Solidrun Hummingboard series User manual

1 | P a g e

SOLIDRUN LTD

HummingBoard series

SolidRun Ltd.

P.O Box 75

Migdal-Te en, 2495900

ISRAEL

http://www.solid-run.com/

Quick User’s Guide

Contents of package

•One HummingBoard board computer.

•One Warranty note.

•One User Manual

Models covered by this User Guide:

I1-310-D, I2-310-D, I2eX-310-D, I4-310-D

Start by reading t e safety notice below before making any adjustments

suc as connecting an RTC backup battery

Setting up t e system

1. The HummingBoard boots rom the microSD. I you purchased a pre-loaded microSD then skip to

step #3.

2. When using your own micro SD device, we recommend a 4GB micro SD class4 or higher.

3. Power Adapter: you may choose your own power adapter, make sure to use a power adapter with the

ollowing speci ication:

Regulated 5V supply with 2A source capacity.

Micro USB plug type.

Use only limited power source (LPS) power adapter with adequate protections. Power adapter

should meet local sa ety regulations.

4. To run applications or distributions on your HummingBoard, you must install them on the microSD card.

Visit this link or more details:

http://www.solid-run.com/support/install-os-micro-sd- lash-card/

5. Once you have your HummingBoard, microSD and power adapter ready, insert the micro SD in the

microSD slot with the microSD pins acing up.

6. Connect an Ethernet cable to your HummingBoard device i network connectivity is desired.

7. Connect the HummingBoard to a display screen via an HDMI cable.

8. Connect your power adapter to the Micro USB connector, and then connect the adapter to mains

supply.

Downloaded from Arrow.com.

2 | P a g e

A red LED (see Indication LEDs in diagram below for LED location), indicating that the system is powered on.

The system should be up and running in ew moments, and your OS o choice should be displayed on the

monitor:

It is recommended to visit the “Getting Started” page in order to learn how to install di erent operating systems and/or

upgrade to recent ones:

http://www.solid-run.com/support/cubox-getting-started/

PRODUCT INFORMATION

1. Overview

HummingBoard amily o products are low cost, highly energy e icient and small orm- actor open source based

board computer that can be used or di erent applications. The HummingBoard high per ormance, high quality yet

low cost and rich connectivity options make it ideal or the embedded market. In addition, the open design nature o

the HummingBoard carrier board makes it per ect or educational and learning projects as well as or DYI and Makers

projects.

2. Interfaces

Figure 1 Example: Android Operating System

Downloaded from Arrow.com.Downloaded from Arrow.com.

3 | P a g e

Figure 2 HummingBoard key features

Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.

4 | P a g e

Figure 3 RTC Generation Circuit using NXP’s PCF8523

Interface

Description

I2-310-D

I2eX

I4-310-D

Micro USB

MicroUSB type connector or p

ower

ing the

HummingBoard and its accessories. User

must connect a 5V limited power supply.

See below sa ety notices or urther sa ety

instructions.

Use 5V/2A

(See sa ety

section

below)

Use 5V/2A

(See sa ety

section

below)

HDMI

Full HD HDMI output. Connect to your TV

set.

Supported

Dual Internal

USB

Two powered internal USB ports. Do not

overload with more than 0.25A current

consumption.

Not

supported

Supported

Ethernet

Connect to your Ethernet switch or router

or local wired networking (LAN).

Fast

Ethernet

Gigabit

Ethernet

CSI Module

CSI connector or camera modules

Supported

Dual USB

Two powered USB port. Connect your USB

device such as Keyboard, Mouse, HD, etc…

Do not overload with more than 0.5A

current consumption.

Supported

RTC Backup

battery

connector

Not

supported

Supported

(See sa ety

section

below)

In ra RED Rx

In ra Red receiver or remote control

support. Running application must support

this unctionality.

Not

supported

Supported

Reset Button

This is a hardware reset button.

Supported

Analog Audio

Mono

output

PWM tune

generator

Stereo

output and

MIC input

SPDIF Output

SPDIF

Coaxial Output.

Supported

Mini PCIe

Hal length (short) mini PCIe module

connector or expansion.

Not

supported

Supported

GPIO Header

26 pin GPIO Header or input and output o

digital signals rom expansion boards and

wire-ups.

Supported

LVDS

LVDS connector with support o lat LCD

Not

Supported

The indicator LED shares the IR receiver window .

note

Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.

5 | P a g e

Connector

panels and touch screen input method

support.

supported

MicroSD

MicroSD MUST be

installed with proper

operating system and application or

proper operation o the device.

Supported

mSATA

Supports SSD Drive on a module with a

SATA high speed inter ace and mSATA

mechanical orm actor.

Not

supported

Supported

Indication

LEDs

Supported

3. System Specifications Hardware:

Below is a table summarizing HummingBoard features for all models.

Model

310

I2eX

310

Commercial

name

HummingBoard

2eX

HummingBoard

C ipset

i.MX6 Solo

i.MX6 Dual Lite

i.MX6 Dual

i.MX6

Quad

Core Count

1 @ 1 GHz

2 @ 1 GHz

@ 1 GHz

Memory Size

512MByte DDR3

1GByte DDR3

GByte DDR3

Memory

Config

32 bit @ 800Mbps

64 bit @ 800Mbps

64 bit @ 1066Mbps

3D GPU

GC880

GC2000

3D GPU Type

OpenGL|ES 1.1/2.0

OpenGL|ES

1.1/2.0,OpenCL 1.1E

OpenGL|ES

1.1/2.0,OpenCL 1.1E

HW Video

Dec/Enc

Multi Format

HDMI 1080p

1.4, 3D support

Et ernet

10/100 Mbps

10/100/1000 Mbps (*)

USB 2.0 Host

2 x Hosts

x Hosts

Micro SD

Interface

mSATA

3Gbps

RTC Wit

Backup

Battery

RTC Backup Battery

Connector Only

RTC Backup Battery

Connector Only

Coaxial

S/PDIFAudio

Out

InfraRed for

Remote

Control

Receive

Software:

•Android

Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.

