Solus Leisure 810 User manual

8.0 Heart Rate Mode Display
6.0 Setting the Daily Alarm
Hold during the to select
the setting display, the 'hour' digits will start
flashing.
[M] Daily Alarm Mode
3
12
6.1Turn the Alarm and Chime ON/OFF
Press or hold to set ì hourî and ì minuteî[S] [S] .
[M]
This icon will appear
when chime is on.
There are 4 status can be
switched by pressing :
1. Alarm off / Chime off
2. Alarm on / Chime off
3. Alarm off / Chime on
4. Alarm on / Chime on
[S]
This icon will appear
when alarm is on.
100 beats
per minute
Flashing follows
the heart rate
pulse.
Icon is on when zone
alert is enabled.
" "will flash
when you enter
.Heart Rate Mode
Hold
for few
seconds
[HR1]
Below
zone
In
zone
Above
zone
Press the
with your index
finger for more
than 1 second.
[HR1] Make sure
on the
back of the
watch sits firmly
on your skin.
[HR2]
SM - 704.1
[M] [M]
7.0 Heart Rate Mode
- Getting a Heart Rate Reading
9 0 Potential Causes for NO Heart Rate
Reading or Long Response Time
.
1) Cause:
Solution:
2) Cause:
3) Cause:
Solution:
[HR1].
Dry skin.
Apply conductive gel or saliva thoroughly to
fingers and the wrist area. (Even water will help if
conductive gel is not available).
Fingers are not placed firmly over the sensors.
Muscle tremors, caused by:
A) Pressing down too hard on the sensors with
fingertips. B) Person is in motion and hold the watch
in an awkward manner.
It is best to place your index finger on
the ''front'' contact This will ensure good and
Solution: Make sure fingers (not the tips) lay flat and
firmly over the sensors and the watch is placed
securely on the wrist. Do not use the very tips of your
fingers (e.g. visualize tip toeing with your fingertips).
Fingertips do not allow for enough contact, therefore,
electrocardiogram will not be picked up.
consistent readings even while walking or jogging
with arms swung naturally.
4) Cause:
Solution:
5) Cause:
Solution:
[HR2]
6) Cause:
Solution:
7) Cause:
Solution:
Dead skin on the wrist.
Usually rubbing your skin with a towel will
help.
A thin layer of body grease can
the back sensor on the
watch.
Wipe the wrist and the back of watch
with a tissue or a soft towel.
Hairy arms.
Apply conductive gel to the wrist area.
Irregular heart beats.
N/A
It is difficult to consistently pick up a reading for those
with irregular heart beats.
Inconsistent response times are expected for those
with arrhythmia.
insulate the
electrocardiogram signal from
10.0 Precautions for Water Resistance
& Battery
Water Resistance
Water damage may occur if the push buttons are pressed
under water. Should water or condensation appear in the
watch, please check the watch immediately, as corrosion of
electronic parts can occur inside the case.
The battery in your SOLUS watch is estimated to last for 2
years, depending on frequency and use of certain features.
If the display dims or the EL backlight is dim, you are
recommended to go to the authorized SOLUS service center
for correct battery replacement and power on set in order
to retain a valid warranty and avoid any damage on the water
resistance function.
Always keep watch batteries away from children. If
swallowed, contact a doctor immediately. Batteries contain
chemical substances. They should be disposed of properly
according to local regulations.
Batter y Life
Batter y Replacement
WARNING!
NOTE: MUST "zone alert on/off",
"below zone limit" "upper zone limit"
5.0.
The user input the
& into the watch,
please refer to chapter When zone alert is on,
there are three possible results:
Bi-Bi will be heard for below zone.
No sound will be heard for in zone.
Bi-Bi-Bi will be heard for above zone.
4

5.0 Setting the Current Time
& Heart Rate Zone Alert
3.1 Design of the Watch 4.0 Functional Modes & Displays
[HR1]:
[HR1]
Heart Rate Mode
Sensor 1
to enter
.
Hold
[HR2]: Sensor 2
When you wear the watch,
the sensor will be activated.
[M]:
.
[M]
.
Mode Button
Press to change modes
to enter/exit
the setting display
In the setting display, press
to select the next item.
Hold
[EL]: Light Button
Press to turn ON
the EL backlight
for about 3 seconds.
[S]: Setup Button
Press to toggle items,
Hold [S] to confirm items.
Time Date Daily Alarm
[M]
Two alternative displays
in Current Time Mode
[S]:
[S]:
Toggle second/
day of week display
Hold Confirm second/
day of week display
SEC DOW
During , hold for 4 seconds
to enter , LCD will be off
Press any buttons to resume normal.
Date Mode [M]
Power Saving Mode .
4.1 Power Saving Mode
3.0 Specifications
Current Time Mode
Hour, minute and second
12 / 24 hour format selectable
Hourly chime on the hours
Current Date Mode
Daily Alarm Mode
Month and date
Daily alarm: 1 daily alarm
Alarm duration: about 30
seconds
Heart Rate Mode
Others
Measuring range: 30 to 240
beats per minute
5 ATM water resistance
Electro-luminescent backlight
*Water-related usage for 5 ATM:
Light spray perspiration, light rain,
bathing, etc
*The illumination provided by the
backlight may be hard to see when viewed
under direct sunlight
WWW.SOLUSWATCH.COM
[M] SEC MINUTE HOUR
DATE FORMAT DAY MONTH YEAR
12/24 HOUR BEEP ON/OFF
BELOW ZONE
ZONE ALERT ON/OFF
[M]
ABOVE ZONE
Time Mode
Hold to switch to the setting display,
the display will start flashing.
Press or to adjust,
then press to confirm.
Hold anytime to exit
the setting display.
[M]
[U] [D]
[M]
[M]
[M]
[M]
[M] [M]
[M]
[M]
[M]
[M]
[M]
[M][M]
hold
[M] [M]
1.0 General Guide
Thank you for purchasing this watch. With this watch, you can get
electrocardiogram heart rate without using a chest strap.
Simply put the watch on your wrist, place your finger on the metal
contact located on the face of the watch, and read your heart rate in
the digital window within seconds!
Do not use this watch for commercial or professional purposes.
Make sure that you read this user manual thoroughly and fully
understand the functions and limitations of this watch before using
it. This watch is a supplementary device for measuring heart
rate; it is not a substitute for medical devices. You should
periodically compare the heart rate reading acquired by this watch
with the reading from your doctor. Do not use heart rate
measurement under water.
This watch contains electronic components. Never attempt to
open the case or remove the back cover. Avoid exposing the
watch to extreme temperature, chemicals which will damage the
watch. Keep the watch away from the conditions of strong
electric field and static electricity. Avoid rough usage or severe
IMPORTANT Notes
1)
2)
3)
4)
2.0 Care and Maintenance
1)
2)
3)
4)
impact. The watch is designed to withstand impact under normal use. It
is advisable to subject it to severe impact or rough usage.
5)
6)
7)
8)
Clean your watch occasionally with a soft moistened cloth only.
Avoid using chemicals, especially soap as the waterproof gasket will
corrode. For PU straps, please wash them with mild soapy water
only and not to apply perfume or moisturizers around your wrist as the
chemicals can erode them. There may be discoloration for light
colors and transparent straps after normal wear for some time. An
original replacement on straps is possible to be re-ordered through an
authorized service center. Store the watch in a dry place when it is
not in use.