
Welcome to Alive with the BioSignals HS
Connect the Sensors to your HS
1) Attach the grey soft rubber finger sensor to the HEART
port on the HS.
2) Attach the black and white pair of skin conductance
sensors to the SKIN port on the HS.
3) Attach the BioSignals HS to its USB extension cord.
4) Attach USB extension cord to your computer. Wait for 30 seconds or more after attaching the
BioSignals HS to your computer before opening Alive.
5) Open Alive 3.2 or later. If Alive doesn’t find your BioSignals sensor, wait for one
minute for BioSignals to finish its automatic setup, then open Alive again.
Connect the Sensors to You
1) Place the rubber heart rate sensor on
the middle finger of your non-dominant
hand. The cable should be on the
top (fingernail side) of your finger.
The cable should extend from your
fingertip in the direction of your
wrist. If the rubber heart rate sensor
feels too tight, you can place it on your
pinky or move your fingertip slightly
back out of the tight end of the sensor.
2) Place the black Velcro skin
conductance sensors on your
index and ring fingers of your non-
dominant hand. The metal disks
should be on the pads (underside) of
your fingertips.