(Optional - Recommended) Grounding the Wall-Mounting Bracket
1. Remove the M6 Nut on the Grounding Stud, using a 10mm Wrench.
2. Slide the appropriately sized Grounding Lug from an Earth Grounding Wire over
the Grounding Stud.
3. Connect the Equipment Grounding Wire(s) to the Grounding Stud as required.
4. Thread the M6 Nut onto the Grounding Stud and tighten, using a 10mm Wrench.
5. Attach the other end of the Earth Grounding Wire to an Earth Ground
Connection.
Adding Equipment to the Wall-Mounting Bracket
Use the included M6 Cage Nuts, M6 Cage Screws, and M6 Plastic Washers to install
equipment into the Wall-Mounting Bracket.
1. Insert the Wing (side) of an M6 Cage Nut into the back of the a Cage Nut Hole.
2. Insert the second Wing of the M6 Cage Nut into the selected Cage Nut Hole, using
pressure by hand, or with a Cage Nut Tool.
3. Repeat steps 1 and 2 to insert the desired number of Cage Nuts.
4. Thread an M6 Plastic Washer over an M6 Cage Screw. Repeat until the desired
number of M6 Cage Screw Assemblies have been prepared.
5. Align the Mounting Holes in the Equipment with the M6 Cage Nuts installed in
steps 1-3.
6. Insert the M6 Cage Screw Assemblies through the Mounting Holes in the
Equipment and into the M6 Cage Nuts and tighten, using a Phillips Head
Screwdriver.
• Wall structures vary. Ensure the type of wall structure and mounting hardware will
properly support the mounted equipment. Failure to do so might result in personal
injury and/or equipment damage. The wall structure should be capable of supporting
at least four times the weight of the mounted equipment.
Package Contents
• Wall-Mounting Bracket x 1
• M6 Cage Nuts x 8 (RACK-2U-14-BRACKET)
x 40 (RACK-10U-14-BRACKET)
x 56 (RACK-14U-14-BRACKET)
• M6 Cage Screws x 8 (RACK-2U-14-BRACKET)
x 40 (RACK-10U-14-BRACKET)
x 56 (RACK-14U-14-BRACKET)
• M6 Plastic Washers x 8 (RACK-2U-14-BRACKET)
x 40 (RACK-10U-14-BRACKET)
x 56 (RACK-14U-14-BRACKET)
• Concrete Wall Anchors x 4
• Mounting Screws x 4
• Quick-Start Guide x 1
Installation
Mount the Wall-Mounting Bracket
• Product mounting should be completed by a certied professional as per the local
safety and building code guidelines.
• Wall Mounting Holes are spaced 16 inches apart for mounting into 16 inch (center to
center) spaced Wall Studs.
Regulatory Compliance
Use of Trademarks, Registered Trademarks, and other Protected Names and Symbols
This manual may make reference to trademarks, registered trademarks, and other protected names and/or symbols of third-
party companies not related in any way to StarTech.com. Where they occur these references are for illustrative purposes only
and do not represent an endorsement of a product or service by StarTech.com, or an endorsement of the product(s) to which
this manual applies by the third-party company in question. StarTech.com hereby acknowledges that all trademarks, registered
trademarks, service marks, and other protected names and/or symbols contained in this manual and related documents are the
property of their respective holders.
PHILLIPS® is a registered trademark of Phillips Screw Company in the United States or other countries.
Warranty Information
This product is backed by a lifetime warranty.
For further information on product warranty terms and conditions, please refer to www.startech.com/warranty.
Limitation of Liability
In no event shall the liability of StarTech.com Ltd. and StarTech.com USA LLP (or their ocers, directors, employees or agents)
for any damages (whether direct or indirect, special, punitive, incidental, consequential, or otherwise), loss of prots, loss
of business, or any pecuniary loss, arising out of or related to the use of the product exceed the actual price paid for the
product. Some states do not allow the exclusion or limitation of incidental or consequential damages. If such laws apply, the
limitations or exclusions contained in this statement may not apply to you.
FR: startech.com/fr
DE: startech.com/de
ES: startech.com/es
NL: startech.com/nl
IT: startech.com/it
JP: startech.com/jp
StarTech.com Ltd.
45 Artisans Crescent
London, Ontario
N5V 5E9
Canada
StarTech.com Ltd.
Unit B, Pinnacle 15
Gowerton Road
Brackmills,
Northampton
NN4 7BW
United Kingdom
StarTech.com LLP
4490 South Hamilton
Road
Groveport, Ohio
43125
U.S.A.
StarTech.com Ltd.
Siriusdreef 17-27
2132 WT Hoofddorp
The Netherlands
