Status EVP300 User manual

innovations
izvirni pripomočki
izvorna pomagala
innovations
izvirni pripomočki
izvorna pomagala
innovations
izvirni pripomočki
izvorna pomagala
ELECTRICAL VACUUM PUMP
USER MANUAL
EN


EN
3
Figure 1: Components*
The gure below shows the electrical vacuum pump. Important points are marked with numbers and explained
in the table:
1. Outer casing
2. Start/Stop Button
Initiation and interruption of vacuum packing process.
3. Stand
4. Silicon gasket
By vacuum packing process it should be placed precisely on the valve of the chosen container.
5. Rubber tap
6. Rib
In the case the pump is placed on the wall, remove the ribs.
7. Wall inserted piece
8. Screws
* Components are marked with the same numbers also on Figures 3 and 4.
1. COMPONENTS AND FUNCTION BUTTONS

EN
4
1.1. TECHNICAL DATA
Dimensions
(with the stand)
Width: 80 mm
Depth: 180 mm
Height: 136 mm
Weight Pump with the stand approximately 0,49 kg, adapter approximately 0,6 kg.
Material ABS plastic
Pump Single–piston pump (self-oiling – no maintenance necessary)
Vacuum pressure - 500 mbar
Motor 12 V DC
Automatic cut-off after one minute in case of improper use.
Max RPM 3500
Pump volume 11 l/min
Controls Electronic
Adapter input: 110-240 V ~ 50-60 Hz, 250 mA
output: 12 V DC, 2000 mA
a) Pay attention on the place, where vacuum pump
will be positioned. Working surface must be dry,
normal temperature (not hot) and clear from ob-
structions or water source.
b) Check the power cable and electrical outlet before
you plug in the appliance. Make sure there are no
breakdowns.
c) Appliance should be cleaned only with a dry or sli-
ghtly damp cloth.
d) Use the appliance only for the purposes described
in the User Manual.
e) Warranty is invalid if:
• the appliance has been repaired by somebody who
is not an authorised person or a professional.
• you use the appliance for unintended purposes.
• you do not respect safety regulations and do not
follow the instructions in the User Manual.
The manufacturer will not accept responsibility for any
damage that may occur as a result of not following the
User Manual or improper use.
1.2. IMPORTANT SAFETY
INSTRUCTIONS
1.3. OPERATING CONDITIONS
Maximum ambient temperature in normal use is
+40°C; the average of temperatures over a 24-hour
period should not exceed +35°C. Minimum ambient
temperature is –5°C.
Surrounding air should be clean; relative humidity
should not exceed 50% at the maximum temperature
of +40°C. Higher relative humidity is allowed at lower
ambient temperature (e.g. 90 % at +20°C).

EN
5
2. USAGE
2.1. GENERAL INSTRUCTIONS
a.) When taking the appliance out of its packaging
check that all its components are included and
undamaged. Make sure no polystyrene fragments
are left inside silicon gasket.
b.) Read the User Manual before you use the machi-
ne for the rst time.
a) Electrical vacuum pump is a professional appliance
adapted to everyday use in households.
a) Plug in the appliance.
b) Place the pump right-angled on the container or lid
and push slightly. Make sure that silicon gasket
(item 4) is placed on the middle of the valve.
c) Press Start/Stop Button (item 2). The pump will
automatically turn off when the vacuum process is
completed.
d) In case of improper use the pump will automatically
cut-off after one minute.
e) During vacuum packing process the pump could be
stopped at any time by pressing Start/Stop Button.
Figure 2: Proper vacuum pump position on the
vacuum container
2.2. INSTRUCTIONS FOR USE
2.3. STORAGE
Electrical vacuum pump can be put and storaged on
the kitchen counter or xed to the kitchen wall.
Figure 3: Position when stored on the counter or on
the wall
When xing stand on the wall remove ribs on the lower
side of the stand (see item 6), make holes for the
attached wall screws and screw them into the wall. See
gures bellow:
Figure 4: Compound parts and xing the bottom stand
on the wall

EN
6
2.4. MAINTENANCE AND CLEANING
a.) Always unplug the appliance before cleaning.
b.) Use a soft, damp cloth to clean the machine. Do
not use anything which could scratch or damage
the surface. Never submerge the appliance in wa-
ter or place it under running water. Never squirt de-
tergent directly onto or into the machine.
c.) Before using the appliance make sure that it is
completely dry.
d.) If any case the liquid enters the appliance consult
an authorised repair service.
2.5. TIME INTERVALS FOR USING
ELECTRICAL VACUUM PUMP
When using electrical vacuum pump for vacuum pack
larger amounts of food let the pump cool down every
20 minutes for at least 2 minutes.
If you have any comments or questions concerning the
functioning of the appliance or warranty, please con-
tact us on the following address:
STATUS d.o.o. Metlika
Ulica Belokranjskega odreda 19, 8330 Metlika
Service phone: + 386 (0)7/36 91 228
e-mail: [email protected]
More information available also on www.status.si.
The appliance complies with all European directives:
a.) Rules on Electrical Equipment Designed for Use wi-
thin Certain Voltage Limits
(Ofcial Journal of RS, Nos. 27/2004, 17/2011,
71/2011)
LVD Directive 2014/35, 2006/95/EC
b.) Rules on Electromagnetic Compatibility
(Ofcial Journal of RS, Nos. 84/2001, 32/2002,
132/2006)
EMC Directive 2014/30, 2004/108/EC
EC declaration of conformity guarantees that the ap-
pliance is safe and has been inspected and tested to
meet all the requirements specied in the applicable
standards, directives and regulations.
EC Declaration of conformity for CE marking is loca¬ted
at the seller and can be provided per customer’s
request.
4. DECLARATION OF CONFORMITY
This warranty is valid for two years from the date of
purchase. Evidence of original purchase is required
for warranty services, so it is important to keep your
sales receipt.
This warranty only covers breakdown caused by electri-
cal or mechanical failure. It does not cover damage ca-
used by liquid entering the machine or breakdown cau-
sed by failure to follow the manufacturers instructions.
3. WARRANTY

