SpeedEPart 45-0587 User manual

PRINTED IN USA FORM NO. 3-154 (10/13/21)
45-0587 / 45-0588
15 / 25 GALLON SPRAYER

2
1
2
3
4
5
ST43243
BA19478
ST44021
ST43585
A
6x
B
6x
C
4x
D
2x
E
2x
F
2x
H
2x
G
1x
J
1x
K
1x
L
1x
I
1x
ST65007
ST65008
ST43233
ST43468
ST43623
ST43244
ST43483
ST43472
ST43155
ST43156
ST65075
ST65012

3
D4
EF
3
2
M
1
5
6
B
G
A
J
3
K
3
1
C
C
H
4
A
B
5
3
1
45-0588 Only

4
IL
7 8
ENGLISH
SAFETY
1. Read this owners manual and the vehicle owners manual before
using this sprayer.
2. Never allow children to operate this sprayer.
3. Do not allow anyone to ride on or sit on this sprayer.
4. Keep the area clear of all persons, especially small children.
5. Read the chemical label before handling or mixing chemicals.
6. Wear eye and hand protection and protective clothing when
handling and applying lawn chemicals.
7. Do not spray on windy days.
8. Be aware of your tractor's capabilities. Attaching this sprayer may
a󰀨ect your tractor's braking and stability.
9. STAY OFF STEEP SLOPES. Refer to the vehicle owner's manual
concerning safe operation on slopes.
10. Operate at reduced speed on rough terrain, along ditches and on
hillsides to prevent loss of control.
ASSEMBLY
The meanings of symbols used in the illustrations are as follows:
Do not tighten yet. Tighten now.
OPERATION
CAUTION: Connect to a 12 V battery only.
PUMP PRESSURE SWITCH
The pump pressure switch turns o󰀨 the pump when it reaches
its maximum pressure setting. Very low ow demand may cause
the switch to rapidly cycle the pump on and o󰀨. Rapid on and o󰀨
cycling must be limited to no more than 6 times per minute. Cycling
could cause the motor to heat beyond the recommended maximum
temperature and reduce the operational life of the pump and pressure
switch.
SPRAYER CONTROLS
Boom ON-OFF valve shuts o󰀨 the ow to the boom nozzles
Recirculation valve adjust spray wand pressure and recirculation of
spray material to the tank.
Boom
Valve
Recirculation
Valve

5
ADJUSTABLE SPRAY GUN NOZZLE
Twisting the nozzle will adjust the spray pattern from a cone shaped
mist to a solid stream.
BEFORE STARTING
1. Attach the sprayer to the tractor hitch.
2. Connect the wire harness from the switch to the pump.
3. Check for leaks using plain water. Fix leaking ttings with thread
tape.USING THE SPRAYER
CAUTION: Wear eye and hand protection and protective
clothing when handling and working with lawn chemicals.
1. Determine the application rate (gallons per 1,000 sq. feet) based on
the chemical manufacturers recommendations.
2. Estimate the size of the area to be sprayed and the amount of
solution that will be needed. This can help avoid unneeded solution
left in the tank.
3. Refer to the application chart below to help determine the speed
required to achieve the manufacturers recommended application
rate.
4. Use plain water to set the correct boom spraying pressure. Turn the
boom valve to the "ON" position. If misting occurs, gradually start
closing the valve until misting stops.
5. Add the chemical solution to the tank, following the manufacturers
recommendations.
6. Unfold Boom arms (25 gallon model only). Check height of spray
tips to ground (A) is approximately 17" (43 cm). If necessary, adjust
boom height by raising or lower the boom on the threaded boom
supports (B).
7. Begin spraying, making each pass so that the spray pattern slightly
overlaps the spray pattern from the previous pass.
8. Stay clear of owers, shrubs and evergreen trees when spraying to
prevent contact of the solution with these sensitive plants.
APPLICATION CHART
Sprayer Tip Size PSI GMP One Nozzle
25 Gallon TP11008VP 30 0.69
15 Gallon 35 0.75
Sprayer Gallons per 1000 Sq. Ft.
2 mph 3 mph 4 mph 5 mph 6 mph
25 Gallon 1.57 1.05 0.78 0.63 0.52
15 Gallon 1.7 1.13 0.85 0.68 0.57
USING THE SPRAY GUN
1. Shut o󰀨 the boom by turning the boom valve to "OFF".
SPRAYER RECIRCULATION
1. The sprayer is equipped with a recirculation valve to aid in material
agitation and pressure control.
2. This valve is in the “open” position when the valve handle is in line
with the hose (pictured), “closed” when perpendicular to the hose.
3. Adjusting the recirculation valve between the open/closed positions
will a󰀨ect the pressure coming through the spray wand only.
4. Closed position is full pressure through spray wand or boom.
5. It may be helpful to adjust the pressure when spraying with the
spray wand to avoid damage to plants from excess pressure.
6. This valve should be in the “closed” position when operating the
boom.
MAINTENANCE
AFTER EACH USE
1. Fill the sprayer part way with water and pump the water out through
the boom assembly and the handgun. Use the handgun to wash
the inside of the tank.
2. Rell the tank about half full with water and a chemical neutralizer
solution and repeat the cleaning instructions above. Follow the
manufacturers instructions for disposal of all chemicals.
AS NEEDED
1. Periodically clean the tank strainer on the end of the intake hose.
Remove the nylon swivel nut from the hose, pull out the screen and
ush it with water.
2. Periodically clean the strainers in the boom nozzles. Remove the
nozzle, pull out the screen and ush it with water.
WINTER STORAGE
1. Drain all water out of the sprayer, especially the pump and
handgun. These items are prone to damage from freezing
temperatures.
2. Winterize the sprayer by pumping a 50-50 solution of water and
R. V. antifreeze through the boom assembly and the hand gun.
A
B