STATESMAN Napier 60E User manual

USER / INSTALLER
INSTRUCTION BOOKLET
Please read instructions before using the appliance
MODEL: NAPIER 60E
Serial No.
Affix Serial No. Label above

2
CONTENTS
Introduction……………………..Page 3
Service…………………………...Page 3
Safety (General)………………..Page 4
Using the Oven………………....Page 6
Using the Grill…………………..Page 7
Using the Hotplate……………..Page 7
Installation……………………....Page 8
User Safety Rules………….…..Page 9
Cleaning………………………....Page 10
Technical Specification……….Page 11
CE Declaration of Conformity
This cooking appliance has been designed to be used only for cooking. Any
other use (such as heating a room) is improper and dangerous.
This cooking hob has been designed, constructed, and marketed in compliance
with:
- Safety requirements of the “LVD” Directive 2006/95/EC;
- Safety requirements of the “EMC” Directive 89/336/EC;
-Requirements of the Directive 93/68/EC.

3
INTRODUCTION
Thank you for choosing a STATESMAN appliance.
IMPORTANT: Before using your appliance, please read this manual carefully to
assist safe and successful operation.
INSTALLATION (SEE PAGE 8)
-This cooker must be installed by qualified personnel, according to the
manufacturer‟s instructions and to the relevant British Standards.
-This cooker is heavy; take care when moving it.
-Remove all packaging before using the cooker.
-Ensure that the electrical supply complies with type stated on the rating
plate.
-Do not attempt to modify the cooker in any way as this may be dangerous
and will invalidate the warranty.
SERVICE
Should you have any difficulty using your cooker, and you have checked the
possible causes with the help of information provided, you may contact our
CUSTOMER SERVICES DEPARTMENT: 0844 84 85 861
Please have ready the following details:
- Model No.
- Serial No.
- Date of purchase
- Name, address and postcode
- Contact telephone number
- Accurate description of fault
- Where purchased
Spare parts information can be obtained by calling the SPARE PARTS
DEPARTMENT: 0844 84 85 862

4
SAFETY
It is important to read this manual and take all safety measures that are
recommended.
WARNING; do not leave the hotplates switched on without a pan in place as
this will cause overheating which is a safety hazard. Damage caused this
way is not covered by the guarantee.
-This appliance has been designed for domestic, non-professional use.
-Check for any damage once unpacked. If there are any defects or damage,
do not use the appliance. Report the defect/damage to your supplier or
Statesman Service.
-Remove and dispose of all packaging immediately to prevent any risk of
harm to children.
-This appliance must be installed and commissioned by a qualified person as
Statesman will not take any responsibility for damage caused by incorrect
installation.
-Before installing this appliance, make sure that the electricity supply is
compatible with the specification on the rating plate and the packaging.
-The supply cable must never be changed by the customer. If it becomes
damaged, contact a qualified person to replace it.
-Switch the power supply off before changing the oven lamp.
-Always switch the power supply off before any cleaning or maintenance is
carried out.
-After use, some parts of this appliance may remain hot for a long time. Take
care to avoid touching parts until the appliance has cooled.
-Keep flammable materials away from the appliance.
-Ensure that no cables of other electrical appliances come into contact with
this appliance, especially hot parts.
-Keep children away from this appliance.
Take care to avoid touching the heating elements inside the oven as these
become extremely hot when in use.
-When using the grill, the oven door should be kept closed.
-Never use steam cleaners for cleaning the appliance.

5
SAFETY CONT….
IF A REPAIR IS REQUIRED, ONLY GENUINE PARTS SHOULD BE USED AND
ANY WORK MUST BE CARRIED OUT BY A STATESMAN ENGINEER.
The installer of this appliance should read the installation instructions and
should be a suitably qualified person.
CONTROL PANEL AND HOTPLATE
1- Oven/Grill function control
2- Oven/Grill temperature control
3- Hotplate control (1500 W) rear left
4- Hotplate control (1000 W) front left
5- Hotplate control (2000 W) front right –fast plate
6- Hotplate control (1000 W) rear right
7- Hotplate 145mm (1000W)
8- Hotplate 185mm (2000W) - fast plate
9- Hotplate 145mm (1000W)
10-Hotplate 185mm (1500W)
9
8
10
7
NAPIER 60E
Hotplate indicator light
Oven/Grill indicator light
OVEN/GRILL
FUNCTION
OVEN/GRILL
TEMPERATURE
BACK LEFT FRONT LEFT FRONT RIGHT BACK RIGHT

6
USING THE OVEN & GRILL
Functions
The symbols below show the functions that can be selected with the
function control knob.
Main oven full heat
Main oven base heat
Main oven top heat
Grill
OVEN OPERATION
When you first operate the oven, the installation material around it will emit an
odour. This is harmless and will soon fade.
Turn the oven function control knob to the required function symbol. Turn the
thermostat knob to desired temperature setting.
For preheated recipes, preheat oven for 15 minutes.
When the required temperature is reached the oven/grill indicator light
will no longer be illuminated.

