Sony BVP-570 User manual

COLOR VIDEO CAMERA
BVP-570
BVP-570WSPK
MAINTENANCE MANUAL
1st Edition (Revised 1)
Serial No. 15001 and Higher: BVP-570
Serial No. 55001 and Higher: BVP-570WSPK

!WARNING
This manual is intended for qualified service personnel only.
To reduce the risk of electric shock, fire or injury, do not perform any servicing other than that
contained in the operating instructions unless you are qualified to do so. Refer all servicing to
qualified service personnel.
!WARNUNG
DieAnleitung ist nur für qualifiziertes Fachpersonal bestimmt.
Alle Wartungsarbeiten dürfen nur von qualifiziertem Fachpersonal ausgeführt werden. Um die
Gefahr eines elektrischen Schlages, Feuergefahr und Verletzungen zu vermeiden, sind bei
Wartungsarbeiten strikt dieAngaben in der Anleitung zu befolgen. Andere als die angegeben
Wartungsarbeiten dürfen nur von Personen ausgeführt werden, die eine spezielle Befähigung
dazu besitzen.
!AVERTISSEMENT
Ce manual est destiné uniquement aux personnes compétentes en charge de l’entretien.Afin
de réduire les risques de décharge électrique, d’incendie ou de blessure n’effectuer que les
réparations indiquées dans le mode d’emploi à moins d’être qualifié pour en effectuer d’autres.
Pour toute réparation faire appel à une personne compétente uniquement.

1 (P)
CAUTION
Danger of explosion if battery is incorrectly
replaced.
Replace only with the same or equivalent type
recommended by the manufacturer.
Dispose of used batteries according to the
manufacturer’s instructions.
Vorsicht!
Explosionsgefahr bei unsachgemäßem
Austausch der Batterie.
Ersatz nur durch denselben oder einen vom
Hersteller empfohlenen ähnlichen Typ.
Entsorgung gebrauchter Batterien nach Angaben
des Herstellers.
ATTENTION
Il y a danger d’explosion s’il y a remplacement
incorrect de la batterie.
Remplacer uniquement avec une batterie du
même type ou d’un type équivalent recommandé
par le constructeur.
Mettre au rebut les batteries usagées
conformément aux instructions du fabricant.
ADVARSEL!
Lithiumbatteri-Eksplosionsfare ved fejlagtig
håndtering.
Udskiftning må kun ske med batteri
af samme fabrikat og type.
Levér det brugte batteri tilbage til leverandøren.
Voor de klanten in Nederland
Dit apparaat bevat een MnO2-Li batterij voor memory
back-up.
Raadpleeg uw leverancier over de verwijdering van de
batterij op het moment dat u het apparaat bij einde
levensduur afdankt.
Gooi de batterij niet weg. maar lever hem in als KCA.
Bij dit produkt zijn batterijen geleverd.
Wanneer deze leeg zijn, moet u ze niet
weggooien maar inleveren als KCA.

1 (E)
BVP-570
Table of Contents
Manual Structure
Purpose of this manual ........................................................................................ 7 (E)
Contents ............................................................................................................... 7 (E)
Relative manuals ................................................................................................. 8 (E)
1. Installation
1-1. Checking ROM Version........................................................................1-1 (E)
1-2. Connector Input/Output Signals............................................................1-1 (E)
1-3. Connection Connector...........................................................................1-6 (E)
1-4. Installation Conditions ..........................................................................1-6 (E)
1-5. Function of Internal Switches/Control ..................................................1-6 (E)
1-6. Instance of System Configuration.........................................................1-8 (E)
1-7. Optional Accessories for Viewfinder..................................................1-11 (E)
1-8. 16:9/4:3 Selector Board.......................................................................1-11 (E)
2. Service Overview
2-1. Note on Service .....................................................................................2-1 (E)
2-1-1. Standard Tightening Torque for Screws ..............................2-1 (E)
2-1-2. Description on Backup Battery ............................................2-1 (E)
2-1-3. Note on Replacement of Flash Memory ..............................2-2 (E)
2-1-4. Resetting Adjustment and Setting Values............................2-2 (E)
2-1-5. Notes on Spare Parts ............................................................2-3 (E)
2-2. Removing the Side Panels.....................................................................2-4 (E)
2-3. Location of Printed Wiring Boards .......................................................2-4 (E)
2-4. Circuit Description ................................................................................2-5 (E)
2-5. Recommended Replacement Parts........................................................2-9 (E)
2-6. Cleaning ..............................................................................................2-10 (E)
2-6-1. Cleaning Viewfinder (Option) ...........................................2-10 (E)
2-6-2. Cares after Using at Special Environment .........................2-11 (E)
2-7. Disconnecting/Connecting the Flexible Card Wire ............................2-12 (E)
2-8. Removing the V Shoe Bracket............................................................2-13 (E)
2-9. Replacing External Connectors...........................................................2-13 (E)
2-9-1. VF Connector .....................................................................2-13 (E)
2-9-2. MIC Connector...................................................................2-13 (E)
2-9-3. LENS Connector ................................................................2-14 (E)
2-9-4. TEST OUT/REMOTE Connectors ....................................2-14 (E)
2-9-5. 68P Connector ....................................................................2-15 (E)

