Sportplus SP-HRM-BLE-400 User manual

SportPlus
SP-HRM-BLE-400 Manual
Use only Water, ECG gel or other
conductive liquids, in order to
moisten the electrodes.
Device overview
Transmitter
Front view Rear view
Belt
Electrodes
Fixing points
How to wear the heart rate monitor
Important note
Important note
Carrying direction left and right
Battery
compartment
cover
Incorrect heart rate data are
transmitted, if the Device is
aligned in the wrong direction.
Fix them with the clips at both ends.
Fit the strap so that it is neither too
loose or too tight, so that the divice
can measure the correct pulse rate.
Fasten them with the clips at both ends.
Moisten the electrodes as shown in the sketch below.
Attach the transmitter to the belt.
Wear the strap slightly below your
chest. Place the Sensor in the middle
of your body, where the electrodes
are placed against your skin must
be pressed.
Heart Rate Chest Belt

SportPlus
SP-HRM-BLE-400
Customer service:
For technical questions, information on our products and for replacement orders, our service team is available to you as follows:
Service time: Monday to Friday from 9.00 to 18.00 o'clock | service hotline: +49 (0) 40 - 780 896 - 35*
E-mail: [email protected] | URL: www.sportplus.org | Distributor: Latupo GmbH, Stahltwiete 21, 22761 Hamburg, Germany
*National fixed network, call charges depend on your telephone provider / your telephone contract
Declaration of conformity:
We declare that this product is in conformity with the essential requirements
and the other relevant provisions of the RED Directive 2014/53/EU, the EMC Directive
2014/30/EU, the Low Voltage Directive 2014/35/ EU and ROHS 2011/65/EU.
It is strictly forbidden to clean the transmitter and belt in a
washing machine.
Before hand washing the belt, remove the transmitter from
the belt.
When washing the belt, make sure that it is not
hotter than 30°C.
Ironing, bleaching or drying on the heater
is prohibited.
Manual
Supported devices and how to start
Battery change
Note:
Please make sure that the rear
cover is firmly closed to prevent
an unexpected intrusion of water.
Notes!
Supported devices:
The chest strap works with all common uncoded 5.3 kHz receivers. For use with Bluetooth, you need a smartphone
from iPhone 4S (iOS 7.1), or Android from 4.3.
How to start:
The connection with common uncoded 5.3 kHz receivers is automatically and the heart rate is shown on the display.
To do this fasten the chest strap as described above. For use via Bluetooth, please switch on Bluetooth on your
Smartphone. DO NOT connect the chest strap via your Bluetooth menu. The chest strap may only be connected
directly to the respective App. Now open the desired App and connect the chest strap. The compatibility can vary
depending on the operating system. Please ask the publisher of the App in advance.
Detach the transmitter from
the Belt.
Use a coin to unscrew the
battery cover
Remove the battery and
change against a new
battery.
Setzen Sie die hintere
Abdeckung wieder auf das
Gerät.
Note on environmental protection:
From the date of transposition of European Directive 2002/96/EU into national law, the
following applies:
Electrical and electronic equipment must not be disposed of with household waste. The
consumer is legally obliged to return electrical and electronic equipment at the end of
its life to the public collection points set up for this purpose or to the point of sale.
Details are regulated by the respective national law. The symbol on the product, the
instructions for use or the packaging refers to this provision. By recycling, material
recovery or other forms of recovery of old appliances, you make an important
contribution to the protection of our environment. In Germany, the above-mentioned
disposal rules apply accordingly to batteries and accumulators, according to the
Battery Ordinance.
Heart Rate Chest Belt