Sky Master ARF F-18 User manual

SkymasterARF F-18 Instructions Manual

first: Take out the front servos mount,

install front fuel tank before installing nose cone

connect nose cone to fuselage by 6 screw

install main gear with setup air pipes for air breaks for the main gear

install nose gear with after connecter

setup the two screws for both rudder fins
When you place the rudder fin in the fuselage, please make sure you use
thread lock or a spring washer to set the screw in tightly. Also, make
sure you check the screw regularly to ensure that the rudder does not
come loose. Please keep in mind, if the rudder is even slightly loose, it
could cause flutter and serious damage on the plane.

install two servos for the Elevator
We suggest use of the Futaba # 9204. (#9151) or JR # 8425 (#8511 or 8611)
servos for the elevator

elevator shafts and servo arms must be installed first (make sure that
there is a minimal lateral movement) and after which the servos mounts
can be installed (included in the kit).

connect both push-pull rods for elevator servos control (the F-18 kit
includes 2 rods for Elevators)

set-up elevator function for up / down movement for each to between 40
mm ~ 45 mm

Glue the 6 Hinges for Ailerons with Flaps