SORINEX P3 Poor Man Glute Ham Developer User manual

ASSEMBLY INSTRUCTIONS
SORINEX.COM|1 of 3
P3 Poor Man Glute Ham
Developer
ASSEMBLY INSTRUCTIONS
DISCLAIMER:
RESISTANCE TRAINING, GYMNASTICS TRAINING, AND ACTIVITIES AT
HEIGHT ARE POTENTIALLY DANGEROUS AND MAY LEAD TO SEVERE INJURY
OR EVEN DEATH. THIS EQUIPMENT MUST BE USED BY COMPETENT AND
RESPONSIBLE PERSONS OR UNDER THE GUIDANCE AND SUPERVISION OF
COMPETENT PERSONS. BE SURE YOU ARE VERSED IN PROPER
TECHNIQUE AND METHODS BEFORE USING ANY EQUIPMENT. THE
USER ASSUMES ALL RISKS AND RESPONSIBILITIES FOR ALL DAMAGE,
INJURY OR DEATH WHICH MAY OCCUR DURING INCORRECT USE OF THIS
EQUIPMENT. SORINEX BEARS NO LIABILITY ABOVE REPLACEMENT VALUE
OF THE EQUIPMENT IN QUESTION.
Sorinex Exercise Equipment | 193 Litton Drive | Lexington, SC 29073 | 1-877-SORINEX | [e-mail]
THE INFORMATION CONTAINED IN THIS DRAWING IS THE SOLE PROPERTY OF SORINEX INC.
ANY REPRODUCTION IN PART OR AS A WHOLE WITHOUT THE WRITTEN PERMISSION OF SORINEX INC. IS PROHIBITED.
Align Foot Connector with Right Side Bracket. As Shown. Secure hardware with 3/4” wrench.
Tools needed:
1/2” wrench
3/4” wrench
3/16” allen wrench
1. 2.
Item Number

ASSEMBLY INSTRUCTIONS
SORINEX.COM|2 of 3
Sorinex Exercise Equipment | 193 Litton Drive | Lexington, SC 29073 | 1-877-SORINEX | [e-mail]
THE INFORMATION CONTAINED IN THIS DRAWING IS THE SOLE PROPERTY OF SORINEX INC.
ANY REPRODUCTION IN PART OR AS A WHOLE WITHOUT THE WRITTEN PERMISSION OF SORINEX INC. IS PROHIBITED.
Align both Crossbars as shown and secure with hardware. Repeat steps to secure Left Side Bracket.
Align Foot Plate to Foot Connector. Wheels should face
outward.
Secure with hardware.
Align Tower to Foot Connector, as shown. Tower adjustment
holes should face inward.
With 3/4” wrench secure Tower with hardware.
3. 4.
5. 6.
7. 8.

ASSEMBLY INSTRUCTIONS
SORINEX.COM|3 of 3
Sorinex Exercise Equipment | 193 Litton Drive | Lexington, SC 29073 | 1-877-SORINEX | [e-mail]
THE INFORMATION CONTAINED IN THIS DRAWING IS THE SOLE PROPERTY OF SORINEX INC.
ANY REPRODUCTION IN PART OR AS A WHOLE WITHOUT THE WRITTEN PERMISSION OF SORINEX INC. IS PROHIBITED.
Align the Split Shaft Collar onto the Handle so that it is flush
to one side of the bar. Secure with 3/16” allen wrench.
Align Handle and secured Collar through the Left and Right
Side Bracket holes. Secure other side with Spit Shaft Collar.
Align Pad to Left and Right Side Bracket. As shown. Make sure
Pad sits flush and does not rest against Tower.
Use 1/2” wrench to secure hardware to Pad.
Attach Adjustable Roller Pad by pulling Pop Pin and aligning
onto Tower. Adjust as desired.
P3 Poor Man Glute Ham Developer is fully assembled and
ready to use.
9. 10.
11. 12.
13. 14.