ST-Lab S-270 User manual

USB 3.0 3.5’’ SATA 3G
Hard Drive Enclosure
User Manual
Ver. 1.00
All brand names and trademarks are properties of their
respective owners.

MN Page
Features & Specifications
Supports USB 3.0 SuperSpeed and USB 2.0
Maximum transfer rate of 5 Gbps with USB 3.0 and 480Mbps
with USB 2.0; actual speed depends on the hard drive
performance
Supports SATA 3.5’’ hard drives
Supports Plug and Play
Supports Windows 2000, XP/Vista/7 (32/64 bit)
System Requirements
Windows® 2000, XP/2003/Vista/7 (32/64 bit)
Available USB port
Package Contents
1 x USB 3.0 3.5’’ SATA 3G Hard Drive Enclosure
1 x User Manual
1 x USB 3.0 Cable
1 x Power Adapter
Note: Contents may vary depending on country/market.

MN Page
Hard Drive Installation
Install a hard disk drive in the Enclosure Kit by completing the
following steps.
1. Disassemble the rear
panel from the housing
by removing one screw
from each side of the
housing with a
screwdriver.
2. Push the bottom panel
out of the housing.

MN Page
3. Insert the SATA cable
into the hard drive, and
insert the control board
power cable into the
receptacle on the hard
drive.
4. Turn the enclosure so that
the bottom side is facing
up and insert the first
screw. Tighten the first
screw ensuring that
proper alignment is
maintained while
tightening. Repeat for the
three screws.

MN Page
5. Align the edges of the
hard drive platform and
carefully slide the
assembled platform into
the enclosure housing.
6. Fasten the rear panel to
the enclosure housing by
replacing the (2) screws
removed in step 1.
7. The Enclosure Kit is now assembled and ready for connection to a
computer.

MN Page
Connecting the Enclosure to a Computer
Complete the following steps to connect the enclosure to a host
computer.
1. Connect the AC/DC power adapter, then turn on the power switch;
ensure that the Power LED indicator is active.
2. Connect the USB 3.0 cable from the Enclosure to an available
USB port on the computer system.
Driver Installation
Windows will automatically detect and install the drivers for the USB
3.0 3.5’’ SATA 3G Hard Drive Enclosure.