
Installation
Before installation, please test the doorbell button range first.
It is not advised to mount the transmitter onto metal surfaces as the
material can block RF signals between the transmitter and the
receiver.
Plug the receiver into the socket.
Peel the insulating film from the battery to power the transmitter on.
Tear off one side of the double-sides adhesive tap and stick it to the
underside of transmitter, tear off the other side and attach transmitter
in the desired location.
Pairing
The transmitter(s) supplied with this kit is(are) paired with receiver. IF
NOT or you want to pair more, you might easily pair the transmitter
with receiver as followings.
Press Music Up Button or Music Down
Button to choose your favorite
ringtone.
Press and hold the pairing button until
you hear one beep and indicator light
blue, then the receiver goes into the
pairing/sniffer mode.
Press the button on transmitter, then the receiver beep and flash
once to indicate the pairing is complete. The receiver will beep and
flash twice to indicate that the pairing fails if the transmitters are full
(max to 100).
Tips: One transmitter can be paired to more than one receivers and
vice versa.