Sprout PIKLER LABYRINTH DOWEL CUBE User manual

PARTS
LABYRINTH DOWEL CUBE
PIKLER
ASSEMBLY GUIDE
INCLUDED TOOLS
Hex Bit
4mm Allen
Wrench
long & skinny
Sandpaper
14.50”
Dowels
(4x)
14.50”
Bored Dowels
(6x) Screws
(12x)
Top
F
G
H
C
D
A
Top
B
E

Start by separating Dowels C from Bored Dowels D .
1
If using a drill, set clutch on drill to LOW SETTING (around 3).
If your drill has two speeds, set it to the SLOW SPEED (1).
A high clutch setting will strip screw heads or wood and can render
parts useless!
CLUTCH TOO HIGH: If the drill twists dramatically in your hand when
drilling. Lower the clutch setting.
CLUTCH TOO LOW: If the screw does not screw in all the way. Adjust
clutch up by 1 setting and try again.
STRIPPED WOOD: If the screw continuously spins in place, the wood
has stripped. To x, insert a toothpick into the stripped hole and break
the top o so it's even with the hole opening, then try again. If needed,
add additional toothpicks until the screw stops spinning in place.
3
4
2
2
3
3
4
2
1
12
12
C
C
D
D

Insert Dowels B into their reliefs, as shown below. If the Dowel is tight,
twist and push the Dowel into the recess until snug.
4C
C
Using 4mm Allen Wrench F or Hex Bit G and a drill, attach one Bored
Dowel D to Bottom B by threading Screw E through hole until ush,
as shown below. Repeat with other Bored Dowels D .
2
Flip the parts so that the Bored Dowels D are pointing up, as shown.
3
F G
D
D
DBE
F
D
B
E
D

Place Top A onto Dowels B & C , aligning loosely.
5
Using 4mm Allen Wrench E or Hex Bit F and a drill, thread Screw D
halfway through each hole, as shown below. Repeat with each corner.
6
Line up Dowels B & C and tighten Screws D until ush with Top A .
Make sure to visually conrm that Dowels sit in their respective recess
before fully threading each Screw.
7
Go through and pull on each Dowel B & C to conrm that there is no
excessive wiggle. Visually conrm that all Screws D are ush.
8
G
D
D
A
E
E
F
F
A
A
A
C
C
D
D
D
C
C
C
E
E
E
WWW.SPROUT-KIDS.COM
PO BOX 1123, PROVO, UT 84601
QUARK ENTERPRISES 2022
DOCUMENT: AI-PIK-LAB_DWL-CUBE