Sky Wing MXS Manual

Note: SkyWing’s products are updated frequently. As a result, there might be minor
inconsistencies between this manual and the product being built.
1
EPP Electric Model Plane
MXS Build Manual
Warning: This product is not a toy. Children under 12 years of age or first timers
should build and fly the product with the help of an experienced RC pilot.
Model planes are potentially dangerous and can cause harm to people
and properties if operated inappropriately. Please always be safety-
minded when building and operating with your model plane.

Note: SkyWing’s products are updated frequently. As a result, there might be minor
inconsistencies between this manual and the product being built.
2
1. Hinge the ailerons with CA
2. Glue the included aileron horns to the
precut plywood piece. Do not apply too
much glue.
3. Install the quick adjuster to the servo arm
and the push rod.
4. Install the tail servos. You can use a thread
with a weight to fish the servo lead and its
extension through the fuselage, as shown
in the photo.
5. Now install the horizontal tail: insert the
elevator first and then the stabilizer.
6. Make sure the tail is symmetrical about
the fuselage axis.

Note: SkyWing’s products are updated frequently. As a result, there might be minor
inconsistencies between this manual and the product being built.
3
7. Make the distance between the elevator’s
left end and the wing’s left end equal to
that between the elevator’s right end and
the wing’s right end.
8. Make sure that the horizontal tail parallel
to the wing.
9. Only then apply CA to glue the horizontal
tail into position.
10. Now install the rudder.
11. Place the tail horns into the precut slots in
the rudder and the elevator and secure
them with CA.
12. Install the tail servo arms, quick adjusters,
and push rods.

Note: SkyWing’s products are updated frequently. As a result, there might be minor
inconsistencies between this manual and the product being built.
4
13. Insert the landing gear as shown in the
photo.
14. Install the motor and then glue the frontal
piece to the fuselage.
15. Stick the ESC to the fuselage with a piece
of Velcro.
16. Install the two metal hooks into the pre-
drilled holes in the wing halves.
17. Glue the two small wing-root pieces to the
wing halves respectively.
18. Finally, installing the SFGs is optional.

Note: SkyWing’s products are updated frequently. As a result, there might be minor
inconsistencies between this manual and the product being built.
5
Specifications:
Wingspan: 1219 mm
Length: 1152 mm
Wing Area: 30.4 dm2
AUW without battery: 870 g
Power Set-up:
Motor: 3715 KV820 Brushless Outrunner
Battery: 3-cell 20-25C LiPo 1800-2200
mAh
ESC: 40A
Propeller: APC 13x6.5E, 12x6E
Servos: 12-gram, 1.5-2.0 kg, 0.1-0.2 s
Control Set-up:
Aileron Throws: 35-40 degrees
Elevator Throws: 40-45 degrees
Rudder Throws: 40-45 degrees
CG Position: 115-120 mm from the
leading edge of the wing