StarTech.com CLAYTEK WOR-2740C User manual

WOR-2740C
ID Name Qty
Rack Components
1 Left Vertical Rail 2
2 Right Vertical Rail 2
3 Base Bracket 2
4 Corner Section 8
5 Center Section 4
6 Top Bracket 2
Rack Assembly Hardware
10 M8 Bolt 48
11 M8 Washer 48
Rack Assembly Tool
12 M8 (13mm) Wrench 1
Equipment Mounting Hardware
13 M6 Cage Nut 50
14 PVC Cup Washer 50
15 M6 Phillips-Head Screw 50
Cable Management Hardware
16 Cable Management Hook 16
17 Hook Mounting Screw
Casters and Hardware(Optional Accessories)
18 Casters 4
19 Levelling Feet 4
20 M6 Screw 16
21 M6 Flat Washer 32
22 M6 Flange Nut 16
1
16

Instruction Manual
Installation
Verify packaging contents before proceeding with assembly.
1. Assemble the Top and Bottom Beams (4 total) as shown below, adjusting for your
desired mounting depth using the numbers indicated on the center section pieces
(see chart below)
Mounting Depth Index Numbers Mounting Depth Index Numbers
22 in. 0 and 0 31 in. 4 and 5
23 in. 1 and 0 32 in. 5 and 5
24 in. 1 and 1 33 in. 5 and 6
25 in. 1 and 2 34 in. 6 and 6
26 in. 2 and 2 35 in. 6 and 7
27 in. 2 and 3 36 in. 7 and 7
28 in. 3 and 3 37 in. 7 and 8
29 in. 3 and 4 38 in. 8 and 8
30 in. 4 and 4 39 in. 8 and 9
40 in. 9 and 9
NOTE: Depth from 22 to 40 inches is available by adjusting the beams at
corresponding silkscreen numbers on the beams.
2

Instruction Manual
2. Using two of the Beams assembled in the previous step, line up one set of Left
and Right Vertical Rails, followed by the Base and Top Bracket pieces and fasten as
shown.
NOTE: In order to ensure all of the screw holes will line up easily, it is recommended
to hand-tighten the nuts through the entire assembly process, and then fully
tighten using an adjustable wrench once all bolts have been inserted.
3. Using the remaining two Beams assembled in step 1, line up the other set of Left
and Right Vertical Rails and fasten them to the Base and Top Brackets as shown.
3

Instruction Manual
Optional Component Installation
1. Install the Casters (4pcs) and Leveling Feet (4pcs) as shown.
2. Stand the rack upright and install the included Cable Management Hooks in your
desired locations as shown.
4