SpyCameraCCTV SPYBATT007 User manual

Getting Started
Charging your battery recorder
Before using the SPYBATT007 we recommend
making sure the device is fully charged. To charge,
connect to a PC USB port, or a 5V USB charger.
While charging the blue and red lights will ash,
once fully charged the red light will go out and the
blue light will turn on. The recorder will take 4-6
hours to fully charge from a at battery.
Installing microSD card
The microSD card is installed in to the bottom
of the unit, and then one of the adhesive plates
are used to cover it. We recommend testing the
device records OK, and that you can access the
recording on your PC before sticking down this
cover.
Playback on your computer
For playing back the les on your computer, we
recommend using VLC Media Player. The latest
version can be downloaded for free from http://
www.videolan.org
Power on – standby mode
Press and hold the power button for 3-4 seconds.
The red status light will come on. The unit is now
in standby mode.
Recording video
From standby mode, click the power button. The
red light will ash twice to indicate the unit has
start to record. To stop recording, click the power
button again. The red light will come on and the
unit is back to standby mode.
Motion detection record
From standby mode, press and hold the power
button for about 3 seconds then release, the
blue light will ash and the red light goes out.
The device is now in motion detection mode.
When motion is detected, the blue light will ash
once to indicate it has started recording. To stop
recording, click the power button and the device
will return to standby mode, indicated by the red
light coming on.
Product Guide:
SPYBATT007
Get to know your recorder
Note: The large USB port on the left is
non-functioning.

Powering o the recorder
Press and hold the power button for 6-7 seconds,
until the red and blue light ash together. The
lights will then go out and the device has powered
o.
Setting date & time for video timestamp
Ensure the microSD card is installed and the unit
is powered o, then connect the SPYBAT007 to
your computer. Open the device so you can see
the contents of the SD card. Right click, select
‘New’ then ‘Text Document’ and name the le
time.
The date and time is stored in the following
format:
YYYY.MM.DD HH:MM:SS
Edit the le to the current date and time, for
example. At 3PM on the 14th October 2013 the
le would read:
2013.10.14 15:00:00
Once you have set it to the current date and time,
save the le. Now disconnect the device and
power it on. The date and time will be updated to
the information in the le.
All done!
Specication Troubleshooting
Storage capacity Up to 32GB micro SD
USB interface USB 2.0
Motion detect range 6 meters (approx.)
Minimum illumination 1 LUX
Video format AVI
Video resolution 1280x720p
Framerate 30fps
Photo format JPG 3264x2448
Battery life from full 8 hours
Battery DC 5V 3000MAH
Storage temperature -20 °C to 80°C
Problem Solution
Won’t turn on Ensure the battery is
fully charged and that
the SD card has space
Unit won’t record Restart the camera,
check the battery is
charged and that the
SD card has space
Sound or video
distortions in
recordings
Fully charge the unit
Not detected by your
PC
Ensure that the USB
connector is fully
pushed into the unit