
1. Find and secure a suitable hitting area, pole,
tree etc. with approximately 12 feet of free
space around pole in all directions. Do not
attach to any street signs.
2. Unloop the Top Collar strap. Hold the colored
tab in your left hand and the Hit-A-Way cable
in your right. Wrap the Top Collar strap 5’ to 6’
from the ground.
NOTE: If positioned correctly, you should be
able to read the text instructions on the
strap. The rubber padding should be
pressed against the post/tree/pole.
Pull the colored tab thru the metal strap loop.
Wrap the strap back onto itself and secure the
strap tightly with the velcro fabric.
3. Repeat with the Bottom Collar strap.
Wrap the Bottom collar approximately
2' from the ground.
21
ATTACHING HIT-A-WAY®TO A POLE:
HIT-A-WAY®COMPONENTS:
Pitch-height adjustment
cords and sleeve
Durable, 4-foot plastic covered
steel cords
11-inch softball with
leather cover and laces