Skywalker X-5 User manual

Skywalker X-5 Fly wing for FPV
Welcome to buy X-5 fly wing, this is a small sized FPV aircraft, but it has enough lift area to carry
C or gopro. It is suitable for cruising at a speed of 60KM/H. It also has a relatively spacious
cabin and is convenient to carry around. The installation is very simple. Look at its accessories
and installation instructions below .

Parts in the accessories bag: 1 glue , 2 steel tie rods, 2 extension cords , 2 rudder horns and quick
connector. And 4 fixed screws for motor and 2 for hatch cover.
First disconnect the winglets

Spread the glue evenly over the winglets and fuselage and wait for five minutes, then adhere the
winglets to the fuselage.
Installation of motor: here for 2212 ~ 2215 KV 1600~1900 outer rotor brushless motor, generally
it is high speed flight, so we need to adjust the thrust line with two gaskets.

Spread the glue evenly between the motor base and the layer, wait until it is non-sticky, they can
be pressed, as for binding benchmark, the bottom edge shall prevail.

The angle is like this after binding
Glue the servo and rudder horn, power on the receiver and make servo stop in the mid-position,
and then lock the regulator. After that cut the aileron. Here are advices for players who are new to
this fly wing : aileron deflection angle ,which is -20/+20 degrees, is more appropriate. Increase the
rudder quantity as you adapt to this.
Spray paint on the hatch cover

Cut some CC briquette in front of hatch

Gluing on the fuselage
Gluing the antenna base of the data radio

Try whether CC is suitable for installation

Basically completed

It is looks like this after attaching stickers

When you use a wide-angle lens, you need to cut the front part into some bevels, so as not to keep
out line of sight.

ata radio or other devices can be installed above the engine cover, install battery in the forecabin,
which is suitable for 2200ma4S batteries. Midbin is fit for placing C or goupro toward the
ground, the rear cabin for OS and etc. Please use a cable to extend the video transmitter antenna
to the far-end of the wing, which can avoid the interference of GPS module's placement on the
front inner side of the engine cover. These are our suggestions, you can install the equipment
according to own hobby.