Southco TP35AHT User manual
TP35AHT tool instruction manual
(pre-adjustment before use)
Native Orbit File: TP35AHT_tool_instruction_manual_revA
TP35AHT tool instruction manual (pre-adjustment before use)
For smaller panel gap
For wider panel gap
Close position
Close position
Open position
Open position
The lock nut must be moved from the top side to the bottom side to accommodate a panel gap
wider than 3mm.
Lock Nut
position
Available
Panel
thickness
Available product Remarks
Upper
1.63mm PFSC 35-38A These parts are for use
with receptacles PR35,
PR35-1, PRB35 and
PR35. For other
receptacles, refer to
Southco.
1.88mm PFSC 35-39A
2.13mm PFSC 35-40A
2.39mm PFSC 35-41A
2.64mm PFSC 35-42A
Lower 2.90mm PFSC 35-43A
3.18mm PFSC 35-44A
With the tool closed, use a
screwdriver to adjust the plunger
to ensure that the cup shall be
flared
Place stud assembly into the cup
nest Place panel over the stud assembly
Ensure the cup of the assembly
protrudes through the panel
Cup nest
Cup
Ensure the flare of the cup
protrudes through the panel
Apply pressure by squeezing the
tool trigger. The cup flares over
and fixes the stud assembly to the
panel
Panel
Flare
Flare of cup
