MMC Photon A10 User manual

Photon A10 User Manual
Sky-end
Image 1 Sky-end Frontal Diagram
Image 2 Sky-end Right Side Diagram
Image 3 Sky-end Left Side Diagram

Image 4 Sky-end Back Side Diagram
1. HDMI Input
Use HDMI wire to connect this port to the HDMI output port of camera/Max. 1080P60 video
input.
2. Serial Port
1) 5V: Power Output；
2) RX: Serial Port Input (TTL electrical level, Default 115200 bps, optional 9600 bps, 57600
bps);
3) TX: Serial Port Output (TTL electrical level, Default 115200 bps, optional 9600 bps, 57600
bps);
4) G: Ground Electrode
3. S-Bus1
1) 5V: Power Output;
2) TX: S-Bus output(connect flight control SBUS connector or gimbal SBUS connector) ；
3) G: Ground Electrode
4. Power Input
1) 12V: Power Input（4.5v-16v）;
2) G: Ground Electrode
5. S-Bus2
1) 5V: Power Output;
2) TX: S-Bus output (connect flight control SBUS connector or gimbal SBUS connector) ；
3) G: Ground Electrode
6. Video Indicator Light
Image transmission link indicator light to signal video input status.

Indicator Light
Status
Constant Green Light
Detection of HDMI signal and normal function
Shining Green
Detection of HDMI Signal but incapability to send.
Light
Reconnect sky-end power or check if it is correctly wired.
Constant Red Light
No detection of video source input or incompatible video source input.
Check if the camera is correctly connected to wire or check the camera
output settings.
7. CTRL Indicator Light
Image transmission link indicator light to signal the connection status between sky-end and
ground-end
Indicator Light
Status
Shining Red Light
LINK pressed down and sky-end is successfully paired to ground-end.
Shining Green Light
Detection of HDMI signal but incapable to send. It needs frequency
calibration.
Constant Green Light
Sky-end and ground-end connected successfully.
Constant Red Light
No detection of signal. Turn on the ground-end power switch or check
if the sky-end is correctly connected.
8. PAIRING button
The frequency matching between the sky-end and the ground-end can be achieved through the
pairing button.
9. SMA connector
The connector of the antennas, be used for connecting the sky-end video transmitter.