Sony PS3 INFIMOD User manual

PS3 INFIMOD Installation Manual
Installation time 10-15 minutes.
INFIMOD includes electronic board and cable.

Unscrew 5 screws.

Open first back side of t e controller. If you ave any
problems opening your controller t en on YouTube you can
find many videos wit explanations ow to do it. Searc for
”disassemble a ps3 controller”.

Opened controller. Gray piece is t e battery.

Disconnect battery from t e green board. Try to old w ite
connector and don't pull t e wires.

Unscrew additional screw.

Lift t e board.

Place t e original board like on t e picture.

Now we need to lift t e PCB(prinetd circuit board) of t e
buttons. Insert screwdriver as s own on t e picture.

Lift rig t side up.

T en wit t e elp of twizzers or your finger pus left side of
t e board as s own on t e picture.

Wit t e elp of screwdriver lift left side of t e board.

Bot sides are lifted. Under t e board you will see black
cus ion.

Remove t is cus ion and put to t e side.

T is picture s ows t e cus ion on t e left side and s aped
plastick t at was under t e cus ion.

Wit t e elp of t e tweezers (included in t e kit) put w ite
rectangular piece of paper as s own on t e next picture.

W ite rectangular piece of paper is placed.

Place black cus ion above w ite piece of paper. Please
note: smoot surface of t e cus ion must be at t e top.

Black cus ion is placed. Please note: place t e cus ion in
t e center between two pins.

Return back clear PCB. Put w ite plastic pins t ru t e clear
PCB oles.