SkylinkHome TB-318 User manual

4. TOGGLE MODE (DEFAULT)
Push pad to
toggle on / o
ON
OFF
Pushing the pad from one position to the other will toggle the status of a
load, i.e. when the light is o, pushing the pad will turn on the light, and
vice versa.
To enable or disable the ON/OFF Operation
mode, press and hold the set button for
15 seconds until the LED blinks.
5. ON / OFF MODE
Push the top button to turn on your light and push the bottom to turn it o.
+
Red
LED
SET
Button
CR 2032 SET
Button

Press and Hold
to dim the light.
TOGGLE MODE:
Press and Hold
to brighten
the light. OR
6. BRIGHTNESS CONTROL OPERATION
Besides turning on and o a load, you may also control the brightness
of a light if the receiver module and the light bulb isdimmable, i.e. either
incandescent light or dimmable compact uorescent light.
To change the brightness, rst turn on the light by pushing the pad.
Then, press and hold the pad after the light is on will change thebrightness
of the light. When the desired brightness is reached, release the pad.
ON/OFF MODE:*
Press and Hold
to brighten or
dim the light.
-001