splashback 781JJ User manual

How to install
glass splashbacks
What you need
Before you start
Easy to apply
STANDARD INSTALLATION
PEEL, STICK & SEAL
Tape Measure
Check that your splashback
fits into the required space.
Your splashback must be at
least 110mm away from the
nearest heat source.
Make sure all corners are safe from
hard surfaces. Take care to peel off
the protective film back and not
the self-adhesive backing.
Place the bottom edge of the
splashback to the rear of the hob.
Push it to the wall and apply firm
even pressure with the cloth.
Using the Silicone Sealant.
No more than 2.5mm in thickness.
Our splashbacks
are made from
toughened safety
glass so they
cannot be cut.
Check the surface
is perfectly flat,
non-porous, dry
and dust free.
Splashback to
go here
Silicone Sealant -
Low Modulus Type
Sealant Gun Clean Cloth 1 x Splashback
1
Peel off backing
1Stick on the wall 2Seal the edges 3
2
3
110mm

Health & Safety
Aftercare
WARNING!
SAFE HANDLING GLASS
IMPORTANT
All products are supplied with a safety backing but we recommend that the glass is handled with care and in particular eye protection
and suitable gloves should be worn.
Do not touch the backing once it’s been peeled as contamination can affect the adhesive properties of the backing.
We advise that the product is brought to room temperature over a period of 24 hours if it has been subject to very hot or cold conditions.
Unfitted glass is fragile. Do not place on hard surfaces prior to fitting. Special care should be taken with the corners of the product as
impact will cause the product to shatter.
When cleaning the splashback use hot water and a mild soap detergent. Do not use abrasive cleaners.
Leave the Splashback for at least 45 minutes to cool before wiping, as in extreme cases, applying a cold cloth to a hot
surface can cause the glass to crack/shatter.
Thank you for purchasing this Splashback.
For further information, additional colours and styles,
please visit our website
SPLASHBACK.CO.UK
1
2