Spa Electrics LV100Q-12 User manual

INSTALLATION GUIDE
FOR ASSISTANCE PLEASE
CONTACT SPA ELECTRICS
ph: [phone]
[e-mail]
www.spaelectrics.com.au
INSTALLATION
LV100Q-12
LOW VOLTAGE TRANSFORMER
Fasten the transformer mounting
bracket to the wall. The transformer
can then be mounted onto the
bracket.
CABLE TERMINATION
Ensure that the unit is installed at least
3.5 metres away from the pool and/or
spa and at a minimum of 500mm above
ground level.
The LV100Q-12 transformer has 4 outputs,
each with a pair of terminals. Each cable core
should be terminated as follows:
2. Place one of the stripped ends of the cable on
top of the terminal bolt. Tighten the clamp
plate and screw on top of the cable end to
secure it in place. As the Transformer outputs
AC power the cable orientation is not
important.
1. Loosen the terminal screw and clamp plate
from the terminal bolt. (These parts are joined
and will loosen together). You do not need to
fully remove the screw and clamp plate, only
loosen.
Do not remove the plug. This equipment MUST be
plugged into a protected outlet installed by an
Electrician.
Spa Electrics recommends the use of an Electrical
Contractor or Pool Technician for connection of the Pool
Light to the Transformer.
For the second cable core, repeat these steps
on the adjacent terminal.

INSTALLATION GUIDE
TRANSFORMER RATING
Input: 230-240VAC ~ 50Hz
Output: 4 X 25W 12VAC ~ 50Hz switched
Auxilary GPO: 230-240VAC ~ 50hz 10amp Max Total
IP Rating: IP44
TECHNICAL SPECIFICATION
FOR ASSISTANCE PLEASE
CONTACT SPA ELECTRICS
ph: [phone]
[e-mail]
www.spaelectrics.com.au
20231023
LV100Q-12
LOW VOLTAGE TRANSFORMER
CHECKING THE FUSE
The LV100Q-12 transformer includes 4 x 3amp
blade fuses, one for each output. The fuse is
designed to protect the transformer and light
cable from shorts & over loading, which may
lead to the premature replacement of the
transformer.
The following steps show how to check if your
transformer fuse has blown:
1. Turn power off to the transformer.
2. Remove the fuse, the fuse may be held firmly
in the fuse holder, if so it may be necessary to
use a pair of needle nose pliers to gently
remove the fuse.
3. Check the center of the fuse for breaks. If the
fuse has blown, first check all cable
connections for shorts before replacing the
fuse.
Note: Spa Electrics uses generic blade fuses,
which can be purchased from any quality auto
parts/Electrical retailer.
CONDITION PROBABLE CAUSE REMEDY
GOOD BAD
No Output Power No Input Power Check that LED Power light is illuminated. If this LED light is not
illuminated, there is no power from the GPO to the transformer.
If power is available at GPO and the LED is illuminated,
contact Spa Electrics for further assistance.
Blown Fuse Check fuse,
if the fuse has blown, first check all cable connections
for shorts before replacing the fuse.
If fuse wire is intact, contact Spa Electrics for further assistance.
TROUBLE SHOOTING
FUSE & OUTPUT OPTIONS
1 x 100W Output on 1 terminal only:
1 x 15A 12VAC Blade Fuse
4 x 25W Outputs using 4 terminals:
4 x 3A 12VAC Blade Fuse