SMART BOOSTER T5-A User manual
Quick Start Guide
T5-A
Ｃｅｌｌ Ｐｈｏｎｅ
Ｓｉｇｎａｌ Ｂｏｏｓｔｅｒ
Package Contents
Signal Booster
X1
Outdoor
Antenna
X1
Indoor
Whip
Antenna
X1
Power
Supply
X1
How It Works
①Find the outdoor area with Strongest Signal
②Install the outdoor Antenna
PAY ATTENTION TO SELF-OSCILLATION*
③Install the Booster
④Connect the System
⑤Check the Coverage and Optimize
1)Walk around your house with
your cell phone, search for the
place where your phone gets the
strongest signal reception, at
least 3-4 signal bars.
2)Make a few phone calls there
to check the call quality, if it is
clear and stable, that will be an
ideal position to place the
outdoor antenna.
①
Install the outdoor antenna on
the wall near the location you
found in Step 1. Make sure the
antenna points towards the
direction on where your cellular
operator’s tower is.
To prevent lightening, the height
of the outdoor antenna should
be lower than the highest point
of your house.
②
Connect the Outdoor Antenna
cable with “BTS " port on the
cellular signal booster, and
connect the Indoor Whip
Antenna with “ANT" port on the
booster. Then power on the
booster and check the coverage.
④
√×
If you do not have any installation experience,
please read the detailed installation guide within the manual.
Place the Booster at where
strong signal is needed most.
③
*The Outdoor Antenna should be
as far away as possible from the
Indoor Antenna.
Minimum separation : 20 Feet
Horizontal and 13 Feet Vertical.
＞13FT.
＞20FT.
booster
12
The arrows represent the
isolation between outdoor
antenna and indoor antenna.
When flashing, it reminds you the
separation between antennas are
not enough. Try to increase more
distance between antenna and
make sure the antennas are not
facing to each other.
It shows the outdoor signal
strength your booster picked up
from outside. The more bars you
get, the better coverage the
booster will produce. Try to get
at least 2 bars, 3 bars will be the
best.
⑤
1
2
power
Product Specifica�ons
Model: T5-A
Network: AWS-1/Cellular/LowA-EBlocks/700MHzUpperC
Block/BroadbandPCS
Model No.
Working Band
Range (MHz)
Range (MHz)
Maximum Gain
Maximum Output
AGC Range
Ripple in Band
Impedance
Weight
Dimension
Environmental
50 ohm
：，：
，
777-787
Cellular BroadbandPCS
Smart Booster S5-A
2.Check if the cables are properly connected.
2. Check if the outdoor cable is installed
securely without damage.
booster device need to be sent to supplier for
repair.
(1)Usage of unauthorized antennas, cables, and/or coupling devices may result in poor effect and, insevere
cases, equipment damage.
(2)a complete list of authorized antennas, cables, and/or coupling devices:
This equipment should be installed and operated with a minumum distance of 20cm between the
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation
radiator and your body.
The antenna for the device must be installed to comply with the 10 meter above ground maximum
antenna height limitation
This equipment complies with IC radiation exposure limits set forth for an
uncontrolledenvironment. This equipment should be installed and operated with
minimum distance of 20 cmbetween the radiator and your body. This transmitter
must not be co-located or operating inconjunction with any other antenna or
transmitter.
This device complies with Industry Canada licence-exempt RSS standard(s). Operation
is subjectto the following two conditions:
(1) This device may not cause interference, and
(2) This device must accept any interference, including interference that may cause
undesiredoperation of the device.
Le present appareil est conforme aux CNR d'lndustrie Canada applicables aux appareils
radioexempts de licence. L'exploitation est autorisee aux deux conditions suivantes:
(1) l'appareil ne doit pas produire de brouillage, et
(2) 'utilisateur de 'appareil doit accepter tout brouillage radioelectrique subi, meme si
lebrouillage est susceptible d'en compromettre le fonctionnement
This is a CONSUMER device.
BEFORE USE, you must meet all requirements set out in CPC-2-1-05.
This device MUST ONLY be operated with approved antennas and cables as specified by the manufacturer.
Antennas must be installed in a way where the minimum separation distance between the antennas and a
user (or bystander) specified by the manufacturer is ALWAYS maintained.In order to reduce oscillations it is
recommended that sufficient separation distance is maintained between the donor and server antennas of
the zone enhancer system.You MUST cease operation of this device immediately if requested by ISED or a
licensed wireless service provider.
WARNING:E911 location information may not be provided or may be inaccurate for calls served by using
this device.
Ce produit est un appareil GRAND PUBLIC.
AVANT DE L’UTILISER, vous devez vous conformer à toutes les exigences établies dans la CPC 2-1-0.
Cet appareil NE DOIT ÊTRE UTILISÉ qu’avec des antennes et des câbles approuvés, conformément aux indic
ations du fabricant. Les antennes doivent être installées de manière àce que la distance minimale de sépara
tion entre les antennes et un utilisateur (ou un passant) spécifiée par le fabricant soit TOUJOURS respectée.
Afin de réduire les oscillations, il est recommandéde maintenir une distance de séparation suffisante entre l
es antennes du donateur et du serveur du système d’enrichisseur de zone.Vous DEVEZ cesser d’utiliser cet
appareil immédiatement à la demande d’ISDE ou d’un fournisseurde services sans fil autorisé.
AVERTISSEMENT:Les informations relatives àla localisation pour le service E911 peuvent être non fournies
ou inexactes pour les appels transitant par cet appareil.This device may operate in a fixed location only, for
in-building use.
Cet appareil peut fonctionner seulement àun emplacement fixe à l’intérieur d’un bâtiment.
label:
CPC-2- 1-05 — Zone Enhancers - Spectrum management and telecommunications
https://ised-isde.canada.ca/site/spectrum-management-telecommunications/en/learn-more/key-
documents/procedures/client -procedures-circulars-cpc/cpc-2-1-05-zone-enhancers
CEREVO TECHNOLOGY LIMITED
F22, Tower B, RuiChuangGuoJi Plaza, No.8 WangJing East Road, Chaoyang
District, Beijing, China 100102
Contact: Esson Diao
Tel: 18218747363
Email:[email protected]
Table of contents