EN
7
5. TROUBLESHOOTING
Problem: What to do:
Pump does not react when
pushing the Start/Stop
Button.
• Check the power cord for any damage – cracks or splitting.
• Make sure the machine is plugged in.
• Your machine may switch off automatically due to improper use. Wait app.
one minute.
Pump does not vacuum the
containers or vacuum does
not hold.
• Check if cover of vacuum container and silicone gaskets are clean and correc-
tly adjusted on the container.
• Check if the valve on the container cover is clean and dry, If not, detach it
from the cover and clean it.
Machine won’t work at all &
I’ve tried all of the above.
It is obligatory to contact the service.
The manufacturer can not accept responsibility for any damage that may occur as
a result of improper use or appliances where home repairs have been undertaken.
Vacuum appliance, containers and universal lids are
indispensable in every kitchen. They are intended for
natural storing of food and extending shelf life of raw
and boiled food without losing its quality. Storing in the
refrigerator, pantry or packaging that extends food fre-
shness does not prevent the oxygen coming in contact
with food.
We also have to mention that Status' electrical vacuum
pump helps you save money, since you can buy in bulk,
repackage your purchase in portions and then vacuum
package. Food can be divided into smaller serving por-
tions, vacuum packaged and stored in the refrigerator
for a longer period of time.
Oxygen provokes a chemical change on food and is an
important factor in the formation of moulds and bac-
teria. As a consequence, grease can go rancid, food
colour changes, moulds and bacteria multiply, and
avour, vitamins, aroma and minerals are lost. Vacuum
packaging holds up such undesired effects, prolongs
shelf life and preserves food quality. Only with the help
of vacuum packaging, i.e. removing air from packaging
using vacuum pump, a suitable environment required
to extend food freshness can be established. The pro-
cess of vacuum packaging in containers or bags crea-
tes negative pressure.
6. BENEFITS OF VACUUM PACKING

EN
8
When the equipment or parts of the device are no
longer t for use they must be disposed of at the in-
dustrial waste landll in accordance with applicable
regulations:
• Decree on the Management of Waste Electrical
and Electronic Equipment (WEEE) (Ofcial Journal
of RS, no. 107/2006)
Directive 2012/19/EU on Waste Electrical and
Elec¬tronic Equipment (WEEE)
• Rules on the Restriction of the Use of Certain Ha-
zardous Substances in Electrical and Electron¬ic
Equipment (RoHS) (Ofcal Journal of RS, no.
102/2012)
• Rules amending the Rules on the Restriction of the
Use of Certain Hazardous Substances in Electrical
and Electronic Equipment (Ofcial Journal of RS,
no. 20/2014)
Directive 2011/65/EU on the Restriction of the
Use of Certain Hazardous Substances in Electrical
and Electronic Equipment
Environmentally hazardous components and parts
that were built into the device have to be disposed of
at specialized sites.
7. CORRECT DISPOSAL OF YOUR ELECTRICAL
VACUUM PUMP
The symbol on the product or its
packaging indicates that at the
end of its life, the product may
not be treated as other household
waste.
It is your responsibility to dispo-
se the waste appliance in spe-
cial areas intended for separate
collection of waste in your local
community or to deliver it to the provider of WEEE col-
lection services.
Separate collection of individual components of EE
equipment prevents negative effects of environmental
pollution and minimizes danger to human health, whi-
ch may occur as a result of improper product disposal.
In addition, it enables reuse and recovery of the mate-
rial, thus saving energy and raw materials.
For detailed information on collecting, sorting, reuse
and recycling of the product contact the provider of
WEEE collection services or the shop where you bou-
ght the equipment.
Date of manufacture of vacuum pump appliance can
be found on the warranty sheet which you received at
purchase.
8. ELECTRICAL VACUUM PUMP SET
The set includes:
a) 1 Electrical vacuum pump,
b) 1 Adapter
c) Stand with 4 rubber taps,
d) Wall inserted piece,
e) Screws,
f) User Manual.




Status d.o.o. Metlika
Ulica Belokranjskega odreda 19
8330 Metlika, Slovenia
Table of contents
Other Status Water Pump manuals
Popular Water Pump manuals by other brands

Makita
Makita DVP181 instruction manual

U.S. Products
U.S. Products FLOOD KING 120 Information & operating instructions

Goulds Pumps
Goulds Pumps IC i-FRAME on, and Maintenance Manual

DAB
DAB VA 55/130 Installation & maintenance instructions

Tuson
Tuson RIN72539 user guide

Atlas Copco
Atlas Copco AWC160 instruction manual

Barnes
Barnes BP25 Series Installation and operation manual

Pfeiffer Vacuum
Pfeiffer Vacuum OKTA 6000 operating instructions

KSB
KSB Amarex KRT Installation & operating manual

Pratissoli
Pratissoli SH Series instruction manual

Becker
Becker DT 4.16 operating instructions

Johnson Pump
Johnson Pump AQUA JET WD 3.4 instruction manual