SPT BF-314U User manual

Owner’s Manual
Under-Counter Beer Froster
Model: BF-314U
Please read this manual carefully before use and keep in a safe place for
future reference.

1
IMPORTANT SAFETY INSTRUCTIONS
WARNING To reduce the risk of fire, elec
trical shock, or injury when using this
appliance, follow these basic precautions:
• Read all instructions before using this appliance.
• DANGER or WARNING: Risk of child entrapment.
Child entrapment and suffocation are not problems of the past. Junked or abandoned
appliances are still dangerous…even if they will “just sit in the garage a few days”.
• Before you throw away your old Wine/Beverage Cooler or any appliance:
Remove the door. Leave the shelves in place so children may not easily climb inside.
• Never allow children to operate, play with, or crawl inside the appliance.
• Never clean appliance parts with flammable fluids. The fumes can create a fire hazard or
explosion.
• Please dispose the appliance according to local regulations as the unit contains flammable
blowing gas and refrigerant.
• Keep ventilation openings clear of obstruction.
• Do not store or use gasoline or any other flammable vapors and liquids in the vicinity of this
or any other appliance. The fumes can create a fire hazard or explosion.
• If the power cord is damaged, it must be replaced by the manufacturer, service agent or
similarly qualified persons in order to avoid a hazard.
•
This appliance is not intended for use by persons (including children) with reduced physical,
sensory or mental capabilities, or lack of experience and knowledge, unless they have been
given supervision or instruction concerning use of the appliance by a person responsible for
their safety.
• Do not store explosive substances such as aerosol cans with a flammable propellant in this
appliance.
-Save these instructions-

2
INSTALLATION INSTRUCTIONS
Before Initial Use
• Remove the exterior and interior packing.
• Before connecting power, allow unit to stand upright for 2 hours. This allows the refrigerant to settle
and reduce the possibility of malfunction in the cooling system from handling during transportation.
• Clean the interior surface with lukewarm water using a soft cloth.
• Install the handle on the left side of the door (if you wish to reverse the door, please first reverse
the door according to instructions below, then install handle on the right).
Placement
• This appliance is designed for free standing or built-in (full recessed) installation.
• Place the appliance on a floor that is flat and strong enough to support it when fully loaded. To level
the appliance, adjust the front leveling legs at the bottom of the unit.
• Locate the appliance away from direct sunlight and sources of heat (stove, heater, radiator, etc.).
Direct sunlight may affect the acrylic coating and heat sources may increase electrical
consumption. Extreme cold ambient temperatures may also cause the unit not to perform properly.
• Avoid locating the unit in moist areas.
• Plug the appliance into an exclusive, properly installed-grounded wall outlet. Do not under any
circumstances cut or remove the third (ground) prong from the power cord. Any questions
concerning power and/or grounding should be directed toward a certified electrician.
Defrosting:
While operating, the appliance will defrost once every 8 hours. The defrosting process lasts
approximately 30 minutes. Water will collect in the evaporator drip tray and is automatically evaporated.
During the defrosting process, the temperature displayed may be higher than the set temperature.
Note: Water condensation may appear on the outer surface of the glass door. This occurs when water
molecules within the air comes in contact with the cold surface of the glass door. The vapor condenses
on the glass surface and can cause a foggy effect or in extreme situations, water droplets. This
indicates high humidity in the environment, simply wipe off the water condensation with a soft cloth.

3
OPERATING YOUR BEVERAGE COOLER
• The appliance should be placed where the ambient temperature is between 50°F to 83°F. If the
ambient temperature is above or below this range, the performance of the unit may be affected.
For example, placing your unit in extreme cold or hot conditions may cause interior temperatures
to fluctuate.
• Connect power cord to a properly grounded outlet.
• This appliance is equipped with Memory IC – should there be a power interruption, unit will auto
recover at last setting.
Control Panel:
ON/OFF Power
To turn the appliance on or off, press and hold the ON/OFF button for 3 seconds.
LIGHT/LOCK
• Press to turn the interior light ON or OFF. Light will automatically turn off after 10 minutes. For best
wine storage, keep the light off except when viewing.
• Press and hold for 3 seconds to lock or unlock the control panel.
Setting the temperature Control
• Adjustable temperature: 23°F to 41°F( -5°C to 5°C)
• Set the desired temperature by pressing the corresponding buttons, to increase or to
decrease. Each press is in 1-degree increment. Once released, set temperature will flash for
approximately 5 seconds then revert back to display the internal temperature.
• To view your set temperature, press either the or button once and LED display will flash
set temperature for 5 seconds.
• The appliance has the capability to display temperature in either Celsius or Fahrenheit. To change
the temperature scale, press and hold both buttons simultaneously for approx. 3 seconds.
Note: The temperature of Beer Froster inside may vary slightly depending on whether or not the
interior bulb is ON or OFF and where the bottles are located (upper/middle or lower section).
RUN
When unit’s compressor is running, this indicator light will illuminate to signify that cooling mode is
currently in operation.
LOCK
If illuminated, indicates the control panel is locked.

4
NOTE:
• If the unit is unplugged, turned off or experienced a power failure, you must wait 3 to 5 minutes
before restarting the unit. If you attempt to restart before this time delay, the appliance will not start.
• When you use the appliance for the first time, or restart after having been shut off for a long time,
there could be a few degrees variance between the set temperature and the displayed
temperature on the LED readout. This is normal and is due to the length of inactivity. Once the unit
runs for a few hours, everything will be back to normal.
• When the “·” is flickering, indicates the defrosting mode is currently in operation, it does not affect
the unit operation normally.
CARE AND MAINTENANCE
Cleaning Your Beverage Cooler
• Turn off the power, unplug the appliance, and remove all items including shelves and racks.
• Wipe the inside surfaces with a soft cloth in warm water and baking soda solution. The solution
should be about 2 tablespoons of baking soda to a quart of water.
• Wash the shelves with a mild detergent solution.
• Wring excess water out of the sponge or cloth when cleaning the control panel or electrical parts.
• Wipe the outside with a soft cloth or sponge. If excessively dirty, wipe with warm water and mild
liquid detergent. Wipe clean and dry with a clean soft cloth.
• Defrosting occurs automatically inside of the beverage cooler during operation, approximately
once every 8 hours. The compressor will stop running for about 30 minutes. During this time, the
temperature may rise above your set temperature. Defrosted water is collected inside evaporating
tray and evaporates automatically.
Power Failure
Most power failures are corrected within a few hours and should not affect the temperature of your
appliance if you minimize the number of times the door is opened. If your power is going to be off for a
longer period of time, you need to take the proper steps to protect your contents.
Vacation Time
Short vacations: Leave the appliance operating during vacations of less then three weeks. For longer
vacations, should you decide to turn off the unit, leave the door ajar to prevent odor building inside.
Transporting
If you need to move your appliance after the box has been discarded:
• Remove contents and securely tape down all loose items (shelves).
• Turn the adjustable leg up to the base to avoid damage.
• Tape the door shut.
• Be sure the appliance stays secure in the upright position during transportation. Also protect the
outside of the appliance with a blanket or similar item.
Energy saving Tips
• The appliance should be located in the coolest area of the room, away from heat producing
appliances and out of direct sunlight.
• Try not to open the door too often, especially when weather is wet and hot.