Glow Bricks Lego Santa's Visit 10293 User manual

1

2
Take the shown lighting parts for the extrance

Remove the 1x6 plates from both sides, replace by the lighting parts by the exact
direction
For the remain light, put it inside the clear round brick
3

Then assemble the lights for the tree
4
This part is done

Start from the light bulb at the end, put it inside the cone
5
Restore the green cone, assemble the orange lighting round plate to the orange
round plate at the middle

Keep assemble the lighting round plates by following the color
6
The tree lights is done

Now it’s turn for the house, get the remain lighting parts be ready
7
Start from the front door, remove the lamps and their tops, take the lights from 1x4 blue
at the end

Put the bulbs inside the clear round bricks
Then restore the lamps and assemble the 1x4 lighting plate as shown
8

Then pull the remain lights through the door
9
There’re 2lighting fires are separated, assemble them on the table first

For the 1x6 lighting tan plate next to the connector, move it to the certain area
and assemble it on the ceiling
10

Assemble the black lighting plates and the clear round plate as shown
11
For the clear round plates next to it, assemble 2of them on the chimney
The rest 3will be assembled on the tree

Replace the fire by the lighting fires, the wires can be covered by the picture
12
The remain lights will be assembled to the top

Assemble the grey 1x2 plates on both side and replace the lighting fire at the front
13
At last, connect all three connectors to the USB cable