Solartech M-455B User manual

.
..
. Solartech P
PP
Power
owerower
ower,
,,
, I
II
Inc
ncnc
nc.
..
.
Solartech Power, Inc.
1070 N. Kraemer Place
Anaheim, CA 92806 USA
Tel: [phone] Fax: [phone]
www.solartechpower.com
E-mail: [e-mail]
Solartech Power Universal Side
Solartech Power Universal SideSolartech Power Universal Side
Solartech Power Universal Side-
--
-of
ofof
of-
--
-Pole Mount Installation Guid
Pole Mount Installation GuidPole Mount Installation Guid
Pole Mount Installation Guide
ee
e
MODEL: M
MODEL: MMODEL: M
MODEL: M-
--
-455
455455
455
Component List
Part Qty ID code
Bracket 1 1
Arm 1 2
压板
2
M10 U 型螺丝
2
M10 平垫片
4
M10 弹簧垫片
4
M6*16 螺丝
6
M6 平垫片
10
M6 弹簧垫片
10
M6*25 螺丝
4

.
..
. Solartech P
PP
Power
owerower
ower,
,,
, I
II
Inc
ncnc
nc.
..
.
Solartech Power, Inc.
1070 N. Kraemer Place
Anaheim, CA 92806 USA
Tel: [phone] Fax: [phone]
www.solartechpower.com
E-mail: [e-mail]
Step 1 - mounting the arm to the PV module
Step 2 - attaching the bracket to the pole
Adjust the backing bracket to desire
height and then attached the U-clamp on
the pole as shown in picture.
Insert a bolt, washer and PV module clamp
through one of the slots.
Place a washer, lock washer and hex nut on
the end of the bolt, and tighten loosely
Lay the PV Module face-down on a
protected flat surface.
Center the arm on the back of the panel as
shown and position the clamps under the
edges of the module’s flange.
Make sure that the clamp bolts are resting
against the module’s flange before
tightening

.
..
. Solartech P
PP
Power
owerower
ower,
,,
, I
II
Inc
ncnc
nc.
..
.
Solartech Power, Inc.
1070 N. Kraemer Place
Anaheim, CA 92806 USA
Tel: [phone] Fax: [phone]
www.solartechpower.com
E-mail: [e-mail]
Step 3 - attaching the panel/arm assembly to the bracket
Insert the pivot bolt and flat washer first this
will enable you to adjust the angle.
Adjust the arm piece to desire angle and insert
the bolt from outside and insert the washer
from inside and tighten the bolt. Make sure you
have two sets on each side installed.
Adjust the tilt of the panel as desired, and
tighten the bolts