6 | P a g e

•

Yocto

•Ubuntu

•XBMC

•reeBSD

•Debian

•GeexBox

•And much more …

4. Operating environment

Operating temperature: 0°C to 40°C

Relative humidity: 5% to 90%

COMPLIANCE AND SAFETY INFORMATION

Federal Communications Commission (FCC) Statement

Labelling requirement for small device statement (FCC15.19(3))

This device complies with part 15 o the FCC Rules. Operation is subject to the ollowing two conditions: (1)

This device may not cause harm ul inter erence, and (2) this device must accept any inter erence received,

including inter erence that may cause undesired operation

Radio Frequency Interference (RFI) (FCC 15.105)

This equipment has been tested and ound to comply with the limits or Class B digital

devices pursuant to Part 15 o the FCC Rules. These limits are designed to provide

reasonable protection against harm ul inter erence in a residential environment. This

equipment generates, uses, and can radiate radio requency energy, and i not installed

and used in accordance with the instruction manual, may cause harm ul inter erence to

radio communications. However, there is no guarantee that inter erence will not occur in

a particular installation. I this equipment does cause harm ul inter erence to radio or

television reception, which can be determined by turning the equipment o and on, the

user is encouraged to try and correct the inter erence by one or more o the ollowing

measures:

•Reorient or relocate the receiving antenna.

•Increase the separation between the equipment and the receiver.

•Connect the equipment into an outlet on a circuit di erent rom that to which the receiver is

connected.

•Consult the dealer or an experienced radio/TV technician or help.

Modifications (FCC 15.21)

Changes or modi ications to this equipment not expressly approved by SolidRun Ltd. may void the

user’s authority to operate this equipment.

Canadian Compliance

This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the

ollowing two conditions: (1) this device may not cause inter erence, and (2) this device must accept any

inter erence, including inter erence that may cause undesired operation o the device.

Le présent appareil est con orme aux CNR d'Industrie Canada applicables aux appareils radio exempts de

licence. L'exploitation est autorisée aux deux conditions suivantes: (1) l'appareil ne doit pas produire de

brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le

brouillage est susceptible d'en compromettre le onctionnement.

The device meets the exemption rom the routine evaluation limits in section 2.5 o RSS 102 and compliance

Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.

7 | P a g e

with RSS-102 RF exposure, users can obtain Canadian in ormation on RF exposure and compliance.

Le dispositi rencontre l'exemption des limites courantes d'évaluation dans la section 2.5 de RSS 102 et la

con ormité à l'exposition de RSS-102 r , utilisateurs peut obtenir l'in ormation canadienne sur l'exposition et

la con ormité de r .

This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.

This equipment should be installed and operated with a minimum distance o 20 centimeters between the

radiator and your body.

Cet émetteur ne doit pas tre Co-placé ou ne onctionnant en même temps qu'aucune autre antenne ou

émetteur. Cet équipement devrait être installé et actionné avec une distance minimum de 20 centimètres

entre le radiateur et votre corps.

Class B Notice for Canada

This Class B digital apparatus complies with Canadian ICES-003.

Cet appareil numérique de la classe B est con orme à la norme NMB-003 du Canada.

3. For EU - CE compliance

This device complies with the EMC Directive 2004/108/EC and Low Voltage Directive 2006/95/EC.

Note: Shielded Ethernet cable must be used in order to comply with emission limits.

4. Safety notice

a) This device is to be used with Certi ied Power adaptor with output rated at 5VDC, 2A. Power adapter

must meet Limited power source (LPS) requirements.

b) Power adapter must meet local sa ety standards and requirements based on product intended use.

c) Power adapter must meet Operating environment conditions as speci ied in section 4 above.

d) Maximum allowed current consumption o the device is 2A, including external USB devices (each can

consume up to 0.5A based on USB 2.0 standard.) As an open and con igurable plat orm, the user must

check any con iguration they build to not exceed the allowed current consumption limits.

e) This device does not ship with a battery. Sa ety testing was made without an RTC backup battery.

) Care ul testing and measurement o component temperature must be made when enclosing the

HummingBoard models with add-ons such as RTC battery, PCIe add-on, mSATA add-on or USB devices

connected to internal USB ports. RTC Backup Batteries ave critical safety parameters suc as

temperature range and current rating t at must NOT be exceeded. RTC circuit is included in igure 3

or re erence.

g) When installing RTC Backup battery, check or: Compatibility with NXP’s PCF8523 speci ications.

Positive pin o battery is connected to pin 1 o the RTC Backup Battery connector (see igure 2).

Battery’s actual worst case temperature and withdraw current meet battery speci ication.

h) Caution, Risk o explosion i battery is replaced by an incorrect type. Dispose o used batteries

according to the local regulations.

Some sur aces o the device might reach high temperature when the device is under heavy work load.

See igure 2, page 3

5. Disposal

Follow local regulations regarding disposal o the product. Dispose o your product in accordance with local

regulations. In some areas, the disposal o these items in household or business trash may be prohibited.

Help us protect the environment - recycle!

Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.

This manual suits for next models

Table of contents

Other SolidRun Motherboard manuals