SPX FLOW Delair Etsiline CommPact User manual

Quick reference delair® Etsiline CommPact
Starting Air Dryer
1. Connect the air dryer to the power supply
2. Switch S4 to turn ON (I) the air dryer.
3. Display AT1 will illuminate and starts to display process status, running hours, pressure and status
internet connection
4. By opening (switch upwards) valves on the front side of the unit (V1 till V8) the corresponding
connection on back side of the unit will deliver dry air.
Stopping Air Dryer
1. Switch S4 to turn OFF (0) the air dryer.
2. Close the dry-air supply valves (V1…V8)
3. Disconnect dryer from power supply if necessary
Information about connections
All connections are positioned on the back side of the unit.
Figure 1.2; Back view with identification of connections (option with adaptor is shown here)
Figure 1; Front view with identification of controls

Quick reference delair® Etsiline CommPact
Electrical power supply standard :48Vdc
To be connected to male-connector CON8. Female socket (CON7) included in delivery. See below how
connector needs to be wired;
CON7
CON8
48Vdc Supply connector
Female socket CON7 included in delivery.
3-pole connection suitable for 48Vdc.
Pin 1: +, Pin 2: -, 3 earth
With option 0281544 (power adaptor) power supply is : 90-264Vac / 1ph / 50-60Hz
CON5
CON6
Main voltage connector
[Only applicable with option 0281544]
Female socket CON6 included in delivery.
3-pole (phase-neutral-earth) connection suitable for 90-264Vac/1/50-60Hz
–90W.
Through CON4 the installation is connected to Ethernet
CON4
Ethernet connection
Air dryer is equipped with an alarm connector CON9. See below positioning of contacts
CON9
CON10
Alarm connector
Connector for external alarm. Potential free contact.
Dry air connections (outlet 1…8)
Outlet
1…8
Dry air outlet connection
Hose connection to system. Connection number corresponds to OPEN-
CLOSE valve on front of the unit. When corresponding valve is opened,
dry air is delivered to the system. Suitable for flexible hoses with internal
diameter 6mm and outside diameter of 8mm.
Connection 9 is the remote sensing connection. With this connection the pressure downstream the dryer can
be measured and used for control.

Quick reference delair® Etsiline CommPact
Logging in through ethernet
After connecting the delair® Etsiline CommPact (connector CON4) to internet, it is possible to check the
status of the dehydrator and change parameters like working pressure and alarms.
At start-up of the dehydrator you read on the display (line 2) the IP address of the unit. After you have filled in
the IP address in your web browser (preferable Google Chrome), you need to fill in your Username and
Password. The default username and password are:
Username : admin
Password : admin
To be checked in case of failure
- Check system for leakages
- Check dryer settings (see manual ACMM16WC0002 Chapter 6 Parameter Settings or via webpage ->
Installer -Factory settings)
- Check power supply
- Check fuse on back of the unit. To open fuse holder, twist holder counter clockwise.
F1
Fuse
Fuse holder for 2A-fuse-slow (20 mm) which protects the heater
elements. Twist to open.
NOTE
:
Detailed information can be found in manual
ACMM16WC0002 as stored on the USB-stick which is
included in the delivery of the air dryer.
Figure 6.3; Inlog screen