Solartech SPM040P User manual

Solartech Power Universal Side-of-Pole Mount Installation Guide
Component List
Part
Qty
ID code
Bracket
1
1
Arm
1
2
U-Bolt
2
4
M8 U-Clamp for 2.5’’ pole
2
M8
尼龙
hex-cap bolt for U-bolt
4
M6 *25 hex-cap bolt for Bracket
6
M6 flat washer for Bracket
6
M6 split lock washer for Bracket
6
M6 *18 hex-cap bolt for PV Module
4
M6 flat washer for PV Module
4
M6 split lock washer for PV Module
4
M6 hex nut for PV Module
4
The Mount suppors PV modules:
SPM040P, SPM045P, SPM050P, SPM055P

Step 1 - mounting the arm to the PV module
Insert a bolt, washer and PV module clamp
through one of the slots.
Place a washer, lock washer and hex nut on
the end of the bolt, and tighten loosely
Lay the PV Module face-down on a
protected flat surface.
Center the arm on the back of the panel as
shown and position the clamps under the
edges of the module’s flange.
Make sure that the clamp bolts are resting
against the module’s flange before
tightening

Adjust the arm piece to desire angle and insert
the bolt from outside and insert the washer from
inside and tighten the bolt. Make sure you have
two sets on each side installed.
Adjust the tilt of the panel as desired, and
tighten the bolts
Step 2 - attaching the bracket to the pole
Step 3 - attaching the panel/arm assembly to the bracket
Adjust the backing bracket to desire
height and then attached the U-clamp on
the pole as shown in picture.
Insert the pivot bolt and flat washer first this
will enable you to adjust the angle.