
www.srt.se
Status LEDs
Charge indicator LED
(charger connected)
Charge indicator LED
(no charger connected)
GSM status LED
Solid
Searching for a GSM
network
Slow blinking
Connected to a GSM
network
Rapid blinking
Voice call in progress
No light
GSM is turned off
Blinking three times
every 15 seconds
The device is on and
shows the battery status
with three blinks
Blinking green
every other second
The device is on and
charging
Blinking red every other
second
The device is off and
charging
Solid green
The device is on and fully
charged
Solid red
The device is off and fully
charged
green green green
Very good
greengreen red
Good
green redred
Low
redredred
Critical
Alternating between
solid red and green
The device is shutting
down
Alternating between
solid red and green
The device is shutting
down
GPS/Timer/
Man down status
No light
GPS is either turned off,
is in idle mode or have no
current position.
Man down is disabled.
Blinking (green)
The device have a
current GPS position.
Blinking (red)
Timer alarm/Man down is
enabled.
Blinking (red/green)
the device have a current
GPS position.
Timer alarm/Man down is
enabled.
Insert the charger
cable into the mini
USB connector.
The charge indicator
LED will blink red or
green when charging
The charge indicator
LED will turn into a solid
red or green when the
device is fully charged
Charging times
Before using your alarm
device the rst time or
whenever it is fully dischar-
ged, the battery should be
charged for 4 hours. The
device should be
charged every day.
Charging
(Desktop charger)
Charging (USB)
Lift the rubber ap on the
side of the device
Place the unit in the desk-
top charger