SKLZ Klikster Manual

SET-UP INSTRUCTIONS
Includes:
» 12' x 6' Kickster Goal
» Carry Bag
» 4 Ground Stakes

BEFORE YOU BEGIN:
» Adult assembly required.
» Make sure you have all of the Kickster components. Please contact SKLZ customer service
toll free at 877-225-7275 x128 if you are missing anything.
» Read all setup and usage instructions carefully.
» When done, disassemble Kickster and store after use. Do not leave Kickster outdoors.
» Do not climb or hang on the Kickster.
» Regularly check for wear and tear. Stop using goal if any part of it breaks. Failure to do so
could result in injury.
» Keep away from fire and heat sources.
» Not suitable for children under 3 years of age.
KICKSTER PARTS:
A – Net
B – Base Frame
C – Tension-Tite™ Arm Pole (2)
D – Ground Stakes (4)
KICKSTER ASSEMBLY:
STEP 1–BASE FRAME AND TENSION-TITE™ ARM POLE ASSEMBLY
NOTE: Base Frame and Tension-Tite arm poles come pre-attached by elastic.
Layout one Tension-Tite Arm Pole (C) and link together to
form a straight pole. Repeat with second Tension-Tite Arm
Pole. Layout Base Frame (B) and link the frame together.
Make sure to secure the poles with the push buttons.
NOTE: The slight bowing on the Base Frame is part of the
Tension-Tite system design.
Slide the Tension-Tite™ Arm Poles into each side of the
Base Frame.
NOTE: Ensure arm poles are fully inserted. Failure to do
so may result in damage to the Kickster.
B
Push Button Attachment
C
C

SKLZ.com
STEP 2–CONNECT THE NET TO THE FRAME
Unfold the Net (A) and slide the metal pin at the top of the net into the top of the
Tension-Tite Arm Pole. Make sure that the Kickster logo on the net is facing away from the
frame. Repeat on the other side.
Lift up the base pole to connect the gromments on the bottom of the net to each side of the
frame.
Secure the net to the frame by wrapping the velcro straps around both the Tension-Tite Arm
Poles and the Frame Base.
NOTE: Check the frame to make sure it is securely and fully assembled with the net before
securing to the ground.
STEP 3–SECURE THE KICKSTER TO THE GROUND
Place your Kickster in the desired location. Make sure that
you are on level ground. Secure the goal into the ground
with the included Ground Stakes (D). If you are unable to
press them into the ground with your hand or foot you may
use a mallet.
NOTE: Do not use Ground Stakes on the back of the base
frame. Poles will bend and tension system will not
fuction properly.
NOTE: Care should be taken when pressing in the ground
stakes. Poles can be bent if driven too far into the
ground or hard surface.
CAUTION: Make sure the Kickster is secured into the ground
before play. During play make sure that the
Ground Stakes are secured regularly as a loose
Ground Stake may cause injury.
Grommet attachment
1.
1.
1.
2.
2.
2.
ONLY secure stakes where
indicated above.
SIDE

90-DAY LIMITED WARRANTY – KICKSTER™
Pro Performance Sports (PPS) warrants to the original consumer purchaser of any PPS product it manufactures that the product
will be free of defects in materials or workmanship for 90 days (unless specified in alternate warranties) from the date of purchase.
If defective, and purchased from a retail store, return the product along with receipt to the retail store where the product was
purchased. If the item was purchased from PPS, return the product along with proof of the date of purchase (i.e. the packing slip),
postage prepaid to the address below for replacement consideration:
Pro Performance Sports :: 5823 Newton Dr, Suite 130 :: Carlsbad, CA 92008 :: Attn: Returns
This warranty does not cover damages resulting from accident, misuse, abuse or lost merchandise.
Only valid in the USA. All returns sent to PPS require a Return Merchandise Authorization number (RMA).
For returns to PPS and for all other Customer Service inquiries, please call toll free: 1-877-225-7275
Register your product at SKLZ.com to ensure warranty coverage, get new product information
and special deals from SKLZ
DO YOU HAVE A WINNING SPORTS PRODUCT OR IDEA?
Visit our website to learn how to submit a product application for consideration.
It may become our next winning product!
SKLZ.com
Made in China
©2011 Pro Performance Sports.
All rights reserved.
Unauthorized duplication is
a violation of applicable laws.
U.S. and Foreign Patents Pending.
STORING YOUR KICKSTER:
Remove the Ground Stakes and unvelcro the net from the frame. Place the ground stakes into
the carry bag.
CAUTION: Kickster is under tension when assembled. Please take the utmost care when
releasing the tension during disassembly. Failure to do so may result in injury.
Hold one pin in one hand and one Tension-Tite™ Arm Pole in the other while pulling the pin
out. Repeat on the other side. Remove the Net grommets from each side of the frame. If
needed, air dry the net before you fold and place it into the carry bag.
Pull the Tension-Tite Arm Poles out of each side of the base frame and unlink and fold them
down to store.
NOTE: Store Tension-Tite Arm Pole in the carry bag with the round tops facing away from
each other.
Unlock the push buttons on the Base Frame to unlink the frame. Fold and store in carry bag.
Become a fan on Facebook:
facebook.com/SKLZfans
Follow us on Twitter:
@teamSKLZ
VIDEOS
SKLZ.com