7
GRILL OPERATION
The grill door must be closed when grilling.
Turn the function control knob to the grill symbol.
Turn the temperature control knob to 190oC max.
The indicator light will show, indicating that the grill is on.
For best results, pre-heat the grill for 2 minutes before beginning to use it.
The clip-on grill pan handle should be used when handling the grill pan.
USING THE HOTPLATE
Turn the hotplate control knob clockwise to the desired position; the indicator
light will illuminate showing that the hotplate is on. When you have finished using
the hotplate, turn the control knob back to „0‟ before removing the pan. There
may be some discolouration of the hotplate trims initially which is normal and
not detrimental to its use in any way.
The table below gives an indication of typical use for the different heat settings:
Knob position
0
1 & 2
3 & 4
5 & 6
Function
Off
Low heat
simmering
Cooking
and boiling
Rapid cooking
and boiling
145mm plate
1000W
250 W
750 W
1000 W
185mm plate
1500W
750 W
1250 W
1500 W
185mm plate
2000W
1000 W
1500 W
2000 W
WARNING; do not leave the hotplates on without a pan in place as this could
cause overheating which creates a safety hazard. Damage to the appliance
caused this way is not covered by the guarantee.

8
INSTALLATION
IMPORTANT –Installation of this cooker must be carried out by qualified
personnel.
This cooker must be earthed.
CLEARANCES
This cooker may be fitted flush to the base units, please leave a small gap of
approximately 2mm for cleaning etc.
No over hang or cooker hood can be closer than a minimum of 650mm above
hotplate.
The cooker must have a horizontal clearance above the hotplate of 90mm each
side and a minimum of 400mm above the hotplate.
ELECTRICAL CONNECTION
- This appliances must be earthed.
- The power supply must be 220-240v for single phase or 380-415v for three
phase installation.
- This appliance requires a 32amp circuit breaker and double pole switch with
minimum contact separation of 3mm.
- The power supply cooker switch must be close to the appliance with no
extension cable being used.
- The power supply cable must not come into contact with any hot/sharp parts of
the back of the appliance. This is to avoid damage to the cable which could
result in a short circuit.
- Do not install the appliance with a damaged cable.
- Incorrect installation will invalidate the guarantee.

9
Cont…
ELECTRICAL CONNECTION CONT….
SINGLE PHASE –NORMAL THREE PHASE
USER SAFETY RULES
- This appliance has been manufactured according to all regulations for
electrical appliances.
-Any maintenance or repair work must be carried out by a qualified and
authorised engineer. This is for your safety and to avoid the guarantee being
invalidated.
- When in use, the outer surfaces of the appliance will become hot as well as the
interior surfaces of the oven and grill. The heat is retained for a certain time
after use and care must be taken not to touch these parts of the appliance until
it has cooled down. Keep children away until it has cooled down.
-Never leave the cooker whilst cooking with solid or liquid oils and fats. If
neglected and overlooked they can easily catch fire. Never use water to
extinguish burning oil. Apply a cover to the pan and turn off the cooker power
supply switch.
- Please be aware of the risk of leaving the oven door open. Any downwards
pressure could tilt the cooker forward and tip any pans being used from the
hotplate. Excess weight or pressure on the open door may also result in
damage which will not be covered by the guarantee.
CONT…

10
USER SAFETY RULES CONT….
- Switch the power supply switch (cooker switch) off at the wall when not in use.
- Always protect the appliance from the effects of damp or wet weather
conditions. Appliances in a damp atmosphere will be damaged by rust
corrosion which is not covered by the guarantee.
CLEANING
IMPORTANT –Before any maintenance or cleaning can be carried out, you
must DISCONNECT the cooker from the electricity supply.
HOB TOP
The hob is best cleaned whilst it is still warm as spillage can be removed more
easily than if it is left to cool.
Regularly wipe over the hob top using a soft cloth well wrung out in warm water
to which a little washing up liquid has been added. Avoid the use of strong
household detergents and bleaches, impregnated pads unsuitable for non-stick
saucepans, steel wool pads and bath/sink stain removers.
Apply a thin layer of cooking oil to hotplates after being cleaned and dried.
CONTROL PANEL
Before cleaning the control panel, ensure that the surface is cool. For best
results, use a soft dampened cloth. If marks should remain use a very mild
detergent using a light rubbing action, being particularly careful around
graphics.
OVEN AND GRILL
The oven should be kept clean at all times. A build up of fats or other foodstuffs
could result in a fire.
The oven and grill cavities have a smooth enamel finish and can be scrubbed
with a soft cloth soaked in warm soapy water. However, from time to time they
may require a more thorough clean using an oven cleaner. Ensure that the oven
cleaner used is suitable for smooth enamel.

11
TECHNICAL DATA
SPECIFICATION FOR HOTPLATE, OVEN & GRILL
Element Type
Rating
145mm Hotplate (x2)
1000 W
180mm Hotplate
1500 W
180mm Rapid
Hotplate
2000 W
Grill Element
2000 W
Oven Top Element
1200 W
Oven Bottom
Element
1100 W
TOTAL MAX POWER
7800 W