2 (E) BVP-570
2-10. Replacing Printed Wiring Board .........................................................2-16 (E)
2-10-1. Description on EEPROM Data ..........................................2-16 (E)
2-10-2. Adjusting Items Required After Replacing the Board .......2-16 (E)
2-10-3. Replacing the MB-602 Board ............................................2-17 (E)
2-11. Replacing Function Switches ..............................................................2-18 (E)
2-11-1. Side Switch Panel Block ....................................................2-18 (E)
2-11-2. Front Switch Panel Block...................................................2-18 (E)
2-11-3. VF DISP Switch .................................................................2-19 (E)
2-12. Replacing MENU SEL Knob (Rotary Encoder) .................................2-20 (E)
2-13. Replacing DC/DC Convertor Unit ......................................................2-21 (E)
2-14. Optional Fixtures List .........................................................................2-22 (E)
3. Setup Menu
3-1. Setup Menu ...........................................................................................3-1 (E)
3-1-1. Operation Menu ...................................................................3-3 (E)
3-1-2. Paint Menu ...........................................................................3-7 (E)
3-1-3. Maintenance Menu .............................................................3-11 (E)
3-1-4. Reference File Menu ..........................................................3-14 (E)
3-1-5. Trimming File Menu ..........................................................3-14 (E)
3-1-6. System Config Menu..........................................................3-15 (E)
3-2. Self-Diagnosis .....................................................................................3-20 (E)
4. Electrical Alignment for OHB Installation
4-1. Preparation ............................................................................................4-1 (E)
4-1-1. Equipment Required.............................................................4-1 (E)
4-1-2. Notes on Adjustment ............................................................4-1 (E)
4-1-3. Maintaining the Grayscale Chart .........................................4-2 (E)
4-1-4. Connections ..........................................................................4-3 (E)
4-1-5. Description on Setup Menu ..................................................4-4 (E)
4-1-6. Initial Setting ........................................................................4-5 (E)
4-2. VCO CONT Frequency Confirmation ..................................................4-6 (E)
4-3. VA Gain Adjustment.............................................................................4-6 (E)
4-4. Black Shading Adjustment....................................................................4-8 (E)
4-5. White Shading Adjustment .................................................................4-10 (E)
4-6. Master Black Adjustment....................................................................4-11 (E)
4-7. Gamma Correction Adjustment ..........................................................4-11 (E)
4-8. Flare Adjustment .................................................................................4-13 (E)
4-9. Knee and White Clip Adjustment .......................................................4-14 (E)
4-10. Crispening Adjustment........................................................................4-15 (E)
4-11. Level Dependent Adjustment..............................................................4-16 (E)
4-12. Detail Frequency Adjustment .............................................................4-17 (E)
4-13. H/V Ratio Adjustment.........................................................................4-18 (E)

