Smart Lifestyle SLA-R18-190D/N3A4 User manual

PTR valve
Water outlet
E-heater
Temp. sensor
Condensate Drainage
Overflow
Water inlet
1
2
3
4
5
6
7
1
2
3
4
5
6
7






Fast heating mode (hybrid heating mode)
Electric heater mode
Fan running indication
Lock indication
Defrost mode
Timer on/Timer off icon
Clock
The setting value of water temperature
The current value of water temperature
Heat pump mode
Condensate
tube
Manual
Manual
Tube joint
PTR valve
Tempering valve
Full Package

Position the heat pump on a flat sturdy surface.
Connect cold water inlet.
Joint connect cold water pipe, hot water pip and temper-
ing valve.
Switch power on. Hold out the ON/OFF button for 2
seconds to start the heat pump.
Connect hot water outlet and PTR valve.
Fix the tube joint and fit the condensation tube to the
overflow port. Finally, run it to suitable location.


Position the heat pump on a flat sturdy surface.
Connect cold water inlet.
Joint connect cold water pipe, hot water pip and temper-
ing valve.
Switch power on. Hold out the ON/OFF button for 2
seconds to start the heat pump.
Connect hot water outlet and PTR valve.
Fix the tube joint and fit the condensation tube to the
overflow port. Finally, run it to suitable location.



Maintenance space requirements
Unit dimension
Enclosed room installation
≥300mm
≥300mm ≥200mm
Controller
≥300mm
≥300mm ≥200mm
ΦD
H
D 640mm
2010mm
510mm
2175mm
H
Model SLA-R25-300D/N3D4
SLA-R25-300D/N3D4C
SLA-R18-190D/N3A4
Top clearance is primarily a maintenance rather than operational requirement. If top clearance is reduced future mainte-
nance (if required) cost may increase due to need to move and then return unit to original position.
SLA-R18-190D/N3A4: the minimum area = 25m3.
SLA-R25-300D/N3D4, SLA-R25-300D/N3D4C: the minimum area = 32.5m3.
Note: