SportsArt Fitness ANT Plus User manual

ANT+ Display assembly manual
Note For C510 No. 1
Install the Display
Assemble the display (1), water-resistant membrane (2), and display bracket (3) in the order shown
below. Note: In installing the water-resistant membrane, put the rough side up.

ANT+ Display assembly manual
Note For C510 No. 2
Display Placement
Please secure the display to the handlebars as shown below. First, center the display. Then secure
it with screws. If needed, add rubber strips (4) to narrow the gap between the handlebar and the
clamp before securing the bracket.

ANT+ Display assembly manual
Note For C510 No. 3
Transmitter Placement
Use zip ties to loosely secure the transmitter onto one fork of the bike. Align the transmitter with the
magnet on the flywheel. Press the button on the transmitter.An LED will light briefly then extinguish.
With your hand, rotate the flywheel. The LED should light when the magnet aligns with the
transmitter. If the LED does not light or lights twice, the signal is not being received properly. Adjust
the transmitter position. When the transmitter works properly, pull the end of the zip ties to secure
the transmitter into place. Then cut off the loose ends of the zip ties.