Sony VAIO PCG-K Series Guide

PCG-K Series Hard Disk Drive
Replacement Instructions
P/N T99860098 Rev. D 1/2
Step 3. Using the enclosed
magnetic screwdriver, remove
the marked screw and set
aside.
Step 1.To prevent any kind of cosmetic
damages and scratches, place your PC upside
down on top of a soft surface, with the ports
facing you.
Step 2. CAUTION!
Disconnect the power cord and
remove the battery. Failure to
do so can result in damage to
the PC.
These easy instructions are intended to guide you through the replacement process.
9To avoid electric shock please make sure product is turned off and AC Adaptor is disconnected
from the power source. Remove jewelry before you begin work to avoid scratching the surface of
your notebook computer.*
9Place your notebook computer on a clean, stable and covered surface to avoid damage to the
computer's case.*
9Follow the ESD (Electrostatic Discharge) damage prevention instructions:
oHold parts by the edges, away from exposed circuitry when possible.
oDo not walk around excessively as this promotes static build-up.
9The appearance of the electronic components shown in the illustrations may be different from the
components shipped. This slight difference does not affect the accuracy of these instructions.
* Sony is not responsible for any loss of data associated with your computer or any damage caused by
incorrect handling of the computer under these procedures. The terms of your Sony Limited Warranty
continue to apply.
IMPORTANT!
PLEASE READ BEFORE YOU START

PCG-K Series Hard Disk Drive
Replacement Instructions
P/N T99860098 Rev. D 2/2
Step 7. Gently remove the drive as shown. CAUTION! Be
careful not to lift the drive before releasing the pins from the
socket as instructed in Step 6!
Step 8. Place the new drive flat in the opening. Slide the drive
into position in the direction of the arrows, as shown above. Make
sure both rows of pins have been inserted into the socket.
Step 4. Remove hard
drive access door as
shown and set aside.
Step 9.Using the
enclosed magnetic
screwdriver, reinstall the
four (4) previously
removed screws.
CAUTION! Be careful
not to drop screws into
the unit, and be careful
to use the correct
screws, as shown in the
picture. Do not over
tighten the screws!
Step 10. Reinstall the
hard drive access door and
screw. Power on your
computer and continue with
the recovery process by
following the instructions
described on the back of the
recovery disk’s case.
Return the old HDD Bay to
Sony following the included
shipping instructions.
Step 6. Gently slide the drive in
the direction of the arrows to
release the pins from the socket.
X
Step 5. Using the enclosed magnetic screwdriver, remove
the four (4) screws as indicated in the picture. CAUTION! Be
careful not to drop screws into the unit.