SolarMax OT LED Area Light Series Service manual

OT Series LED Area Light
Type A Sliptter Mount
Installation Instruction Manual
Read these instructions completely and carefully. Save these instructions for future use.
• To avoid the possibility of electric shock, turn o power supply before installation or servicing.
Installation and servicing should be performed by qualied technician.
• Before closing cover of xture, make sure all wires are inside xture housing to avoid pinching
wires.
• Fixture must be installed in accordance with NEC or local electrical codes.
• For protection, install/service technician should always wear protective goggles and gloves
during the installation and maintenance.
• SolarMax LED is not responsible for any damages caused by parts/components that are not
supplied by SolarMax LED.
Before proceeding with installation or service maintenance of this product:
SolarMax LED | 3080 12th St., Riverside, CA 92507 | [phone] | [email protected]
Slip the Sliptter onto the tenon.
Secure with (4) hex head bolts.
STEP 2
Torque Force ≥ 8.3M/N.m until locking
Remove (4) bolts from the Sliptter bracket.
STEP 1

Wire Connection
STEP 4
OT Series LED Area Light
Type A Sliptter Mount
Installation Instruction Manual
SolarMax LED | 3080 12th St., Riverside, CA 92507 | [phone] | [email protected]
Adjust the tilting with embedded M16
socket head screw. Secure at a desired angle.
STEP 3
Sliptter with Double Arm TenonSliptter with Single Arm Tenon
Torque Force ≥ 71M/N.m until locking