Sprout PIKLER LABYRINTH CONNECTORS User manual

LABYRINTH CONNECTORS
PIKLER
ASSEMBLY GUIDE
Fully assemble purchased Labyrinth pieces according to their included
assembly instructions.
1
Take one of your assembled Labryinth pieces and ip it upside-down. The
groove on the bottom should be facing up.
2
PARTS REQUIRED
Connector Part*
A
Screw*
B
Phillips
Screwdriver
*Number of Parts Varies per Order

Press Connector Part A into one of the grooves. Make sure that the side
with the hole is the side pressed into the groove, as shown below.
3
Insert Screw B through hole, as shown below. Use screwdriver to thread
screw into insert until ush.
4
Repeat Steps 3-4 with additional Connector Parts A as needed. Flip
assembled Labyrinth piece back over.
5
B
B
A
A
A

Take other assembled Labyrinth piece and place it on Connector Part A ,
aligning the groove on the bottom with the installed Connector.
6
Gently apply pressure to second assembled Labyrinth piece to press down
onto Connector Piece A until fully seated and ush with the oor.
7
Repeat Steps 2-7 for any additional assembled Labyrinth pieces that you
would like to connect.
8
A
A
A

WWW.SPROUT-KIDS.COM
PO BOX 1123, PROVO, UT 84601
QUARK ENTERPRISES 2022
DOCUMENT: AI-PIK-LAB_BRAK