SOMFY Irismo User manual

Copyright © 4/2019 Somfy Systems Inc./SAS. All rights reserved
Irismo Enclosure Installation
Somfy P/N - 9021132
Tools Required:
•Torx T-9 Bit (For original motor screws)
•Torx T-10 Bit (For replacement screws)
Kit Includes:
•ABS Plastic Enclosure (Top and Bottom Halves)
•Snap-Together Velcro
•(2) M3 x 25 T-10 Torx Screws
Installation:
1. Using a T-9 screwdriver, remove the (2) Torx screws near the modular jack as
shown below:

Copyright © 4/2019 Somfy Systems Inc./SAS. All rights reserved
2. Take the bottom half of the enclosure and using a T-10 screwdriver, fasten to
Irismo via (2) M3 x 25 screws until snug.
3. Take Snap-Together Velcro and stick one side to the raised rectangle. Press and
hold Velcro for a few seconds to ensure good adhesion.

Copyright © 4/2019 Somfy Systems Inc./SAS. All rights reserved
4. The Irismo Enclosure is designed to house 3 different interface cards:
•SDN (P/N: 1811129) Zigbee (P/N: 1870221) & Z-Wave (P/N: 1870228)
4a. SDN Card Installation
•Insert the RJ-12 plug into the motor and remove the Velcro adhesive backing.
•Center card inside enclosure as shown below:
IMPORTANT Don’t
go past this edge!
Make sure RJ-45 jack is
centered with power plug
Remove adhesive
backing

Copyright © 4/2019 Somfy Systems Inc./SAS. All rights reserved
4b. Zigbee Card
•Insert the RJ-12 plug into the motor and remove the Velcro adhesive backing:
•Center card inside enclosure as shown below:
Remove adhesive
backing
IMPORTANT Don’t
go past this edge!

Copyright © 4/2019 Somfy Systems Inc./SAS. All rights reserved
4c. Z-Wave Card
•Insert the RJ-12 plug into the motor and remove the adhesive backing:
•Center card inside enclosure as shown below:
Remove adhesive
backing
IMPORTANT Don’t
go past this edge!

Copyright © 4/2019 Somfy Systems Inc./SAS. All rights reserved
5. Attach the top by squeezing and aligning the hooks with the slots:
Installation is complete!
Squeeze here