3 (E)
BVP-570
4-14. Detail Level Adjustment .....................................................................4-19 (E)
4-15. Detail Clip Adjustment .......................................................................4-19 (E)
4-16. Skin Tone Adjustment.........................................................................4-20 (E)
4-17. Zebra Adjustment................................................................................4-22 (E)
4-18. Auto Iris Adjustment...........................................................................4-23 (E)
4-19. Menu Settings After Finishing Adjustment ........................................4-24 (E)
4-20. File Store .............................................................................................4-24 (E)
5. Overall Electrical Alignment
5-1. Preparation ............................................................................................5-1 (E)
5-1-1. Equipment Required.............................................................5-1 (E)
5-1-2. Notes on Adjustment............................................................5-1 (E)
5-1-3. Maintaining the Grayscale Chart .........................................5-2 (E)
5-1-4. Connections..........................................................................5-4 (E)
5-1-5. Description on Setup Menu..................................................5-5 (E)
5-1-6. Initial Setting ........................................................................5-6 (E)
5-1-7. How to Output Camera Color-Bar Signal ............................5-6 (E)
5-2. VCO CONT Frequency Adjustment.....................................................5-7 (E)
5-3. VTR Y Adjustment ...............................................................................5-8 (E)
5-4. Test Out Adjustment .............................................................................5-9 (E)
5-5. Chroma Adjustment ............................................................................5-10 (E)
5-6. INT SC Phase Adjustment ..................................................................5-11 (E)
5-7. VF Level Adjustment..........................................................................5-12 (E)
5-8. TEST 1 Adjustment.............................................................................5-13 (E)
5-9. TEST 2 Adjustment.............................................................................5-14 (E)
5-10. A/D Gain Adjustment .........................................................................5-14 (E)
5-11. VA Gain Adjustment...........................................................................5-16 (E)
5-12. VA MOD Adjustment .........................................................................5-18 (E)
5-13. Black Shading Adjustment..................................................................5-19 (E)
5-14. White Shading Adjustment .................................................................5-21 (E)
5-15. Master Black Adjustment....................................................................5-22 (E)
5-16. Gamma Correction Adjustment ..........................................................5-23 (E)
5-17. Flare Adjustment.................................................................................5-24 (E)
5-18. Pre Knee Adjustment ..........................................................................5-25 (E)
5-19. Knee and White Clip Adjustment .......................................................5-27 (E)
5-20. A/D Clock Phase Adjustment .............................................................5-29 (E)
5-21. VTR R-Y/B-Y Adjustment .................................................................5-30 (E)
5-22. CCU Y/R-Y/B-Y Adjustment .............................................................5-31 (E)
5-23. RGB Adjustment.................................................................................5-32 (E)
5-24. Menu Setting After Finishing Adjustment..........................................5-33 (E)

4 (E) BVP-570
6. Spare Parts
6-1. Hardware List ..............................................................................................6-1
6-2. Exploded Views ..........................................................................................6-2
6-3. Electrical Parts List ...................................................................................6-10
6-4. Optional Fixtures.......................................................................................6-44
7. Semiconductor Pin Assignments
8. Block Diagrams
Block Diagram Index ..................................................................................8-1
Overall .........................................................................................................8-2
VA-163A .....................................................................................................8-4
AT-126 ........................................................................................................8-5
SG-234 ........................................................................................................8-6
DA-88A .......................................................................................................8-7
IF-510 ..........................................................................................................8-8
PR-242.......................................................................................................8-10
9. Schematic Diagrams
Schematic Diagram Index ...........................................................................9-1
VA-163A .....................................................................................................9-2
AT-126 ........................................................................................................9-7
SG-234 ......................................................................................................9-10
DA-88A .....................................................................................................9-14
IF-510 ........................................................................................................9-18
PR-242.......................................................................................................9-20
PR-243.......................................................................................................9-27
CN-1120 ....................................................................................................9-28
CN-1121 ....................................................................................................9-29
MB-602 .....................................................................................................9-30
Frame.........................................................................................................9-32

5 (E)
BVP-570
10. Board Layouts
VA-163A...................................................................................................10-1
AT-126 ......................................................................................................10-3
SG-234 ......................................................................................................10-5
DA-88A.....................................................................................................10-7
IF-510........................................................................................................10-9
PR-243.....................................................................................................10-10
PR-242.....................................................................................................10-10
MB-602 ...................................................................................................10-13
CN-1120..................................................................................................10-15
CN-1121..................................................................................................10-15
CN-1122..................................................................................................10-15
CN-1504..................................................................................................10-15
CN-1672..................................................................................................10-15
SW-730 ...................................................................................................10-17
SW-731 ...................................................................................................10-17
SW-732 ...................................................................................................10-17
SW-733 ...................................................................................................10-17
SW-742 ...................................................................................................10-17