State Water Heaters SRGSS01806 User manual

RESIDENTIAL
SELECT®
Residential Gas Water Heaters
For more information on Select®contact:
State Water Heaters
500 Tennessee Waltz Parkway, Ashland City, TN 37015
800.365.0024 Toll-free USA
www.statewaterheaters.com
SRGSS01806 Revised March 2012
®
State Select
®
gas water heaters feature an FVIR Compliant design, which meets the ANSI Z21.10.1-CSA 4.1
standards for flammable vapor ignition resistance.
Diffuser Dip Tube
• Reduces lime and sediment buildup, maximizes hot water output
• Made from State PEXAN ™, a cross-linked polymer that can withstand
long-term exposure to temperatures up to 400ºF
Green Choice® Gas Burner
• Patented “Eco-Friendly” burner design reduces NOx emissions by up to 33%
and complies with 40 ng/j requirements for low NOx emissions.
Easy-to-Light Piezo Ignitor
• For fast “one-hand” pilot ignition
Glasslined Tank with Aluminum Anode Rod
• For long-lasting protection against build up and corrosion
Durable, Brass Tamper-Resistant Drain Valve
CSA Certified and ASME Rated T&P Relief Valve
Design-Listed by CSA International
• Certified at 300 PSI test pressure and 150 PSI working pressure
• Listed according to ANSI Z21.10.1 - CSA 4.1 standards governing storage-type water heaters
• Meets the Federal Energy Efficiency Standards effective January 20, 2004, according to
the National Appliance Energy Conservation Act (NAECA) of 1992 and meets the thermal
efficiency and standby loss requirements of the U.S. Department of Energy and current
editions of ASHRAE/IESNA 90.1.
• Additional code compliance: UBC, CEC, SBCC, CABO, HUD and BOCA National Codes
FVIR Compliant Design
6-Year Limited Tank and Parts Warranty
Consult written warranty or contact State Water Heaters for complete information
Simplifies Service
• Uses industry standard thermopile
• Burner operation may be viewed through new enlarged sight glass
Intelligent Control Logic
• The internal microprocessor provides enhanced operating parameters and tighter differentials
for precise sensing and faster heating response to optimize performance.
Self-powered Electronic Gas Valve
• Uses a thermopile to generate the power needed to operate the electronic gas control without
requiring an external power source.
Diagnostics
• The electronic gas control incorporates an LED status indicator that monitors system
operation & service diagnostics.
These High Output Models Have
• Capacity/input combinations up to 98 gallons/75,100 BTU produce recoveries up to 81
gallons per hour, with deliverable hot water up to 150 gallons.
300/301 Series
Low Lead Content

RESIDENTIAL
For more information on Select®contact:
State Water Heaters
500 Tennessee Waltz Parkway, Ashland City, TN 37015
800.365.0024 Toll-free USA
www.statewaterheaters.com
SRGSS01806 Revised March 2012
For complete information on limited warranties, consult written warranty,
or contact the State Customer Care Center, 1-800-365-0024.
State Industries, Inc. reserves the right to make product changes or improvements without prior notice.
SELECT
®
Residential Gas Water Heaters
65 HRRT: 62,500
(GS6 75CRRS)
®
SERIES
GS6 40 YRRT 75 .60 40 50,000 51 16 61-3/4 58-1/4 20 13 8 51-3/4 4 138300
300
100
100
100
100
State FVIR design meets or exceeds the American National Standards Institute standards (ANSI Z21.10.1 - CSA 4.1) that deal with
the accidental or unintended ignition of flammable vapors, such as those emitted by gasoline.
Feature a sealed combustion chamber with air intake filter and a flame arrestor built into the water heater base. In addition, a thermal
cutoff (TCO) device, is designed to shut off gas flow to the burner and pilot if
poor combustion is detected.
Flammable Vapor Ignition Resistant (FVIR) Water Heaters
If flammable vapors accidentally enter the
combustion chamber, the arrestor is designed
so flames burn off the top surface and can not
escape down through the arrestor. A. Industry standard thermopile
B. Large View Port for easy burner inspection
C. 3600combustion air filter
D. Thermal Cutoff (TCO) with manual reset
Maximum Hydrostatic Working Pressure: 150 PSI.
BA
F
D
1/2" GAS
CONNECTION
VALVE
C
COLD
CONNECTION
E
HOT
CONNECTION
ANODE ROD
(OPTIONAL T&P
LOCATION)
GS6 40 & 50 YRRT models are certfied from sea level to 10,100 ft. elevation all other models are certified to 7,700 ft. elevation
50 60-3/4 57 13 153
50-1/4
300/301 Series
Low Lead Content