Stanwood CWS-01 User manual

HOW TO ASSEMBLE YOUR
WIND SCULPTURES
CWS-01 -02 -03 -01L -02L
COPYRIGHT © STANWOOD IMPORTS & ORIENTAL TOUCH LLC
STEP 1.
Gather these parts : one pole with beveled
edge and three support stakes .
STEP 2.
Hammer the
main pole into
the ground
using a Rubber
Mallet until the
black line
touches the
ground ( about 1
ft . deep ).
Installation: Pole Anchoring
* We recommend you use blue Loctite thread locker if in windy area
1
STEP 3.
Slide a support
stake into the
main pole
and hammer it
into the ground .
STEP 4.
Slide a second
support stake
into the main
pole . Position it
~ 120 degrees
away from the
first stake and
hammer it into
the ground .
STEP 5.
Slide a third
support stake on
to the main pole .
Position it evenly
away from the first
two stakes and
hammer it into the
ground .
STEP 6.

COPYRIGHT © STANWOOD IMPORTS & ORIENTAL TOUCH LLC
STEP 7.
Connect two
sections of the
pole together .
Installation: Wind Sculpture
STEP 8.
Mount spinner wheels
onto the T - shaped
shaft with the exposed
side of the bearings
facing away from the T
shaft .
* We recommend you use blue Loctite thread locker if in windy area
STEP 8 cont.
2
Correct Incorrect
ANY QUESTIONS PLEASE
CONTACT US AT:
[email protected]
[email protected]
Tel: [phone]
Copyright © Stanwood Imports
& Oriental Touch LLC
STEP 9.
Fix the wheels with
provided mushroom
ball screws to both
ends of the T shaft .
Hand tighten as
much as
possible .
1 . 2 .
3 . 4 .
STEP 10.
Slide the spinners onto the pole .